Blast-Induced Liquefaction for Full-Scale Foundation Testing
This article has been corrected.
VIEW CORRECTIONPublication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 130, Issue 8
Abstract
This paper describes a pilot test program that was carried out to determine the appropriate charge weight, delay, and pattern required to induce liquefaction for full-scale testing of deep foundations. The results of this investigation confirmed that controlled blasting techniques could successfully be used to induce liquefaction in a well-defined, limited area for field-testing purposes. The tests also confirmed that liquefaction could be induced at least two times at the same site with nearly identical results. Excess pore pressure ratios greater than 0.8 were typically maintained for at least 4 min after blasting. The test results indicate that excess pore pressure ratios produced by blasting could be predicted with reasonable accuracy when single blast charges were used. However, for multiple blast charges, measured excess pressures were significantly higher than would have been predicted for a single blast with the same charge weight. The measured particle velocity attenuated more rapidly with scaled distance than would be expected based on the upper bound relationship developed from previous case histories. Settlement was typically about 2.5% of the liquefied thickness, and about 85% of the settlement occurred within 30 min after the blast. Cone penetrometer test results show that blasting initially reduced the soil strength, but after several weeks the strength had substantially increased.
Get full access to this article
View all available purchase options and get full access to this article.
References
Charlie, W. A., Rwebyogo, F. J., and Doehring, D. O.(1992). “Time-dependent cone penetration resistance due to blasting.” J. Geotech. Eng., 118(8), 1200–1215.
Dobry, R., Abdoun, T., and O’Rourke, T. D. (1996). “Evaluation of pile response due to liquefaction induced lateral spreading of the ground.” Proc., 4th Caltrans Seismic Design Workshop, California Dept. of Transportation, Sacramento, Calif.
Dowding, C. H., and Hryciw, R. W.(1986). “A laboratory study of blast densification of saturated sand.” J. Geotech. Eng., 112(2), 187–199.
Finn, W. D. L. (1978). “Mechanics of liquefaction under blast-loading.” Transcripts of the Int. Workshop on Blast-Induced Liquefaction, U.S. Air Force, Maidenhead, U.K.
Gohl, W. B., J. A. Howie, and C. E. Rea. (2001). “Use of controlled detonation of expolsives for liquefaction testing.” Proc., 4th Int. Conf. on Recent Advances in Geotechnical Earthquake Geotechnical Engineering and Soil Dynamics and Symp. in Honor of Professor W. D. Liam Finn, San Diego, March 26–31.
Hachey, J. E., Plum, R. L., Byrne, R. J., Kilian, A. P., and Jenkins, D. V. (1994). “Blast-densification of thick, loose debris flow at Mt. St. Helen’s, Washington.” Vertical and Horizontal Deformations of Foundations and Embankments, ASCE Geotech. Spec. Pub. 40, ASCE, Reston, Va., 502–512.
Kulhawy, F. H., and Mayne, P. W. (1990). “Manual on estimating soil properties for foundation design.” Electric Power Research Institute, EL-6800 Research Project 1493-6 Final Rep., 2-24 and 2-33.
Mesri, G., Feng, T. W., and Benak, J. M.(1990). “Postdensification penetration resistance of clean sands.” J. Geotech. Eng., 116(7), 1095–1115.
Mitchell, J. K.(1986). “Practial problems from surprising soil behavior.” J. Geotech. Eng., 112(3), 255–289.
Mitchell, J. K., and Solymar, Z. V.(1984). “Time-dependent strength gain in freshly deposited or densitfied sand.” J. Geotech. Eng., 110(11), 1559–1576.
Narin van Court, W. A., and Mitchell, J. K. (1995). “New insights into explosive compaction of loose, saturated, cohesionless soils.” Soil Improvement for Earthquake Hazard Mitigation, ASCE Geotech. Spec. Pub. 49, ASCE, Reston, Va., 51–65.
Rollins, K. M., Ashford, S. A., Lane, J. D., and Hryciw, R. D. (2000). “Controlled blasting to simulate liquefaction for full-scale lateral load testing.” Proc., 12th World Conf. on Earthquake Engineering, Paper 1949, New Zealand Society for Earthquake Engineering, Auckland, New Zealand.
Schmertman, J. H.(1991). “The mechanical aging of soils.” J. Geotech. Eng., 117(9), 1288–1330.
Studer, J., and Kok, L. (1980). “Blast-induced excess porewater pressure and liquefaction experience and application.” Int. Symposium on Soils under Cyclic and Transient Loadings, Swansea, Wales, Balkema, Rotterdam, The Netherlands, 581–593.
Wilson, D. W., Boulanger, R. W., and Kutter, B. L.(2000). “Observed seismic lateral resistance of liquefied sand.” J. Geotech. Geoenviron. Eng., 126(10), 898–906.
Information & Authors
Information
Published In
Copyright
Copyright © 2004 American Society of Civil Engineers.
History
Received: Feb 6, 2001
Accepted: Jun 12, 2003
Published online: Jul 15, 2004
Published in print: Aug 2004
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.