Axial Compression of Footings in Cohesionless Soils. II: Bearing Capacity
This article has a reply.
VIEW THE REPLYThis article has a reply.
VIEW THE REPLYThis article has a reply.
VIEW THE REPLYPublication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 135, Issue 11
Abstract
An extensive database of full-scale field load tests was used to examine the bearing capacity for footings in cohesionless soils. Each load test curve was evaluated consistently to determine the interpreted failure load (i.e., bearing capacity) using the method. This test value then was compared with the theoretical bearing capacity, computed primarily using the basic Vesić model. The comparisons show that, for footing widths , the field results agree very well with the Vesić predictions. However, for , the results indicated a relationship between and the predicted-to-measured bearing capacity ratio. Accordingly, a simple modification was made to the bearing capacity equation, and the resulting predictions are very good.
Get full access to this article
View all available purchase options and get full access to this article.
References
Akbas, S. O. (2007). “Deterministic and probabilistic assessment of settlements of shallow foundations in cohesionless soils.” Ph.D. thesis, Cornell Univ., Ithaca, N.Y.
Akbas, S. O. and Kulhawy, F. H. (2009). “Axial compression of footings in cohesionless soils. I: Load-settlement behavior.” J. Geotech. Geoenviron. Eng., 135(11), 1562–1574.
Canadian Geotechnical Society. (2006). Canadian foundation engineering manual, 4th Ed., BiTech, Richmond, B.C.
Davis, E. H., and Booker, J. R. (1971). “The bearing capacity of strip footings from the standpoint of plasticity theory.” Proc., First Australia–New Zealand Conf. on Geomechanics (1), Sydney Univ., Melbourne, Australia, 276–282.
DeBeer, E. E. (1965). “Bearing capacity and settlement of shallow foundation on sand.” Proc., Symp. on Bearing Capacity and Settlements of Foundations, Duke Univ., Durham, N.C., 15–33.
Hansen, J. B. (1970). “A revised and extended formula for bearing capacity.” Rep. No. 28, Danish Geotechnical Institute, Copenhagen.
Hettler, A., and Gudehus, G. (1988). “Influence of foundation width on bearing capacity factor.” Soils Found., 28(4), 81–92.
Hirany, A., and Kulhawy, F. H. (1988). “Conduct and interpretation of load tests on drilled shaft foundations: detailed guidelines.” Rep. No. EL-5915, Electric Power Research Institute, Palo Alto, Calif.
Kulhawy, F. H., and Mayne, P. W. (1990). “Manual on estimating soil properties for foundation design.” Rep. No. EL-6800, Electric Power Research Institute, Palo Alto, Calif.
Kulhawy, F. H., Trautmann, C. H., Beech, J. F., O'Rourke, T. D., McGuire, W., Wood, W. A., and Capano, C. (1983). “Transmission line structure foundations for uplift—Compression loading.” Rep. No. EL-2870, Electric Power Research Institute, Palo Alto, Calif.
Muhs, E. (1965). “Discussion.” Proc., 6th Int. Conf. on Soil Mechanics and Foundation Engineering (3), Toronto, Montreal, Quebec, University of Toronto Press, Toronto, 419–421.
Perkins, S. W., and Madson, C. R. (1996). “Mechanical and load-settlement characteristics of two lunar soil simulants.” J. Aerosp. Eng., 9(1), 1–9.
Poulos, H. G., Carter, J. P., and Small, J. C. (2001). “Foundations and retaining structures—Research and practice.” Proc., 15th Int. Conf. on Soil Mechanics and Geotechnical Engineering (4), Balkema, Istanbul, Turkey, 2527–2606.
Shiraishi, S. (1990). “Variation in bearing capacity factors of dense sand assessed by model loading tests.” Soils Found., 30(1), 17–26.
Tatsuoka, F., Okahara, M., Tanaka, T., Tani, K., Morimoto, T., and Siddiquee, M. S. A. (1991). “Progressive failure and particle size effect in bearing capacity of a footing on sand.” Proc., Geotechnical Congress 1991 (GSP27), ASCE, New York, 788–802.
Tatsuoka, F., Siddiquee, M. S. A., and Tanaka, T. (1994). “Link among design, model tests, theories and sand properties in bearing capacity of footing on sand.” Proc., 13th Int. Conf. on Soil Mechanics and Foundation Engineering (1), Balkema, Boulder, Colo., 87–88.
Trautmann, C. H., and Kulhawy, F. H. (1987). “CUFAD—A computer program for compression and uplift foundation analysis and design.” Rep. No. EL-4540-CCM (16), Electric Power Research Institute, Palo Alto, Calif.
Vesić, A. S. (1975). “Bearing capacity of shallow foundations.” Foundation engineering handbook, H. Winterkorn and H. Y. Fang, Van Nostrand Reinhold, New York.
Information & Authors
Information
Published In
Copyright
© 2009 ASCE.
History
Received: Feb 7, 2008
Accepted: Apr 28, 2009
Published online: Oct 15, 2009
Published in print: Nov 2009
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.