Experimental Analysis of Local Pressure Losses for Microirrigation Laterals
This article has a reply.
VIEW THE REPLYPublication: Journal of Irrigation and Drainage Engineering
Volume 130, Issue 4
Abstract
The accurate design of drip irrigation laterals needs to consider the variation of hydraulic head due to pipe elevation changes, head losses along the lines, and also, at a given operating pressure, emitter discharge variations related to manufacturing variability, clogging, and water temperature. Hydraulic head variations are consequent to both the friction losses and local losses due to the in-line or on-line emitters along the pipe, which determine the contraction and subsequent enlargement of the flow streamlines. Moreover, in-line emitters usually have a smaller diameter than the pipe, and therefore an additional friction loss must be considered. Evaluation of energy losses and consequently the design of drip irrigation lines is usually carried out by assuming the hypothesis that local losses can be neglected, even if previous experimental researches showed that local losses can become a significant percentage of total head losses as a consequence of the high number of emitters installed along the lines. This paper reports the results of an experimental investigation to evaluate local losses in integrated laterals in which coextruded emitters are installed inside the pipe. Local losses were measured for 10 different types of commercially available integrated laterals and for different Reynolds numbers. A practical power relationship was deduced between the α coefficient, expressing the amount of local losses as a fraction of the kinetic head, and a simple geometric parameter characterizing the geometry of the emitter and the pipe. Local losses obtained for integrated laterals were then compared with those due to the on-line emitters, previously determined as a function of the pipe-emitter geometry. The proposed criterion for calculating the local losses was finally verified by using a step-by-step procedure.
Get full access to this article
View all available purchase options and get full access to this article.
References
Al Amound, A. I.(1995). “Significance of energy losses due to emitter connections in trickle irrigation lines.” J. Agric. Eng. Res., 60(1), 1–5.
Bagarello, V., Ferro, V., Provenzano, G., and Pumo, D.(1995). “Experimental study on flow-resistance law for small-diameter plastic pipes.” J. Irrig. Drain. Eng., 121(5), 313–316.
Bagarello, V., Ferro, V., Provenzano, G., and Pumo, D.(1997). “Evalu-ating pressure losses in drip-irrigation lines.” J. Irrig. Drain. Eng.,123(1), 1–7.
Bagarello, V., and Pumo, D. (1992). “Lateral line hydraulics in drip irrigation systems.” Proc., 16th ICID European Regional Conf., Int. Commission on Irrigation and Drainage, New Delhi, India.
Blasius, H. (1913). “Das Aehnlichkeitsgesetz bei Reibungsvorgangen in Flussigkeiten.” Forshungsarbeiten auf dem Gebiete des Ingenieur-Wesen, 131(1) (in German).
Howell, T. A., and Barinas, F. A.(1980). “Pressure losses across trickle irrigation fittings and emitters.” Trans. ASAE, 23(4), 928–933.
Jeppson, R. W. (1982). Analysis of flow in pipe networks, 5th Ed., Ann Arbor Science, Ann Arbor, Mich.
Juana, L., Rodriguez-Sinobas, L., and Losada, A.(2002). “Determining minor head losses in drip irrigation laterals. I: Methodology.” J. Irrig. Drain. Eng., 128(6), 376–384.
Kang, Y., Nishiyama, S., and Chen, H.(1996). “Design of microirrigation laterals on nonuniform slopes.” Irrig. Sci., 17, 3–14.
Karmeli, D., and Keller, J. (1975). Trickle irrigation design, Rain Bird Sprinkler Manufacturing Corp., Glendora, Calif.
Provenzano, G., Pumo, D., and Di Dio, P.(2003). “Valutazione delle perdite di carico nelle gocciolanti integrali.” Riv. Ingegneria Agraria, 4, 55–63 (in Italian).
Solomon, K.(1979). “Manufacturing variation of emitters in trickle irrigation systems.” Trans. ASAE, 22(5), 1034–1038.
Valiantzas, J. D.(1998). “Analytical approach for direct drip lateral hydraulic calculation.” J. Irrig. Drain. Eng., 124(6), 300–305.
Vallesquino, P., and Luque-Escamilla, P. L.(2002). “Equivalent friction factor method for hydraulic calculation in irrigation laterals.” J. Irrig. Drain. Eng., 128(5), 278–286.
von Bernuth, R. D.(1990). “Simple and accurate friction loss equation for plastic pipe.” J. Irrig. Drain. Eng., 116(2), 294–298.
von Bernuth, R. D., and Wilson, T.(1989). “Friction factors for small diameter plastic pipes.” J. Hydr. Eng.,115(2), 183–192.
Wu, I. P.(1992). “Energy gradient line for direct hydraulic calculation in drip irrigation design.” Irrig. Sci., 13, 21–29.
Wu, I. P.(1997). “An assessment of hydraulic design of micro-irrigation systems.” Agric. Water Manage., 32, 275–284.
Zayani, K., Alouini, A., Lebdi, F., and Lamaddalena, N.(2001). “Design of drip irrigation systems using the energy drop ratio approach.” Trans. ASAE, 44(5), 1127–1133.
Information & Authors
Information
Published In
Copyright
Copyright © 2004 American Society of Civil Engineers.
History
Received: Jan 27, 2003
Accepted: Dec 30, 2003
Published online: Jul 15, 2004
Published in print: Aug 2004
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.