Fuzzy Logic Process Control of HPO-AS Process
Publication: Journal of Environmental Engineering
Volume 122, Issue 6
Abstract
The high purity oxygen activated sludge process requires more advanced controls as compared to the conventional activated sludge process. Feedback controllers have difficulty controlling process disturbances due to process delays and noisy signals, and cannot adjust to extreme upsets, such as stormwater flows. Four fuzzy logic control systems were developed for average conditions, and are superior to conventional feedback control systems in conserving energy, reducing dissolved oxygen (DO) variations, and stabilizing feed and exit gas flow rates. A direct control strategy, using feedforward aerator speed control and feedback stage 4 DO control, is the best among the four systems. For plants without variable speed aerators, feedforward control based on influent flow rate to adjust the stage 1 pressure setpoint, with feedback stage 4 DO control, is best. To address stormwater flows an adaptive fuzzy logic control system was developed. The control system can immediately shift to a new state to adapt to large changes in influent flow rate. The system prevents DO depletion under wet weather conditions, and conserves oxygen and energy during dry weather conditions.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Bare, W. H., Mulholland, R. J., and Sofer, S. S.(1988). “Design of a self-tuning expert controller for a gasoline refinery catalytic reformer.”Proc., Am. Control Conf., 1, 247–253.
2.
Batur, C., and Kasparian, V.(1989). “A real-time fuzzy self-tuning control.”Proc., IEEE Int. Conf. on Sys. Engrg., 3, 1810–1815.
3.
Blackwell, L. G. (1971). “A theoretical and experimental evaluation of transient response of the activated sludge process,” PhD dissertation, Clemson Univ., Clemson, S.C.
4.
Busby, J. B., and Andrews, J. F.(1975). “Dynamic modeling and control strategies for the activated sludge process.”J. Water Pollution Control Federation, 47, 1055–1080.
5.
Chen, Y. U., Cao, Z., and Kandel, A.(1990). “Application of fuzzy reasoning to the control of an activated sludge plant.”Fuzzy Sets and Sys., 38(1), 1–14.
6.
Clifft, R. C. (1980). “A dynamic model for predicting oxygen utilization in the activated sludge process.” PhD dissertation, Univ. of Houston, Houston, Tex.
7.
Clifft, R. C., and Andrews, J. F.(1986). “Gas-liquid interactions in oxygen activated sludge.”J. Envir. Engrg. Div., ASCE, 112(1), 61–77.
8.
Clifft, R. C.(1991). “Gas phase control for oxygen activated sludge.”J. Envir. Engrg. Div., ASCE, 118(3), 390–401.
9.
Driankov, D., Hellendoorn, H., and Reinfrank, M. (1993). An introduction to fuzzy control. Springer-Verlag, Berlin, Germany.
10.
Lee, C. C.(1990). “Fuzzy logic in control systems: fuzzy logic controller—part 1.”IEEE Trans. on Sys., Man, and Cybernetic, 17(2), 404–418.
11.
Lee, C. C.(1990). “Fuzzy logic in control systems: fuzzy logic controller—part 2.”IEEE Trans. on Sys., Man, and Cybernetic, 17(2), 419–435.
12.
McWhirter, J. R., and Vahldieck, N. P. (1978). Oxygenation systems mass transfer design considerations. in the use of high-purity oxygen in the activated sludge process . J. R. McWhirter, ed., CRC Press, Inc., West Palm Beach, Fla., 1, 235–260.
13.
Norman, T., Borchart, R. J., Garrett, M. T., Ahmad, Z., and Hayre, G. (1985). “Startup and interim operation of Houston's 69th street wastewater treatment complex.”Conf. Proc., Instrumentation and Control of Water and Wastewater Treatment and Transport Sys., Int. Assoc. on Water Pollution Res. and Control, Houston, Tex., 359–365.
14.
Olsson, G., and Andrews, J. F.(1978). “The dissolved oxygen profile—a valuable tool for control of activated sludge process.”Water Res., 12, 985–1004.
15.
Olsson, G., and Andrews, J. F.(1981). “Dissolved oxygen control in the activated sludge process.”Water Sci. Technol., 13(10), 341–347.
16.
Samstag, R. (1989). “West Point treatment plant secondary treatment facilities—high purity oxygen design test facility draft report.” Metropolis of Seattle, Wash.
17.
Stenstrom, M. K., Kido, W. H., Shanks, R. F., and Mulkerin, M. (1989). “Estimating oxygen transfer capacity of a full scale pure oxygen activated sludge plant.”J. Water Pollution Control Federation, 61, 208–220.
18.
Stenstrom, M. K. (1976). “A dynamic model and computer compatible control strategies for the activated sludge process,” PhD dissertation, Clemson Univ., Clemson, S.C.
19.
Stenstrom, M. K. (1990). “Westpoint treatment plant oxygen process modeling.”Engrg. Rep. No. UCLA ENG 90–17, Univ. of California, Los Angeles, Calif.
20.
Terano, T., Asai, K., and Sugeno, M. (1992). Fuzzy systems theory and its applications . Academic Press, Inc., Boston, Mass.
21.
Tong, R. M., Beck, M. B., and Latten, A.(1980). “Fuzzy control of the activated sludge wastewater treatment process.”Automatica, 16(6), 659–701.
22.
Tzeng, C-J. (1992). “Advanced dynamic modeling of the high purity oxygen activated sludge process,” PhD dissertation, Univ. of California, Los Angeles, Calif.
23.
Yamakawa, T.(1992). “A fuzzy logic controller,”J. Biotechnol., 24(1), 1–32.
24.
Yuan, W. (1994). “Dynamic modeling and expert systems for the activated sludge process,” PhD dissertation, Univ. of California, Los Angeles, Calif.
25.
Zadeh, L.(1965). “Fuzzy sets.”Information Control, 8, 338–353.
Information & Authors
Information
Published In
Copyright
Copyright © 1996 American Society of Civil Engineers.
History
Published online: Jun 1, 1996
Published in print: Jun 1996
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.