Recycling of Spent Abrasive Media in Nonstructural Concrete
Publication: Journal of Environmental Engineering
Volume 122, Issue 9
Abstract
Spent abrasive media from bridge repainting operations contain metals which may result in the media being classified as hazardous under the Environmental Protection Agency (EPA) Toxicity Characteristic (TC) criteria. The management of spent abrasive media by recycling it as a component of nonstructural concrete was investigated. Success was measured with respect to the TC criteria for leaching and a compressive strength requirement of 6.9 MPa (1,000 psi). Portland cement, with and without the additives used, successfully immobilized the metals present in the media. However, not all of the mixes prepared set, indicating that there is a limit to the amount of media that can be recycled in a concrete product. Mixes incorporating 100% unseparated spent abrasive sand and dust or slag in place of clean sand successfully met the project criteria. Mixes containing up to 25% addition of separated spent abrasive dust met the project criteria with the inclusion of appropriate mix additives. Based on results from this and earlier studies, the Texas Department of Transportation has begun to recycle spent abrasive media using portland cement.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Brabrand, D. (1992). “Solidification/stabilization of spent blasting abrasives with Portland cement for non-structural concrete purposes,” MS thesis, Univ. of Texas at Austin, Austin, Tex.
2.
Brabrand, D. J., and Loehr, R. C.(1993). “Solidification/stabilization of spent abrasives and use as nonstructural concrete.”Waste Mgmt., 13, 333–339.
3.
Chin, D. (1987). “A calcium nitrite-based, non-corrosive, non-chloride accelerator.”Corrosion, Concrete, and Chlorides; Steel Corrosion in Concrete: Causes and Restraints, ACI SP-102, Am. Concrete Inst., Detroit, Mich.
4.
Conner, J. R. (1990). Chemical fixation and solidification of hazardous wastes. Van Nostrand Reinhold, New York, N.Y.
5.
Federal Register. (1992). “Guidelines establishing test procedures for the analysis of pollutants; microwave digestion: final rule.” 57(177), 41830–41834.
6.
Jackman, A. P., and Powell, R. L. (1991). Hazardous waste treatment technologies, Noyes Publications, Park Ridge, N.J.
7.
Khosla, P. N., and Leming, M. L. (1988). “Recycling of lead-contaminated blasting sand in construction materials.”Steel Struct. Painting Council Lead Paint Removal—Proc., SSPC Symp., Steel Struct. Painting Council, Pittsburgh, Pa.
8.
Kosmatka, S. H., and Panarese, W. (1990). Design and control of concrete mixtures, 13th Ed., Portland Cement Assoc., Skokie, Ill.
9.
Ovenden, T.(1990). “The land disposal restrictions program and the paint and coatings industry.”J. Protective Coatings and Linings, 7(8), 35–58.
10.
Rafferty, J., Norling, R., Tamaru, R., McMath, C., and Morganstein, D. (1985). StatWorks: statistics with graphics for the Macintosh, Version 1.2. Cricket Graph Software, Philadelphia, Pa.
11.
Salt, B. K. (1993). “Recycling contaminated spent blasting abrasives in Portland cement mortars using solidification/stabilization technology,” MS thesis, University of Texas at Austin, Austin, Tex.
12.
“Standard method of load verification of test machines.” (1994). E 4-94, ASTM, Philadelphia, Pa.
13.
“Standard test method for compressive strength of cylindrical specimens.” (1994). C 39-94, ASTM, Philadelphia, Pa.
14.
U.S. Environmental Protection Agency. (1990). “Code of Federal regulations.”40 CFR Part 261-267, Washington, D.C.
15.
U.S. Environmental Protection Agency. (1987). “Test methods for evaluating solid waste.”SW-846, Revision 1, Ofc. of Solid Waste and Emergency Response, Washington, D.C.
Information & Authors
Information
Published In
Copyright
Copyright © 1996 American Society of Civil Engineers.
History
Published online: Sep 1, 1996
Published in print: Sep 1996
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.