Effect of Uniaxial Strength and Fracture Parameters of Concrete on Its Biaxial Compressive Strength
This article has a reply.
VIEW THE REPLYThis article has a reply.
VIEW THE REPLYPublication: Journal of Materials in Civil Engineering
Volume 26, Issue 6
Abstract
The biaxial compressive behavior of concrete has been widely studied in the literature, and the biaxial envelope has always been reported for a particular uniaxial compressive strength. However, there is no theoretical or experimental evidence that concrete with similar strength exhibits similar biaxial behavior. In this study, several kinds of concrete with different maximum aggregate sizes were tested for their biaxial compressive strength under several load ratios. To ensure a uniform stress state in the cubic specimens, four layers of plastic membrane separated by three layers of butter were inserted between the steel loading platens and concrete surfaces to reduce the end friction during the test. In addition to biaxial strength, the uniaxial compressive strength, fracture energy, and characteristic length of each concrete mix were also determined. It was found that the biaxial compressive strength of concrete was dependent on both the uniaxial strength and the fracture energy (or characteristic length). Biaxial tests on concrete should therefore be conducted together with fracture tests to enable the proper comparison of biaxial behavior among different kinds of concrete. While further testing is required, this finding casts new light on concrete behavior under biaxial loading.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors gratefully acknowledge the financial support of the China Ministry of Science and Technology under Grant 2009CB623200.
References
Ashby, M. F., and Hallam, S. D. (1986). “The failure of brittle solids containing small cracks under compressive stress states.” Acta. Metall., 34(3), 497–510.
ASTM. (2002). “Standard test method for static modulus of elasticity and Poisson’s ratio of concrete in compression.” C469-02, West Conshohocken, PA.
ASTM. (2004). “Standard test method for splitting tensile strength of cylinder concrete specimens.” C496/C496M-04, West Conshohocken, PA.
Hampel, T., Speck, K., Scheerer, S., Ritter, R., and Curbach, M. (2009). “High-performance concrete under biaxial and triaxial loads.” J. Eng. Mech., 1274–1280.
Hilsdorf, H. (1965). “Die Bestimmung der zweiachsigen Festigkeit von Betons [The experimental determination of the biaxial strength of concrete].” Deutscher Ausschuss fur Stahlbeton, Heft 173, Wilhelm Ernst und Sohn, Berlin.
Horii, H., and Nemat-Nasser, S. (1986). “Brittle failure in compression: Splitting, faulting and brittle-ductile transition.” Philos. Trans. R. Soc. London, Ser. A, 319(1549), 337–374.
Hussein, A., and Marzouk, H. (2000). “Behavior of high-strength concrete under biaxial stresses.” ACI Mater. J., 97(1), 27–36.
Kleinschrodt, H. D., and Winkler, H. (1986). “The influence of the maximum aggregate size and the size of specimen on fracture mechanics parameters.” Fracture toughness and fracture energy of concrete, F. H. Wittmann, ed., Elsevier, Amsterdam, 391–402.
Kupfer, H., Hilsdorf, H. K., and Rusch, H. (1969). “Behavior of concrete under biaxial stresses.” ACI J. Proc., 66(8), 656–666.
Lim, D. H., and Nawy, E. G. (2005). “Behavior of plain and steel-fiber-reinforced high-strength concrete under uniaxial and biaxial compression.” Mag. Concr. Res., 57(10), 603–610.
Mehammed, S. M., Salim, Z., and Said, B. (2010). “Effect of content and particle size distribution of coarse aggregate on the compressive strength of concrete.” Constr. Build. Mater., 24(4), 505–512.
Rao, G. A., and Prasad, B. K. R. (2002). “Fracture energy and softening behavior of high-strength concrete.” Cem. Concr. Res., 32(2), 247–252.
RILEM-50-FMC. (1985). “Determination of the fracture energy of mortar and concrete by means of three-point bend test on notched beams.” Mater. Struct., 18(4), 287–290.
Shah, S. P., Swartz, A. E., and Ouyang, C. S. (1995). Fracture mechanics of concrete: Application of fracture mechanics to concrete, rock and other quasi-brittle materials, Wiley, New York.
Wang, H. L., and Song, Y. P. (2009). “Biaxial compression behavior of different aggregates graded concrete.” Mag. Concr. Res., 61(6), 457–463.
Wu, K., Chen, B., and Yao, W. (2001). “Study of the influence of aggregate size distribution on mechanical properties of concrete by acoustic emission technique.” Cem. Concr. Res., 31(6), 919–923.
Yin, W., Su, E., Mansour, M., and Hsu, T. (1989). “Biaxial tests of plain and fiber concrete.” ACI Mater. J., 86(3), 236–243.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Jan 9, 2012
Accepted: Aug 12, 2013
Published online: Feb 28, 2014
Published in print: Jun 1, 2014
Discussion open until: Jul 28, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.