Predictive Models for the Median and Variability of Building Period and Damping
This article is a reply.
VIEW THE ORIGINAL ARTICLEThis article has a reply.
VIEW THE REPLYPublication: Journal of Structural Engineering
Volume 135, Issue 5
Abstract
There are two goals in this paper: (1) the presentation of a comprehensive database of over 4,000 fundamental period and damping measurements from nearly 1,000 buildings; and (2) the derivation of predictive models for period and damping. The modeling approach presented in the companion paper, which accounts for the statistically nonconforming properties that characterize building data, is used herein to derive models which include two intrinsic sources of variability: that associated with multiple measurements from different excitations on the same building and variability between buildings that are nominally identical. The period models are in general agreement with those currently used, with model parameters that are in terms of height, material, and lateral force resisting system. The damping models show a decrease in damping as building height increases and, for steel and reinforced structures, a twofold increase in damping for earthquake excitations as opposed to other, lower amplitude excitations.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This material is based upon work partially supported by the National Science Foundation at Johns Hopkins University under Grant No. NSFDMI-0087032. This research support is gratefully acknowledged.
References
Applied Technology Council (ATC). (1978). “Tentative provisions for the development of seismic regulations for buildings.” National Bureau of Standards Special Pub., 510, Gaithersburg, Md.
Architectural Institute of Japan (AIJ). (1996). Database of dynamic properties of buildings and structures in Japan, Research Committee on Damping Evaluation, Tokyo Inst. of Polytechnics, Kanagawa, Japan.
ASCE/SEI. (2005). “Minimum design loads for buildings and other structures.” ASCE/SCI 7-05, Reston, Va.
Chrysanthakopoulos, C., Bazeos, N., and Beskos, D. E. (2006). “Approximate formulae for natural periods of plane steel frames.” J. Constr. Steel Res., 62(6), 592–604.
Crowley, H., and Pinho, R. (2004) “Period-height relationship for existing European reinforced concrete buildings.” J. Earthquake Eng., 8(1), 93–119.
Fang, J. Q., Li, Q. S., Jeary, A. P., and Wong, C. K. (1999). “Random damping in buildings and its AR model.” J. Wind. Eng. Ind. Aerodyn., 79, (1–2), 159–167.
Federal Emergency Management Agency (FEMA). (1997). “NEHRP guidelines for the seismic rehabilitation of buildings.” Pub. 273, Washington, D.C.
Fritz, W. P. (2003). “Period and damping selection for the design and analysis of building structures.” Ph.D. dissertation, The Johns Hopkins Univ., Baltimore.
Ghrib, F., and Mamedov, H. (2004). “Period formulas of shear wall buildings with flexible bases.” Earthquake Eng. Struct. Dyn., 33(3), 295–314.
Goel, R. K., and Chopra, A. K. (1997a). “Period formulas for moment-resisting frame buildings.” J. Struct. Eng., 124(4), 426–433.
Goel, R. K., and Chopra, A. K. (1997b). “Vibration properties of buildings determined from recorded earthquake motions.” EERC Rep. No. 97/14, Univ. of California, Berkeley, Calif.
Haviland, R. (1976). “A study of the uncertainties in the fundamental translational period and damping values of real buildings.” MIT Research Rep. No., 5, R76-12, Dept. of Civil Engineering, MIT, Cambridge, Mass.
Hill-Carroll, P. E. B. (1985). “The prediction of mean structural damping values and their coefficients of variation.” Master’s thesis, The Univ. of Western Ontario, London, Canada.
Hong, L., and Hwang, W. (2000). “Empirical formula for fundamental vibration periods of reinforced concrete buildings in Taiwan.” Earthquake Eng. Struct. Dyn., 29(3), 327–337.
International Code Council. (1997). “Uniform building code.” Proc., Int. Conf. of Building Officials, Whittier, Calif.
International Code Council. (2000). “2000 international building code.” Proc., Int. Conf. of Building Officials, Whittier, Calif.
Jeary, A. P. (1986). “Damping in tall buildings—A mechanism and a predictor.” Earthquake Eng. Struct. Dyn., 14(5), 733–750.
Kareem, A., and Gurley, K. (1996). “Damping in structures: Its evaluation and treatment of uncertainty.” J. Wind. Eng. Ind. Aerodyn., 59(2-3), 131–157.
Lagomarsino, S. (1993). “Forecast models for damping and vibration periods of buildings.” J. Wind. Eng. Ind. Aerodyn., 48(2–3), 221–239.
Satake, N., Suda, K., Arakawa, T., Sasaki, A., and Tamura, Y. (2003). “Damping evaluation using full-scale data of buildings in Japan.” J. Struct. Eng., 129(4), 470–477.
Structural Engineers Association of California (SEAOC). (1996). “Recommended lateral force requirements and commentary.” SEAOC blue book, Sacramento, Calif.
Information & Authors
Information
Published In
Copyright
© 2009 ASCE.
History
Received: Feb 1, 2007
Accepted: Nov 5, 2008
Published online: May 1, 2009
Published in print: May 2009
Notes
Note. Associate Editor: Sankaran Mahadevan
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.