Calibration of the 10HS Soil Moisture Sensor for Southwest Florida Agricultural Soils
This article has a reply.
VIEW THE REPLYPublication: Journal of Irrigation and Drainage Engineering
Volume 139, Issue 12
Abstract
Precision irrigation is crucial in decreasing water demands of irrigated agriculture, which account for the largest source of water withdrawal in most regions. One necessity of precision irrigation is the knowledge of soil moisture content in the root zone of irrigated crops. Dielectric soil moisture sensors can provide this information at a relatively low cost ($100) compared with other techniques; however, their accuracy cannot be guaranteed in all soils without site-specific calibration, the need for which has limited the use of these sensors. This study examined the Decagon 10HS soil moisture sensor in order to determine the accuracy of the manufacturer-supplied calibration equation on southwest Florida (SWFL) agricultural soils, and analyze whether it performs consistently in different soils found in SWFL. Laboratory calibration of the 10HS was done on four SWFL soils that represent the majority of agricultural land in the region and regression calibration equations were obtained. It was found that the manufacturer calibration equation does not accurately predict soil volumetric water content (VWC) within the accuracy range specified for the sensor, meriting the need for site-specific calibration. Additionally, it was found that all tested soils behave very similarly, allowing the development of a single calibration equation for use of the 10HS in all SWFL agricultural applications. The calibration equation developed during this research for SWFL could allow a more widespread use of the 10HS in the region.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors would like to thank Dr. Douglas Cobos, Research Scientist and Director of research and development at Decagon Devices, for his valuable information regarding the 10HS sensor. Additional thanks go to Dr. Ed Hanlon, Professor of Soil Fertility and Management at UF, for his assistance in soil sample collection and insight into SWFL agricultural soils as well as farming practices.
References
Cobos, D. (2008). “10HS volume of sensitivity.” Application Note 13900-01, Decagon Devices, Pullman, WA.
Cobos, D. (2010). “Virtual seminar: Why does my soil moisture sensor read negative?” Decagon Devices, Pullman, WA.
Cobos, D., and Chambers, C. (2010). “Calibrating soil moisture sensors.” Application Note 13393-04, Decagon Devices, Pullman, WA.
Decagon Devices. (2008). 10HS soil moisture sensor operator’s manual version 3, Pullman, WA.
Inoue, M., Ould Ahmed, B., Saito, T., Irshad, M., and Uzoma, K. (2008). “Comparison of three dielectric moisture sensors for measurement of water in saline sandy soil.” Soil Use Manag., 24(2), 156–162.
Kinzli, K., Manana, N., and Oad, R. (2012). “A comparison of laboratory and field calibration of a soil moisture capacitance probe for various soils.” J. Irrig. Drain. Eng., 138(4), 310–321.
Kizito, F., et al. (2008). “Frequency, electrical conductivity and temperature analysis of a low-cost capacitance soil moisture sensor.” J. Hydrol., 352(3–4), 367–378.
Mittelbach, H., Lehner, I., and Seneviratne, S. (2012). “Comparison of four soil moisture sensor types under field conditions in Switzerland.” J. Hydrol., 430–431(1), 39–49.
Obreza, T., and Collins, M. (2002). “Common soils used for citrus production in Florida.” Institute of Food and Agricultural Sciences, Univ. of Florida, Gainesville, FL, SL 193.
Plauborg, F., Iversen, B., and Laerke, P. (2005). “In situ comparison of three dielectric soil moisture sensors in drip irrigated sandy soils.” Vadose Zone J., 4(4), 1037–1047.
Roka, F., and Cook, D. (1998). “Farmworkers in southwest Florida.” Southwest Florida Research and Education Center, Univ. of Florida, Immokalee, FL.
Sadler, E., Evans, R., Stone, K., and Camp, C. (2005). “Opportunities for conservation with precision irrigation.” J. Soil Water Conserv., 60(6), 371–379.
Saxton, K., and Rawls, J. (2006). “Soil water characteristics estimates by texture and organic matter for hydrologic solutions.” Soil Sci. Soc. Am. J., 70(5), 1569–1578.
Seyfried, M., and Murdock, M. (2004). “Measurement of soil water content with a 50-MHz soil dielectric sensor.” Soil Sci. Soc. Am. J., 68(2), 394–403.
Smith, R., Baillie, J., McCarthy, A., Raine, S., and Baillie, C. (2010). “Review of precision irrigation technologies and their application.” National Centre for Engineering in Agriculture, Toowoomba, Australia.
Information & Authors
Information
Published In
Journal of Irrigation and Drainage Engineering
Volume 139 • Issue 12 • December 2013
Pages: 965 - 971
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Mar 18, 2013
Accepted: Jun 17, 2013
Published online: Jun 19, 2013
Discussion open until: Nov 19, 2013
Published in print: Dec 1, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.