Compression Response of Cracked Reinforced Concrete
This article has a reply.
VIEW THE REPLYPublication: Journal of Structural Engineering
Volume 119, Issue 12
Abstract
Cracked reinforced concrete in compression has been observed to exhibit lower strength and stiffness than uniaxially compressed concrete. The so‐called compression softening effect responsible is thought to be related to the degree of transverse cracking and straining present. It significantly influences the strength, ductility and load‐deformation response of a concrete element. A number of experimental investigations have been undertaken to determine the degree of softening that occurs, and the factors that influence it. At the same time, a number of diverse analytical models have been proposed by various researchers aimed at modeling this behavior. In this paper, a review is made of the experimental data available, of the various models proposed, and of the accuracy of the models in correlating to the test data. Based on new data, previously derived analytical models are updated. Parametric studies are made to investigate factors thought to influence the softening effect. As well, nonlinear finite element analyses of test panels are conducted to determine the relative significance of compression softening in accurately predicting behavior of reinforced‐concrete elements.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Belarbi, A., and Hsu, T. T. C. (1991). “Constitutive laws of reinforced concrete in biaxial tension‐compression.” Research Report UHCEE 91‐2, Univ. of Houston, Houston, Tex.
2.
Bhide, S. B., and Collins, M. P. (1989). “Influence of axial tension on the shear capacity of reinforced concrete members.” ACT Struct. J., 86(5), 570–581.
3.
Collins, M. P., and Mitchell, D. (1980). “Shear and torsion design of prestressed and non‐prestressed concrete beams.” J. PCI., 25(5), 32–100.
4.
Collins, M. P., and Porasz, A. (1989). “Shear strength for high strength concrete.” Bull. No. 193‐Design Aspects of High Strength Concrete, Comité Euro‐International du Beton (CEB), 75–83.
5.
Cook, W. D., and Mitchell, D. (1988). “Studies of disturbed regions near discontinuities in reinforced concrete members.” ACI Struct. J., 85(2), 206–216.
6.
Kollegger, J., and Mehlhorn, G. (1990). “Experimentelle Untersuchungen zur Bestimmung der Druckfestigkeit des gerissenen Stahlbetons bei einer Querzugbeanspruchung.” Report 413, Deutscher Ausschuss Für Stahlbeton, Berlin, Germany.
7.
Marti, P., and Meyboom, J. (1992). “Response of prestressed elements to in‐plane shear.” ACI Struct. J., 89(5), 503–514.
8.
Mikame, A., Uchida, K., and Noguchi, H. (1991). “A study of compressive deterioration of cracked concrete.” Proc. Int. Workshop on Finite Element Analysis of Reinforced Concrete, Columbia Univ., New York, N.Y.
9.
Miyahara, T., Kawakami, T., and Maekawa, K. (1988). “Nonlinear behavior of cracked reinforced concrete plate element under uniaxial compression.” Concrete Library International, Japan Society of Civ. Engrs., JSCE, Vol. 11, 306–319.
10.
Shirai, S., and Noguchi, H. (1989). “Compressive deterioration of cracked concrete.” Proc. ASCE Structures Congress 1989: Design, Analysis and Testing, ASCE, New York, N.Y., 1–10.
11.
Stevens, N. J., Uzumeri, S. M., Collins, M. P., and Will, G. T. (1991). “Constitutive model for reinforced concrete finite element analysis.” ACI Struct. J., 88(1), 49–59.
12.
Thorenfeldt, E., Tomaszewicz, A., and Jensen, J. J. (1987). “Mechanical properties of high‐strength concrete and application in design.” Proc. Symposium Utilization of High‐Strength Concrete.” Stavanger, Norway, Tapir Trondheim.
13.
Ueda, M., Noguchi, H., Shirai, N., and Morita, S. (1991). “Introduction to activity of new RC.” Proc. Int. Workshop on Finite Element Analysis of Reinforced Concrete, Columbia Univ., New York, N.Y.
14.
Vecchio, F. J. (1989). “Nonlinear finite element analysis of reinforced concrete membranes.” ACI Struct. J., 86(10), 26–35.
15.
Vecchio, F. J., and Chan, C. C. L. (1990). “Reinforced concrete membrane elements with perforations.” J. Struct. Engrg., ASCE, 116(9), 2344–2360.
16.
Vecchio, F. J., and Collins, M. P. (1986). “The modified compression field theory for reinforced concrete elements subjected to shear.” ACI J., 83(2), 219–231.
17.
Vecchio, F. J., and Collins, M. P. (1982). “Response of reinforced concrete to in‐plane shear and normal stresses.” Report No. 82‐03, Univ. of Toronto, Toronto, Canada.
Information & Authors
Information
Published In
Copyright
Copyright © 1993 American Society of Civil Engineers.
History
Received: Jun 8, 1992
Published online: Dec 1, 1993
Published in print: Dec 1993
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.