Abstract
Providing drivers with open sight distance on entrance ramps can help prevent wrong-way entries at interchange terminals. For partial-cloverleaf (parclo) interchange terminals with close-spaced two-way ramps, appropriate intersection balance and median barrier lengths can provide motorists with a better view of entrance ramps and a better turning radius. A current best intersection balance practice by Washington State Department of Transportation (WSDOT) is to locate the stop line at no more than 60% of the way through the intersection. However, this has not been proven for safety benefits. To fill this void, this paper provides a comprehensive evaluation of the impact of stop line positioning based on wrong-way crash data analysis. Effects of different lengths of the median barriers used to separate two-way ramps on left-turn driver sight distances were also investigated by analyzing driver perspectives of roadway information with a three-dimensional (3D) simulation and analytical methodology. Conclusively, the current best practice was proven effective in deterring wrong-way driving, and general guidelines for appropriate median barrier lengths on two-way ramps were developed.
Get full access to this article
View all available purchase options and get full access to this article.
References
AASHTO. (1977). “Guide for selecting, locating, and designing traffic barriers.” Washington, DC.
AASHTO. (2011). “A policy on geometric design of highways and streets.” Washington, DC.
Easa, S., Dabbour, E., and Ali, M. (2004). “Three-dimensional model for stop-control intersection sight distance.” J. Transp. Eng., 261–270.
Easa, S., and He, W. (2006). “Modeling driver visual demand on three-dimensional highway alignments.” J. Transp. Eng., 357–365.
FHWA (Federal Highway Administration). (2009). “Manual on uniform traffic control devices (MUTCD).” Washington, DC.
FHWA (Federal Highway Administration). (2014). “Median barriers: A solution to cross-median crashes.”, Washington, DC.
FHWA (Federal Highway Administration). (2015). “Safety.” Washington, DC.
Glennon, J. C. (2002). “A new concept for determining guardrail length of need.” ⟨www.crashforensics.com/papers.cfm?PaperID=5⟩ (Jul. 9, 2015).
Glover, D. M., Jenkins, W. J., and Doney, S. C. (2008). “Least squares and regression techniques, goodness of fit and tests, non-linear least squares techniques.” Woods Hole Oceanographic Institute, Woods Hole, MA.
Google Earth version 7.1.2.2041 [Computer software]. Google, Inc., Mountain View, CA.
Hassan, Y., Easa, S. A., and El, H. A. (1996). “Analytical model for sight distance analysis on three-dimensional highway alignments.” J. Transp. Res. Board, 1523(1), 1–10.
Hazewinkel, M. (2001). “Kolmogorov–Smirnov test.” Encyclopedia of mathematics, Springer, New York.
Jha, M. K., Karri, G. A., and Kühn, K. W. (2011). “New three-dimensional highway design methodology for sight distance measurement.” J. Transp. Res. Board, 2262, 74–82.
Kirkman, T. W. (1996). “Statistics to use: Kolmogorov-Smirnov test.” ⟨http://www.physics.csbsju.edu/stats/⟩ (Jul. 9, 2015).
Laub, C., and Kuhl, T. L. (2015). How bad is good? A critical look at the fitting of reflectivity models using the reduced chi-square statistic, Univ. of California, Davis, CA.
Manoj, K. J., and Gautham, A. K. (2009). “Road surface development and sight distance calculation with new visualization methods.” Proc., 2nd WSEAS Int. Conf. on Sensors, and Signals and Visualization, Imaging and Simulation and Materials Science, World Scientific and Engineering Academy and Society (WSEAS), Stevens Point, WI.
Morena, D. A., and Leix, T. J. (2012). “Where these drivers went wrong.” Public Roads, 75(6), 33–41.
Sarhan, M., and Hassan, Y. (2008). “Three-dimensional, probabilistic highway design: sight distance application.” Transportation Research Board of the National Academies, Washington, DC, 10–18.
Tsai, Y., Hu, Z., and Wang, Z. (2009). “Vision-based roadway geometry computation.” J. Transp. Eng., 223–233.
WSDOT (Washington State Department of Transportation). (2013). “Design manual.”, Olympia, WA.
Yan, X., and Radwan, E. (2008). “Influence of restricted sight distances on permitted left-turn operation at signalized intersections.” J. Transp. Eng., 68–76.
Zhou, H., et al., (2012). “Investigation of contributing factors regarding wrong-way driving on freeways.”, Illinois Center for Transportation, Rantoul, IL.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Feb 1, 2016
Accepted: Nov 1, 2016
Published online: Feb 22, 2017
Published in print: Jun 1, 2017
Discussion open until: Jul 22, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.