Nondestructive Method for Estimation of Chloride Profiles: Correlation between Electrical Resistivity and Holliday-Empirical Equation
This article has been corrected.
VIEW CORRECTIONPublication: Journal of Construction Engineering and Management
Volume 146, Issue 10
Abstract
Concrete electrical resistivity has been performed as a durability parameter because this is a nondestructive, simple, fast, and reliable technique for evaluation of reinforced concrete field structures. The results obtained have been used mainly to verify the probable reinforcement corrosion risk. However, other applications for electrical resistivity are possible, such as service life estimation of concrete structures in a marine environment. This paper presents the applicability of concrete electrical resistivity as a parameter for the determination of modified Holliday equation variables for chloride profile modeling of field reinforced concrete structures present in a marine environment. For this, chloride profiles of reinforced concrete structures present for more than in different marine aggressive zones were analyzed. The results showed that all the modified Holliday equation variables can be estimated by electrical resistivity values presenting moderate to very high statistical correlations. The chloride concentration peak was observed near the concrete surface for concretes that presented lower electrical resistivity. Concretes that presented low electrical resistivity showed high chloride concentrations in the profiles, including concentrations up to 1.6% by concrete mass at the peak.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
Data generated by the authors or analyzed during the study are available at http://www.bdita.bibl.ita.br/tesesdigitais/lista_resumo.php?num_tese=73486. Information about the Journal’s data-sharing policy can be found here: http://ascelibrary.org/doi/10.1061/(ASCE)CO.1943-7862.0001263.
Acknowledgments
The authors would like to thank the Fernando Lee Foundation for its support, as well as the Araucaria Foundation, National Council for Scientific and Technological Development (CNPQ), and Coordination for the Improvement of Higher Education Personnel (CAPES).
References
Akoglu, H. 2018. “User’s guide to correlation coefficients.” Turk. J. Emergency Med. 18 (3): 91–93. https://doi.org/10.1016/j.tjem.2018.08.001.
Andrade, C., and C. Alonso. 2001. “On-site measurements of corrosion rate of reinforcements.” Constr. Build. Mater. 15 (2–3): 141–145. https://doi.org/10.1016/S0950-0618(00)00063-5.
Andrade, C., R. D’Andreia, and N. Rebolledo. 2014. “Chloride ion penetration in concrete: The reaction factor in the electrical resistivity model.” Cem. Concr. Compos. 47 (Mar): 41–46. https://doi.org/10.1016/j.cemconcomp.2013.09.022.
Balestra, C. E. T. 2017. “Analysis of chloride profile obtained from real concrete structures present in different marine aggressive zones.” Doctoral thesis, Aeronautic Infrastructure Dept., Aeronautics Institute of Technology.
Balestra, C. E. T., A. Y. Nakano, G. Savaris, and R. A. Medeiros-Junior. 2019a. “Reinforcement corrosion risk of marine concrete structures evaluated through electrical resistivity: Proposal of parameters based on field structures.” Ocean Eng. 187 (Sep): 106167. https://doi.org/10.1016/j.oceaneng.2019.106167.
Balestra, C. E. T., T. A. Reichert, W. A. Pansera, and G. Savaris. 2019b. “Chloride profile modeling contemplating the convection zone based on concrete structures present for more than 40 years in different marine aggressive zones.” Constr. Build. Mater. 198 (Feb): 345–358. https://doi.org/10.1016/j.conbuildmat.2018.11.271.
Balestra, C. E. T., T. A. Reichert, and G. Savaris. 2019c. “Contribution for durability studies based on chloride profiles analysis of real marine structures in different marine aggressive zones.” Constr. Build. Mater. 206 (May): 140–150. https://doi.org/10.1016/j.conbuildmat.2019.02.067.
Balestra, C. E. T., G. Savaris, R. S. Nascimento, and R. A. Medeiros-Junior. 2019d. “Relations between chloride determination in real concrete structures by X-ray fluorescence spectroscopy and by potentiometric titration.” J. Build. Pathol. Rehabil. 4 (1): 1–5. https://doi.org/10.1007/s41024-019-0057-5.
Balestra, C. E. T., G. Savaris, M. V. Schlichting, and W. Leobet. 2018. “Development of laboratory equipment to obtain powdered concrete samples to determine chlorides concentration for durability studies.” J. Build. Pathol. Rehabil. 3 (1): 1–6. https://doi.org/10.1007/s41024-018-0034-4.
Caldas, L. M. 2000. Research on the history of Arvoredos Island and creation of Fernando Lee foundation. São Paulo, Brazil: Casa Fundação Fernando Lee.
Chen, C. T., J. J. Chang, and W. Yeih. 2014. “The effects of specimen parameters on the resistivity of concrete.” Constr. Build. Mater. 71 (Nov): 35–43. https://doi.org/10.1016/j.conbuildmat.2014.08.009.
Coppio, G. J. L., M. G. Lima, J. W. Lencioni, L. S. Cividanes, P. P. O. L. Dyer, and S. A. Silva. 2019. “Surface electrical resistivity and compressive strength of concrete with the use of waste foundry sand as aggregate.” Constr. Build. Mater. 212 (Jul): 514–521. https://doi.org/10.1016/j.conbuildmat.2019.03.297.
COST (Corrosion and Protection of Metals in Contact with Concrete). 1997. “Corrosion and protection of metals in contact with concrete.” In European commission in the field of scientific and technical research. Bruxelas, Bélgica: COST.
Gao, P., J. Xei, T. Zhang, J. Hu, and Q. Yu. 2017. “Modification of chloride diffusion coefficient of concrete based on the electrical conductivity of pore solution.” Constr. Build. Mater. 145 (Aug): 361–366. https://doi.org/10.1016/j.conbuildmat.2017.03.220.
Garzon, A. J., J. Sanchez, C. Andrade, N. Rebolledo, E. Menéndez, and J. Fullea. 2014. “Modification of four point method to measure the concrete electrical resistivity in presence of reinforcing bars.” Cem. Concr. Compos. 53 (Oct): 249–257. https://doi.org/10.1016/j.cemconcomp.2014.07.013.
Hornbostel, K., C. K. Larsen, and M. R. Geiker. 2013. “Relationship between concrete resistivity and corrosion rate—A literature review.” Cem. Concr. Compos. 39 (May): 60–72. https://doi.org/10.1016/j.cemconcomp.2013.03.019.
Hou, T. C., V. K. Nguyen, Y. M. Su, Y. R. Chen, and P. J. Chen. 2017. “Effects of coarse aggregates on the electrical resistivity of portland cement concrete.” Constr. Build. Mater. 133 (Feb): 397–408. https://doi.org/10.1016/j.conbuildmat.2016.12.044.
Linares-Alemparte, P., C. Andrade, and D. Baza. 2019. “Porosity and electrical resistivity-based empirical calculation of the oxygen diffusion coefficient in concrete.” Constr. Build. Mater. 198 (Feb): 710–717. https://doi.org/10.1016/j.conbuildmat.2018.11.269.
Medeiros-Junior, R. A., P. S. Gans, E. Pereira, and E. Pereira. 2019. “Electrical resistivity of concrete exposed to chlorides and sulfates.” ACI Mater. J. 116 (3): 119–130. https://doi.org/10.14359/51714464.
Medeiros-Junior, R. A., and M. G. Lima. 2016. “Electrical resistivity of unsaturated concrete using different types of cement.” Constr. Build. Mater. 107 (Mar): 11–16. https://doi.org/10.1016/j.conbuildmat.2015.12.168.
Medeiros-Junior, R. A., M. G. Lima, P. C. Brito, and M. H. F. Medeiros. 2015. “Chloride penetration into concrete in an offshore platform-analysis of exposure conditions.” Ocean Eng. 103 (Jul): 78–87. https://doi.org/10.1016/j.oceaneng.2015.04.079.
Melara, E. K., A. Z. Mendes, N. C. Andreczevecz, M. O. G. P. Braganca, G. T. Carrera, and R. A. Medeiros-Junior. 2020. “Monitoring by electrochemical impedance spectroscopy of mortars subjected to ingress and extraction of chloride ions.” Constr. Build. Mater. 242 (May): 118001. https://doi.org/10.1016/j.conbuildmat.2020.118001.
Mendes, S. E. S., R. L. N. Oliveira, C. Cremonez, E. Pereira, E. Pereira, and R. A. Medeiros-Junior. 2018. “Electrical resistivity as a durability parameter for concrete design: Experimental data versus estimation by mathematical model.” Constr. Build. Mater. 192 (Dec): 610–620. https://doi.org/10.1016/j.conbuildmat.2018.10.145.
Nguyen, A. Q., G. Klyz, F. Derby, and J. P. Balayssac. 2017. “Evaluation of water content gradient using a new configuration of linear array four-point probe for electrical resistivity measurement.” Cem. Concr. Compos. 83 (Oct): 308–322. https://doi.org/10.1016/j.cemconcomp.2017.07.020.
Nguyen, A. Q., G. Klyz, F. Derby, and J. P. Balayssac. 2018. “Assessment of the electrochemical state of steel in water saturated concrete by resistivity measurement.” Constr. Build. Mater. 171 (May): 455–466. https://doi.org/10.1016/j.conbuildmat.2018.01.155.
RILEM (International Union of Laboratories and Experts in Construction Materials, Systems and Structures). 1988. “CPC-18: Measurement of hardened concrete carbonation depth.” Mater. Struct. 21 (126): 453–455. https://doi.org/10.1007/BF02472327.
RILEM (International Union of Laboratories and Experts in Construction Materials, Systems and Structures). 2000. “TC154-EMC: Electrochemical techniques for measuring metallic corrosion.” Mater. Struct. 37 (234): 603–611. https://doi.org/10.1007/BF02480599.
Sengul, O. 2014. “Use of electrical resistivity as an indicator for durability.” Constr. Build. Mater. 73 (Dec): 434–441. https://doi.org/10.1016/j.conbuildmat.2014.09.077.
Yu, B., J. Liu, and Z. Chen. 2017. “Probabilistic evaluation method for corrosion risk of steel reinforcement based on concrete resistivity.” Constr. Build. Mater. 138 (May): 101–113. https://doi.org/10.1016/j.conbuildmat.2017.01.100.
Information & Authors
Information
Published In
Copyright
© 2020 American Society of Civil Engineers.
History
Received: Feb 8, 2020
Accepted: May 12, 2020
Published online: Jul 21, 2020
Published in print: Oct 1, 2020
Discussion open until: Dec 21, 2020
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.