Real-Time Error Monitoring for Hybrid Simulation. Part I: Methodology and Experimental Verification
This article is a reply.
VIEW THE ORIGINAL ARTICLEThis article has a reply.
VIEW THE REPLYPublication: Journal of Structural Engineering
Volume 133, Issue 8
Abstract
The hybrid simulation test method is a versatile technique for evaluating the seismic performance of structures by seamlessly integrating both physical and numerical simulations of substructures into a single test model. Hybrid simulation results have been shown to be reliable by comparison to shake-table simulations when propagation of experimental errors is successfully mitigated. Techniques have been proposed to assess the severity of experimental errors prior to or after tests have been completed. In this paper, an error monitoring method is presented that predicts the reliability of the test results in real time using data that is readily available. Two error monitors are derived based on estimates of energy added to the hybrid simulation as a result of errors in the experimental setup. The proposed method can provide valuable decision-making information by generating early warnings of unacceptable levels of experimental errors. The warning signals can serve as an indicator to pause the simulation, examine the source of error, and correct the problem, preferably before the specimen is irreparably damaged. Use of the proposed hybrid simulation error monitors to provide a measure of confidence of the quality of the test results is verified in two hybrid simulations.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was supported in part by the NEES Program of the National Science Foundation under award number CMS-0086621. Their support is gratefully acknowledged. Any opinions, findings, and conclusions or recommendations expressed in this material are those of the writers and do not necessarily reflect those of the National Science Foundation.
References
Bathe, K. J. (1996). Finite element procedures, Prentice Hall, Englewood Cliffs, N.J.
Blakeborough, A., Williams, M. S., Darby, A. P., and Williams, D. M. (2001). “The development of real-time substructure testing.” Philos. Trans. R. Soc. London, 359, 1869–1891.
Chang, S.-Y., Tsai, K.-C., and Chen, K.-C. (1999). “Improved time integration for pseudodynamic tests.” Earthquake Eng. Struct. Dyn., 27(7), 711–730.
Combescure, D., and Pegon, P. (1997). “Alpha-operator splitting time integration technique for pseudodynamic testing error propagation analysis.” Soil Dyn. Earthquake Eng., 16, 427–443.
Hilbert, H. M., Hughes, T. J. R., and Taylor, R. L. (1977). “Improved numerical dissipation for time integration algorithms in structural dynamics.” Earthquake Eng. Struct. Dyn., 5, 283–292.
Horiuchi, T., Inoue, M., Konno, T., and Namita, Y. (1999). “Real-time hybrid experimental system with actuator delay compensation and its application to a piping system with energy absorber.” Earthquake Eng. Struct. Dyn., 28(10), 1121–1141.
Magonette, G. (2001). “Development and application of large-scale continuous pseudodynamic testing techniques.” Philos. Trans. R. Soc. London, 359, 1771–1799.
Magonette, G. E., and Negro, P. (1998). “Verification of the pseudodynamic test method.” Eur. Earthquake Eng., XII(1), 40–50.
Mahin, S. A., and Shing, P. B. (1985). “Pseudodynamic method for seismic performance testing.” J. Struct. Eng., 111(7), 1482–1503.
Mahin, S. A., Shing, P. B., Thewalt, C. R., and Hanson, R. D. (1989). “Pseudodynamic test method—Current status and future directions.” J. Struct. Eng., 115(8), 2113–2128.
Molina, J., Magonette, G., and Pegon, P. (2002a). “Assessment of systematic experimental errors in pseudodynamic tests.” Proc., 12th European Conf. on Earthquake Engineering, Paper Ref. 525.
Molina, F. G., et al. (2002b). “Pseudodynamic tests on rubber base isolators with numerical substructuring of the superstructure and strain-rate effect compensation.” Earthquake Eng. Struct. Dyn., 31(98), 1563–1582.
Mosqueda, G., Stojadinovic, B., and Mahin, S. A. (2005). “Implementation and accuracy of continuous hybrid simulation with geographically distributed substructures.” Rep. No. UCB/EERC-2005/02 Earthquake Eng. Res. Center, Univ. of California at Berkeley, Berkeley.
Mosqueda, G., Stojadinovic, B., and Mahin, S. A. (2007). “Real-time error monitoring for hybrid simulations. Part II: Structural response modification due to errors.” J. Struct. Eng., 133(8), 1109–1117.
Nakashima, M. (2001). “Development, potential, and limitations of real-time online (pseudodynamic) testing.” Philos. Trans. R. Soc. London, 359, 1851–1867.
Nakashima, M., Kato, M., and Takaoka, E. (1992). “Development of real-time pseudo dynamic testing.” Earthquake Eng. Struct. Dyn., 21(1), 79–92.
Nakashima, M., and Masaoka, N. (1999). “Real-time online test for MDOF systems.” Earthquake Eng. Struct. Dyn., 28(4), 393–420.
Newmark, N. M. (1959). “A method of computation for structural dynamics.” J. Engrg. Mech. Div., 85(3), 67–94.
Peek, R., and Yi, W.-H. (1990). “Error analysis for pseudodynamic test method: I. Analysis.” J. Eng. Mech., 116(7), 1618–1637.
Shing, P. B., and Mahin, S. A. (1983). “Experimental error propagation in pseudodynamic testing.” Rep. UCB/EERC-83/12 Earthquake, Eng. Res. Center, Univ. of California at Berkeley, Berkeley.
Shing, P. B., and Mahin, S. A. (1984). “Pseudodynamic test method for seismic performance evaluation: Theory and implementation.” Rep. UCB/EERC-84/01. Earthquake Eng. Res. Center, Univ. of California at Berkeley, Berkeley, Calif.
Stojadinovic, B., Mosqueda, G., and Mahin, S. A. (2006). “Event-driven control system for geographically distributed hybrid simulation.” J. Struct. Eng. 132(1), 68–77.
Stoten, D., and Magonette, G. (2001). “Developments in the automatic control of experimental facilities.” Rep. No. 9 ECOEST2/ICONS, Laboratoria Nacional de Engenharia Civil, Lisboa, Portugal.
Takanashi, K., and Nakashima, M. (1987). “Japanese activities on online testing.” J. Eng. Mech., 113(7), 1014–1032.
Thewalt, C. R., and Mahin, S. A. (1987). “Hybrid solution techniques for generalized pseudodynamic testing.” Rep. No. UCB/EERC-87/09, Earthquake Eng. Res. Center, Univ. of California at Berkeley, Berkeley.
Thewalt, C. R., and Roman, M. (1994). “Performance parameters for pseudodynamic tests.” J. Struct. Eng., 120(9), 2768–2781.
Uang, C.-H., and Bertero, V. V. (1990). “Evaluation of seismic energy in structures.” Earthquake Eng. Struct. Dyn., 19(1), 77–90.
Information & Authors
Information
Published In
Copyright
© 2007 ASCE.
History
Received: Apr 10, 2006
Accepted: Sep 19, 2006
Published online: Aug 1, 2007
Published in print: Aug 2007
Notes
Note. Associate Editor: Reginald DesRoches
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.