Modeling the Effects of Speed Limit, Acceleration, and Deceleration on Overall Delay and Traffic Emission at a Signalized Intersection
Publication: Journal of Transportation Engineering, Part A: Systems
Volume 143, Issue 12
Abstract
This paper proposes a microscopic spatial-temporal method to capture the vehicle movement trajectories at an isolated intersection. A bi-objective programming model is presented to minimize the overall delay and emission increment with and without traffic signal by jointly determining the optimal signal timing and speed limit. The proposed method explicitly incorporates the effects of vehicle speed limit, acceleration, deceleration, and signal timing on the overall delay (including the delays caused by traffic signal, acceleration, and deceleration) and emission increment with and without traffic signal control at the intersection.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The work described in this paper was supported by the National Natural Science Foundation of China (71471068), the Major Program of National Social Science Foundation of China (13&ZD175), and Huazhong University of Science and Technology (5001300001).
References
Andre, M., and Hammarström, U. (2000). “Driving speeds in Europe for pollutant emissions estimation.” Transp. Res. Part D, 5(5), 321–335.
Andre, M., and Pronello, C. (1997). “Relative influence of acceleration and speed on emission under actual driving conditions.” Int. J. Veh. Des., 18(3–4), 340–353.
Bokare, P. S. (2013). “Study of effect of speed, acceleration and deceleration of small petrol car on its tail pipe emission.” Int. J. Traffic Transp. Eng., 3(4), 465–478.
Chang, T. H., and Lin, J. T. (2000). “Optimal signal timing for an oversaturated intersection.” Transp. Res. Part B, 34(6), 471–491.
Cheng, Y., Qin, X., Jin, J., and Ran, B. (2010). “An exploratory shockwave approach for signalized intersection performance measurements using probe trajectories.” Proc., 89th Annual Meeting of Transportation Research Board (CD-ROM), Washington, DC.
Coelho, M. C., Farias, T. L., and Rouphail, N. M. (2005). “Impact of speed control traffic signals on pollutant emissions.” Transp. Res. Part D, 10(4), 323–340.
Dai, S., Bi, X., Chan, L. Y., He, J., Wang, B., and Wang, X. (2015). “Chemical and stable carbon isotopic composition of pm2.5 from on-road vehicle emissions in the PRD region and implications for vehicle emission control policy.” Atmos. Chem. Phys., 15(6), 3097–3108.
Dion, F., Rakha, H., and Kang, Y. S. (2004). “Comparison of delay estimates at under-saturated and over-saturated pre-timed signalized intersections.” Transp. Res. Part B, 38(2), 99–122.
Ge, X., Li, Z. C., Lam, W. H. K., and Choi, K. (2014). “Energy sustainable traffic signal timings for a congested road network with heterogeneous users.” IEEE Trans. Intell. Transp. Syst., 15(3), 1016–1025.
Guensler, R. (1993). “Vehicle emission rates and average vehicle operating speeds.” Ph.D. dissertation, Univ. of California, Davis, CA.
Guo, R., and Zhang, Y. (2014). “Exploration of correlation between environmental factors and mobility at signalized intersections.” Transp. Res. Part D, 32, 24–34.
Guo, X., and Yang, H. (2009). “User heterogeneity and bi-criteria system optimum.” Transp. Res. Part B, 43(4), 379–390.
Han, K., Liu, H., Gayah, V., Friesz, T., and Yao, T. (2016). “A robust optimization approach for dynamic traffic signal control with emission considerations.” Transp. Res. Part C, 70, 3–26.
Hao, P., Ban, X., and Whon Yu, J. (2015). “Kinematic equation-based vehicle queue location estimation method for signalized intersections using mobile sensor data.” J. Intell. Transp. Syst., 19(3), 256–272.
Hassel, D., and Weber, F. J. (1993). “Mean emissions and fuel consumption of vehicles in use with different emission reduction concepts.” Sci. Total Environ., 134(1–3), 189–195.
Izadpanah, P., Hellinga, B., and Fu, L. (2009). “Automatic traffic shockwave identification using vehicles’ trajectories.” Proc., 88th Annual Meeting of the Transportation Research Board (CD-ROM), Washington, DC.
Jensen, S. S. (1995). “Driving patterns and emissions from different types of roads.” Sci. Total Environ., 169(1–3), 123–128.
Liao, T. Y. (2013). “A fuel-based signal optimization model.” Transp. Res. Part D, 23, 1–8.
Liao, T. Y., and Machemehl, R. B. (1997). “Development of an aggregate fuel consumption model for signalized intersections.” Transp. Res. Rec., 1641, 9–18.
Li, X., Li, G., Pang, S. S., Yang, X., and Tian, J. (2004). “Signal timing of intersections using integrated optimization of traffic quality, emissions and fuel consumption: A note.” Transp. Res. Part D, 9(5), 401–407.
Li, Z. C., and Ge, X. (2014). “Traffic signal timing problems with environmental and equity considerations.” J. Adv. Transp., 48(8), 1066–1086.
Miettinen, K. (2012). Nonlinear multiobjective optimization, Vol. 12, Kluwer Academic Publishers, Dordrecht, Netherlands.
Miller, A. J. (1963). “Settings for fixed-cycle traffic signals.” J. Oper. Res. Soc., 14(4), 373–386.
Ministry Environmental Protection of People’s Republic of China. (2014). “Environment statistics annual report 2013.” China Environmental Science Press, Beijing.
Mousa, R. M. (2002). “Analysis and modeling of measured delays at isolated signalized intersections.” J. Transp. Eng., 347–354.
Nie, Y. M., and Li, Q. (2013). “An eco-routing model considering microscopic vehicle operating conditions.” Transp. Res. Part B, 55, 154–170.
Olszewski, P. (1993). “Overall delay, stopped delay, and stops at signalized intersections.” J. Transp. Eng., 835–852.
Pandian, S., Gokhale, S., and Ghoshal, A. K. (2009). “Evaluating effects of traffic and vehicle characteristics on vehicular emissions near traffic intersections.” Transp. Res. Part D, 14(3), 180–196.
Quiroga, C. A., and Bullock, D. (1999). “Measuring control delay at signalized intersections.” J. Transp. Eng., 271–280.
Rakha, H., Aerde, M. V., Ahn, K., and Trani, A. (2000). “Requirements for evaluating traffic signal control impacts on energy and emission based on instantaneous speed and acceleration measurements.” Transp. Res. Rec., 1738, 56–67.
Rakha, H., and Ding, Y. (2003). “Impact of stops on vehicle fuel consumption and emissions.” J. Transp. Eng., 23–32.
Rorbech, J. (1968). “Determining the length of the approach lanes required at signal-controlled intersections on through highways.” Transp. Res., 2(3), 283–291.
Stephanopoulos, G., and Michalopoulos, P. G. (1979). “Modelling and analysis of traffic queue dynamics at signalized intersections.” Transp. Res. Part A, 13(5), 295–307.
Sturm, P. J., and Sudy, C. (1996). “Instantaneous emission maps and available data sets and use of data.” Proc., COST 319 Workshop on Estimation of Pollutant Emission from Transport, European Commission, Brussels, Belgium.
Sun, Z., Hao, P., Ban, X. J., and Yang, D. (2015). “Trajectory-based vehicle energy/emissions estimation for signalized arterials using mobile sensing data.” Transp. Res. Part D, 34, 27–40.
Tan, Z., Yang, H., and Guo, X. (2010). “Properties of Pareto-efficient contracts and regulations for road franchising.” Transp. Res. Part B, 44(4), 415–433.
TRB (Transportation Research Board). (1985). “Highway capacity manual.”, Washington, DC.
U.S. Department of Energy. (2012). “Transportation energy data book: Edition 31.”, Oak Ridge National Laboratory, Oak Ridge, TN.
Wang, X., Ye, H., and Yang, H. (2015). “Decentralizing Pareto-efficient network flow/speed patterns with hybrid schemes of speed limit and road pricing.” Transp. Res. Part E, 83, 51–64.
Webster, F. V. (1958). “Traffic signal settings.”, Her Majesty’s Stationary Office, London.
Webster, F. V., and Cobbe, B. M. (1966). “Traffic signals.”, HMSQ, London, 111.
Yu, L. (2013). “Characterization and source apportionment of pm2.5 in an urban environment in Beijing.” Aerosol Air Quality Res., 13(2), 574–583.
Zhang, L., Yin, Y., and Chen, S. (2013). “A robust signal timing optimization with environmental concerns.” Transp. Res. Part C, 29(1), 55–71.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Jan 7, 2017
Accepted: Jun 27, 2017
Published online: Oct 12, 2017
Published in print: Dec 1, 2017
Discussion open until: Mar 12, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.