Influence of Cyclic Amplitude of Deviatoric Stress on Deformation Behavior of Saturated Sand under Different Stress Paths

Under various stress paths, the deformation characteristics represented great differences. In this paper, a series of cyclic triaxial tests have been conducted with Fujian standard sand. By comparing the constant deviatoric (CDS) and constant axial stress paths (CAS), the influence mechanism of the cyclic amplitude of the deviatoric stress was discussed. The test results showed that the stress path significantly influenced the volumetric and shear strains. The increasing and decreasing trend in the volumetric strain (ɛ_v) was consistent with the spherical stress (lnp). Compared with the two stress paths, the slope of the ɛ_v−lnp curve during the loading and unloading stages was larger under the CAS path. In the CDS path, q_c almost did not affect the cumulative volumetric strain, and in the CAS path, the effect was obvious. The shear strain curve was in accordance with the direction of the stress path. As the cyclic number increased, the shear strain gradually accumulated. The shear strain accumulation under the CAS path was larger. The shear strain largely depended on the relative position between the critical state line (CSL) and the stress state of the soil during cyclic loading and unloading.

In practical engineering, the soil will experience various stress paths. For example, in slope or earth–rock dam engineering, where the water level rises and falls repeatedly, the soil often goes through the stress path of constant deviational stress with the cyclic increase and decrease in the spherical stress. In foundation pit engineering, the soil often experiences the stress path of the constant axial stress (CAS) with cyclic loading and unloading of the lateral stress. The stress path greatly influences the deformation and strength of soil. Therefore, the previous two stress paths are compared in this paper to discuss the influence of the cyclic amplitude of deviatoric stress. Under three different consolidation states, the cyclic amplitude of the deviatoric stress significantly influenced the volumetric and shear strains. The shear strain largely depended on the relative position between the critical state line (CSL) and the stress state of the soil during cyclic loading and unloading. Therefore, in practical engineering, if the stress path in the experiment differs from the actual value, the influence of the stress path should be properly considered. The results should be modified according to the degree of influence of each stress condition.