Discussion of “Assessment of Hydraulic Performance of Drip-Irrigation Emitters at Low Head Pressures” by Chao Zhang, Yaohu Kang, Shufang Jiang, Shuqin Wan, and Shiping Liu
This article is a reply.
VIEW THE ORIGINAL ARTICLEPublication: Journal of Irrigation and Drainage Engineering
Volume 140, Issue 3
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors are thankfully appreciated in advance for their valuable clarifications/contributions to the few points raised through the discussion.
References
Bralts, V. F., Wu, I. P., and Gitlin, H. M. (1981). “Manufacturing variation of drip irrigation uniformity.” Trans. Am. Soc. Agric. Eng., 24(1), 113–119.
Chandrakanth, M. S., Lau, L. S., and Wu, I. P. (1988). “Plugging evaluation in reuse of primary wastewater effluent for drip irrigation.” 4th Int. Micro-Irrigation Congress, Vol. 2, Albury-Wodonga, VIC, 6.
Daccache, A., Lamaddalena, N., and Fratino, U. (2010). “Assessing pressure changes in an on-demand water distribution system on drip irrigation performance—case study in Italy.” J. Irrig. Drain. Eng., 261–270.
Latif, M., and Ahmad, F. (2008). “Operational analysis of water application of a sprinkler ırrigation system ınstalled in a golf course: Case study” J. Irrig. Drain. Eng., 446–453.
Merriam, J. L., and Keller, J. (1978). Farm irrigation system evaluation: A guide for management, Utah State Univ., Logan, UT, 271.
Nakayama, F. S., and Bucks, D. A. (1981). “Emitter clogging effects on trickle irrigation uniformity.” Trans. Am. Soc. Agric. Eng., 24(1), 77–80.
Peng, G. F., Wu, I. P., and Phene, C. J. (1986). “Temperature effects on drip line hydraulics.” Trans. Am. Soc. Agric. Eng., 29(1), 211–215.
Pitts, D. J., Haman, D. Z., and Smajstrla, A. G. (1990). “Causes and prevention of emitter plugging in microirrigation systems.” Institute of Food and Agricultural Science Bulletin No. 258, Univ. of Florida, Gainesville, FL.
Solomon, K. (1979). “Manufacturing variation of emitters in trickle irrigation systems.” Trans. Am. Soc. Agric. Eng., 22(5), 1034–1038.
Wei, Q., Shi, Y., Lu, G., Dong, W., and Huang, S. (2008). “Rapid evaluations of anti-clogging performance of drip emitters by laboratorial short-cycle tests.” J. Irrig. Drain. Eng., 298–304.
Wu, I. P. (1997). “An assessment of hydraulic design of micro-irrigation systems.” Agric. Water Manage., 32(3), 275–284.
Wu, I. P., Feng, J. S., and Yabusaki, K. (1989). “Emitter spacing and uniformity of irrigation application.” No. 89-2080, Proc., Int. Summer Meeting.
Wu, I. P., Irudayaraj, J. M., and Feng, J. S. (1988a). “Grouping effect on the uniformity of drip irrigation.” No. 10-4. Proc., 4th Int. Micro-Irrigation Congress.
Wu, I. P., Irudayaraj, J. M., and Feng, J. S. (1988b). “Plugging evaluation for a drip irrigation submain unit.” No. 88-2062, Proc., Int. Winter Meeting of ASAE.
Wu, I. P., Lin, B. Y., and Lau, L. S. (1991). “Plugging evaluation in the re-use of sewage effluent by drip irrigation.” Proc., ASCE National Conf., ASCE, Reston, VA, 780–786.
Wu, I. P., and Phene, C. J. (1984). “Temperature effect on drip emitters and lateral lines.” No. 84-2628, Proc., Winter Meeting of ASAE.
Wu, I. P., Yabusaki, K. Y., and Irudayaraj, J. M. (1985). “Computer simulation of total emitter flow variation. Drip/trickle irrigation in action.” Proc., 3rd Int. Micro-Irrigation Congress on Drip/Trickle Irrigation, 873–886.
Yıldırım, G. (2006). “Hydraulic analysis and direct design of multiple outlets pipelines laid on flat and sloping lands.” J. Irrig. Drain. Eng., 537–552.
Yıldırım, G. (2007a). “Analytical relationships for designing multiple outlets pipelines.” J. Irrig. Drain. Eng., 140–154.
Yıldırım, G. (2007b). “An assessment of hydraulic design of trickle laterals considering effect of minor losses.” Irrig. Drain., 56(4), 399–421.
Yıldırım, G. (2008). “Determining operating inlet pressure head incorporating uniformity parameters for multioutlet plastic pipelines.” J. Irrig. Drain. Eng., 341–348.
Yıldırım, G. (2009). “Simplified procedure for hydraulic design of small-diameter plastic pipes.” Irrig. Drain., 58(3), 209–233.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Jan 17, 2013
Accepted: Feb 6, 2013
Published online: Jan 20, 2014
Published in print: Mar 1, 2014
Discussion open until: Jun 20, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.