Experimental Study of Debris Flows
This article has a reply.
VIEW THE REPLYPublication: Journal of Hydraulic Engineering
Volume 120, Issue 1
Abstract
A steady uniform flow of high concentration sand‐water mixture was recirculated in a flume using a progressing cavity pump. The flume was set on a slope of 28.6%. A specially designed volumetric flow sampler was used to measure the vertical velocity and concentration profiles at the center of the channel. Velocity and concentration distributions are presented for flows with almost uniform sand particles of sizes 0.430, 0.335, and 0.215 mm. Similar distributions are also presented for flows having a mixture of these three sand sizes with a mean diameter of 0.33 mm. Mean volumetric concentrations for these flows ranged from approximately 2.5% to 43.5%. These measurements are compared with the predictions of dilatant fluid as well as laminar and turbulent Newtonian fluid models. The difficulties associated with laboratory handling and measurements of high concentration fluid flow in an open channel have been discussed.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Arai, M., and Takahashi, T. (1986). “The Karman constant of the flow laden with high sediment.” Proc. Third Int. Symp. on River Sedimentation, Univ. of Mississippi, 824–833.
2.
Arai, M., and Takahashi, T. (1983). “A method for measuring velocity profiles in mud flows.” Proc. of 20th IAHR Congress, IAHR, Moscow, 3, 279–286.
3.
Bagnold, R. A. (1954). “Experiments in a gravity‐free dispersion of large solid spheres in a Newtonian fluid under shear.” Proc. Royal Soc. London, Ser A, 225, 49–63.
4.
Bailard, J. E., and Inman, D. L. (1979). “A reexamination of Bagnold's granular fluid model and bed load transport equation.” J. Geophys. Res., 84(12), 7827–7833.
5.
Chen, C. L. (1988). “Generalized viscoplastic modelling of debris flows.” J. Hydr. Engrg., ASCE, 114(3), 237–258.
6.
Davies, R. H. (1988). “Debris flows surges—A laboratory investigation.” Mitteilungen der Versuchsanstalt fur Wasserbau, Hydrologie und Glaziologie, Zurich, Switzerland, 96.
7.
Lee, D. I. (1969). “The viscosity of concentrated suspensions.” Trans. of the Society of Rheology, 3(2), 273–288.
8.
Einstein, A. (1906). “Eine neue bestimmung der molekuldimensionen.” Annslen der Physik, Leipzig (4), 19, 289.
9.
Hirano, M., and Iwamoto, M. (1981). “Experimental study on the grain sorting and the flow characteristics of a bore.” Mem. Faculty of Engrg., Kyushu Univ., 1(3), 193–202.
10.
Iverson, R. M., and Denlinger, R. P. (1987). “The physics of debris flows—a conceptual assessment.” Erosion and Sedimentation in the Pacific Rim (Proc. of the Corvallis Symp., 155–165.
11.
Lun, C. K. K., Savage, S. B., Jeffery D. J., and Chepurniy, N. (1984). “Kinetic theories for granular flow: Inelastic particles in couette flow and slightly inelastic particles in a general flowfield.” J. Fluid Mech., 140, 223–256.
12.
Mainali, A. (1993). “Laboratory study of hyperconcentrated open channel flows,” PhD thesis, The Univ. of Alberta, Edmonton, Alberta.
13.
Mainali, A., and Rajaratnam, N. (1991). “Laboratory measurements of debris flows.” Proc. 1991 Annual Conf. of the Canadian Society for Civil Engrg., 1, 146–154.
14.
Major, J. J., and Pierson, T. C. (1990). “Rheological analysis of fine grained natural debris flow material.” Hydraulics/Hydrology of Arid Lands, Proc. of the Int. Symp., ASCE, New York, N.Y., 225–231.
15.
McTigue, D. F. (1982). “A nonlinear constitutive model for granular material, application to gravity flows.” J. Appl. Mech. Trans., ASME, 49(6), 291–296.
16.
O'Brien, J. S., and Julien, P. Y. (1988). “Laboratory analysis of mudflow properties.” J. Hydr. Engrg., ASCE, 114(8), 877–887.
17.
Pierson, T. C. (1981). “Dominant particle support mechanism in debris flow at Mt. Thomas, New Zealand, and implications for flow mobility.” Sedimentology, 28, 49–60.
18.
Sassa, K. (1985). “The mechanics of debris flows.” Proc. XI Int. Conf. on Soil Mechanics and Foundation Engineering, San Francisco, 1173–1176.
19.
Savage, S. B. (1979). “Gravity flow of cohesionless granular material in chutes and channels.” J. Fluid Mech., 92(1), 53–96.
20.
Shen, H., and Ackermann, N. L. (1982). “Constitutive relations for fluid‐solid mixtures.” J. Engrg. Mech. Div., ASCE, 108(5), 748–763.
21.
Takahashi, T. (1978). “Mechanical characteristics of debris flow.” J. Hydr. Div., ASCE, 104(8), 1153–1169.
22.
VanDine, D. F. (1985). “Debris flows and debris torrents in the Southern Canadian Cordillera.” Can. Geotech. J., 22(1), 44–68.
23.
Wang, L. (1990). “Flume experiments on debris flow.” Hydraulics/Hydrology of Arid Lands, Proc. of the Int. Symp., ASCE, New York, N.Y., 238–243.
24.
Winterwerp, J. C., de Groot, M. B., Masterbergen, D. R., and Verwoert, H. (1990). “Hyperconcentrated sand‐water mixture flows over flat‐bed.” J. Hydr. Engrg., ASCE, 116(1), 36–54.
25.
Yano, K., and Daido, A. (1965). “Fundamental study on mud‐flow.” Bull. Disaster Prevention Res. Inst., Kyoto, Japan, 14, 69–83.
Information & Authors
Information
Published In
Copyright
Copyright © 1994 American Society of Civil Engineers.
History
Received: Dec 26, 1991
Published online: Jan 1, 1994
Published in print: Jan 1994
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.