Analysis of Behavior of Sand Surrounding Pile Tips
This article has a reply.
VIEW THE REPLYPublication: Journal of Geotechnical Engineering
Volume 122, Issue 11
Abstract
A finite-element approach is presented to predict the behavior of dense sand surrounding the pile tip in a fairly large stress range, from low stress levels to very high ones, where particle breakage occurs. The approach is based on a constitutive model for sand, which is characterized by critical-state–type yield surfaces and by a nonlinear Mohr-Coulomb failure criterion, the latter being defined on the basis of constant-volume shear strength and of dilatancy. In addition, the concept of constant relative breakage surfaces, which represent families of curves characterized by constant amounts of particle crushing, is introduced. It is shown that the model, applied to the analysis of the behavior of the tip of nondisplacement piles in sand, can be used to visualize and to predict the distribution of strength, dilatancy, and grain breakage in the soil surrounding the pile base.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
BCP Committee.(1971). “Field tests on piles in sand.”Soils and Found., 11(2), 29–49.
2.
Billam, J. (1971). “Some aspects of the behavior of granular material at high pressures.”Stress-Strain Behaviour of Soils, Proc., Roscoe Memorial Symp., G. T. Foulis and Co. Ltd., Henley on Thames, Oxfordshire, England, 69–80.
3.
Bolton, M. D.(1986). “The strength and dilatancy of sands.”Geotechnique, London, England, 36(1), 65–78.
4.
Bolton, M. D.(1987). “Discussion.”Géotechnique, London, England, 37(2), 225–226.
5.
Desai, C. S.(1974). “Numerical design-analysis for piles in sands.”J. Geotech. Engrg. Div., ASCE, 100(6), 613–635.
6.
Franke, E. (1993). “Design of bored piles, including negative skin friction and horizontal loading.”Proc., 2nd Int. Geotech. Seminar on Deep Found. on Bored and Auger Piles, Van Empe, ed., A. A. Balkema, Rotterdam, The Netherlands, 43–57.
7.
Hardin, B. O.(1985). “Crushing of soil particles.”J. Geotech. Engrg., ASCE, 111(10), 1177–1192.
8.
Lee, K. L., and Farhoomand, I.(1967). “Compressibility and crushing of granular soils.”Can. Geotech. J., 4(1), 68–86.
9.
Leslie, D. D. (1963). “Large scale triaxial tests on gravelly soils.”Proc., 2nd Panamerican Conf. on Soil Mech. and Found. Engrg., Vol. 1, 181–202.
10.
Lo, K. Y., and Roy, M.(1973). “Response of particulate materials at high pressure.”Soils and Found., 13(1), 61–76.
11.
Marsal, R. J. (1965). “Discussion on shear strength.”Proc., 6th Int. Conf. on Soil Mech. and Found. Engrg., University of Toronto Press, Toronto, Canada, Vol. 3, 310–316.
12.
Mazzucato, A., and Ricceri, G. (1986). “Load test on model pile driven into sand.”Proc., Int. Conf. on Deep Found., China Building Industry Press, Beijing, China, Vol. 1, 154–159.
13.
Miura, N., Murata, H., and Yasufuku, N.(1984). “Stress-strain characteristics of sand in a particle-crushing region.”Soils and Found., 24(1), 77–89.
14.
Ottaviani, M.(1975). “Three dimensional finite element analysis of vertically loaded pile groups.”Géotechnique, London, England, 25(2), 159–174.
15.
Poulos, H.(1989). “Pile behaviour—Theory and application.”Géotechnique, London, England, 39(3), 365–415.
16.
Simonini, P.(1993). “Influence of relative density and stress level on the bearing capacity of sands.”Int. J. Numer. Anal. Methods Geom., 17(12), 871–890.
17.
Vesic, A. S., and Clough, G. W.(1968). “Behavior of granular materials under high stresses.”J. Soil Mech. and Found. Div., ASCE, 94(3), 661–688.
18.
Yamamuro, J. A., and Lade, P. V. (1993). “B-value measurements for granular materials at high pressures.”Geotech. Testing J., 16(2), 165–171.
19.
Yamamuro, J. A., and Lade, P. V.(1996). “Drained sand behaviour in axysimmetric tests at high pressures.”J. Geotech. Engrg., ASCE, 122(2), 109–119.
20.
Zienkiewicz, O. C., Humpheson, C., and Lewis, R. W.(1975). “Associated and non associated visco-plasticity in soil mechanics.”Géotechnique, London, England, 25(4), 671–689.
21.
Zienkiewicz, O. C., and Humpheson, C. (1977). “Viscoplasticity: a generalized model for description of soil behaviour.”Numerical Methods in Geotechnical Engineering, Desai, C. S. and Christian, T. J., eds., McGraw Hill, New York.
22.
Zytynski, M., Randolph, M. F., Nova, R., and Wroth, C. P.(1978). “On modelling the unloading-reloading behaviour of soils.”Int. J. Numer. Anal. Methods in Geom., 2, 87–94.
Information & Authors
Information
Published In
Copyright
Copyright © 1996 American Society of Civil Engineers.
History
Published online: Nov 1, 1996
Published in print: Nov 1996
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.