Bearing Capacity of Shallow Strip Foundations in Sand under Eccentric and Oblique Loads
This article has a reply.
VIEW THE REPLYThis article has a reply.
VIEW THE REPLYPublication: International Journal of Geomechanics
Volume 17, Issue 4
Abstract
An empirical nondimensional reduction factor is proposed in this paper, which can be used for determining the ultimate bearing capacity of eccentrically and/or obliquely loaded shallow strip foundations embedded in sand. This was developed after analyzing a series of laboratory model test results available in the literature on strip foundations. The depth of foundation (D), eccentricity of load (e), and inclination of load (α)varied from 0 to 1B, 0 to 0.5B, and 0 to 20°, respectively, where B refers to the width of foundation. The proposed reduction factor was found to provide reasonably well results for calculating the ultimate bearing capacity of shallow strip foundation under eccentric and/or inclined loads. The results obtained by using the proposed method have been found to be in good agreement with widely used traditional methods available in the literature.
Get full access to this article
View all available purchase options and get full access to this article.
References
Agarwal, R. K. (1986). “Behavior of shallow foundations subjected to eccentric inclined loads.” Ph.D. thesis, Univ. of Roorkee, Roorkee, India.
Aiban, S. A., and Znidarčić, D. (1995). “Centrifugal modeling of bearing capacity of shallow foundations on sands.” J. Geotech. Eng., 704–712.
Dhillon, G. S. (1961). “Settlement, tilt and bearing capacity of footings under central and eccentric loads.” J. National Build. Org., 6, 66–78.
Eastwood, W. (1955). “The bearing capacity of eccentrically loaded foundations on sandy soils.” Struct. Eng., 29, 181–187.
Hanna, A. M., and Meyerhof, G. G. (1981). “Experimental evaluation of bearing capacity of footings subjected to inclined loads.” Can. Geotech. J., 18(4), 599–603.
Hansen, J. B. (1970). “A revised and extended formula for bearing capacity.” DGI Bull., No. 28, Danish Geotechnical Institute, Copenhagen, Denmark, 5–11.
Hjiaj, M., Lyamin, A. V., and Sloan, S. W. (2004). “Bearing capacity of a cohesive-frictional soil under non-eccentric inclined loading.” Comput. Geotech., 31(6), 491–516.
Krabbenhoft, S., Damkilde, L., and Krabbenhoft, K. (2014). “Bearing capacity of strip footings in cohesionless soil subject to eccentric and inclined loads.” Int. J. Geomech., 04014003.
Long, J. H., and Wysockey, M. H. (1999). “Accuracy of methods for predicting axial capacity of deep foundations.” Proc., OTRC Conf. Analysis, Design, Construction, and Testing of Deep Foundation, Geotechnical Special Publication No. 88, ASCE, Reston, VA, 190–195.
Loukidis, D., Chakraborty, T., and Salgado, R. (2008). “Bearing capacity of strip footings on purely frictional soil under eccentric and inclined loads.” Can. Geotech. J., 45(6), 768–787.
MATLAB R2014b [Computer software]. MathWorks, Natick, MA.
Meyerhof, G. G. (1951). “The ultimate bearing capacity of foudations.” Géotechnique, 2(4), 301–332.
Meyerhof, G. G. (1953). “The bearing capacity of foundations under eccentric and inclined loads.” Proc., 3rd Int. Conf. on Soil Mechanics and Foundation Engineering (ICSMFE), Vol. I, International Society of Soil Mechanics and Geotechnical Engineering, London, 440–445.
Meyerhof, G. G. (1963). “Some recent research on the bearing capacity of foundations.” Can. Geotech. J., 1(1), 16–26.
Meyerhof, G. G., and Koumoto, T. (1987). “Inclination factors for bearing capacity of shallow footings.” J. Geotech. Eng., 1013–1018.
Michalowski, R. L., and You, L. (1998). “Effective width rule in calculations of bearing capacity of shallow footings.” Comput. Geotech., 23(4), 237–253.
Muhs, H., and Weiss, K. (1969). “The influence of load inclination on bearing capacity of shallow footings.” Proc., 7th Int. Conf. on Soil Mechanics and Foundation Engineering, Vol. 2, Mexico City, Mexico, 187−194.
Okamura, M., Mihara, A., and Takemura, J. (2002). “Effects of footing size and aspect ratio on the bearing capacity of sand subjected to eccentric loading.” Soils Found., 42(4), 43–56.
Ornek, M. (2014). “Estimation of ultimate loads of eccentric-inclined loaded strip footings rested on sandy soils.” Neural Comput. Appl., 25(1), 39–54.
Patra, C., Behara, R., Sivakugan, N., and Das, B. (2012). “Ultimate bearing capacity of shallow strip foundation under eccentrically inclined load, part I.” Int. J. Geotech. Eng., 6(3), 343–352.
Purkayastha, R. D., and Char, R. A. (1977). “Stability analysis for eccentrically loaded footings.” J. Geotech. Eng., 103(6), 647–651.
Ramelot, C., and Vandeperre, L. (1950). “Les foundations de pylons electriques: Leur resistance au reversement, leur stabilite, leur calcul etude experimentale.” Comptes Rendus de Recherces de la Recherche Scientifique dans I’Industrie et Agriculture, Issue 2, Institut Pour L’encouragement De La Recherche Scientifique Dans L’industrie Et L’agriculture, Brussels, Belgium, (in French).
Reissner, H. (1924). “Zumerddruck problem.” Proc. 1st Int. Congress of Applied Mechanics, C. B. Biezeno and J. M. Burgers, eds., J. Waltman Jr. Delft, Netherlands, 295–311 (in German).
Saran, S., and Agarwal, R. K. (1991). “Bearing capacity of eccentrically obliquely loaded footing.” J. Geotech. Eng., 1669–1690.
Saran, S., Prakash, S., and Murty, A. V. S. R. (1971). “Bearing capacity of footings under inclined loads.” Soils Found., 11(1), 47–52.
Sawwaf, E. I. M. (2009). “Experimental and numerical study of eccentrically loaded strip footing resting on reinforced sand.” J. Geotech. Geoenviron. Eng., 1509–1518.
Vesic, A. S. (1973). “Analysis of ultimate loads of shallow foundations.” J. Soil Mech. Found. Div., 99(1), 45–73.
Zaharescu, E. (1961). “The eccentricity sense influence on inclined loads on the bearing capacity of rigid foundations.” J. National Build. Org., 6, 274–282.
Information & Authors
Information
Published In
Copyright
© 2016 American Society of Civil Engineers.
History
Received: Feb 21, 2015
Accepted: Aug 1, 2016
Published online: Sep 8, 2016
Discussion open until: Feb 8, 2017
Published in print: Apr 1, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.