Geotechnical Properties of Oil-Contaminated Kuwaiti Sand
This article has a reply.
VIEW THE REPLYPublication: Journal of Geotechnical Engineering
Volume 121, Issue 5
Abstract
Large quantities of oil-contaminated sands resulted from exploded oil wells, burning oil fires, the destruction of oil storage tanks, and the formation of oil lakes in Kuwait at the end of the Gulf War. An extensive laboratory testing program was carried out to determine the geotechnical characteristics of this material. Testing included basic properties, compaction and permeability tests, and triaxial and consolidation tests on clean and contaminated sand at the same relative density. Contaminated specimens were prepared by mixing the sand with oil in the amount of 6% by weight or less to match field conditions. The influence of the type of oil, and relative density was also investigated by direct shear tests. The results indicated a small reduction in strength and permeability and an increase in compressibility due to contamination. The preferred method of disposal of this material is to use it as a stabilizing material for other projects such as road construction.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Al-Awadhi, N. M., Abdal, M. S., Briskey, E. J., and Kenneth, W. (1992). “Assessment of technologies for the remediation of oil-contaminated soil resulting from exploded oil wells and burning oil fires in Kuwait.”Proc., 85th Annu. Meeting and Exhibition, Air and Waste Mgmt. Assoc., Kansas City, Mo.
2.
Al-Sanad, H., and Eid, W. (1992). “Doha East Power Plant project.”Final Rep., Civ. Engrg. Dept., Kuwait Univ., submitted to the Ministry of Electricity and Water, Kuwait.
3.
Bishop, A. W., and Kenkel, D. J. (1962). The measurements of soil properties in the triaxial test, 2nd Ed., Edward Arnold Ltd., London, England.
4.
Carrigy, M. A. (1967). “The physical and chemical nature of a typical tar sand: bulk properties and behaviour.”Proc., Int. 7th World Petroleum Congress, Vol. 1, 573–581.
5.
Evgin, E., and Das, B. M. (1992). “Mechanical behavior of an oil contaminated sand.”Envir. Geotechnol., Proc., Mediterranean Conf., Usmen and Acar, eds., Balkema Publishers, Rotterdam, The Netherlands, 101–108.
6.
Haunser, H. H., Roll, K. H., and Johnson, P. K. (1957). Perspectives in powder metallurgy: fundamentals methods and applications, Vol. 2, Plenum Press, New York, N.Y., 159.
7.
Ismael, N. F., Jeragh, A. M., Mollah, M. A., and Al-Khalidi, O.(1986). “A study of the properties of surface soils.”Kuwait Geotech. Engrg., 17(1), 67–89.
8.
Kuwait Oil Company. (1991a). Rep. on the clean-up of oil contaminated sand . Kuwait, 1–11.
9.
Kuwait Oil Company. (1991b). Report on the Oil Lakes . Kuwait.
10.
Meegoda, N. J., and Ratnaweera, P.(1994). “Compressibility of contaminated fine grained soils.”Geotech. Testing J., 17(1), 101–112.
11.
Ola, S. A. (1991). Geotechnical properties and behaviour of Nigerian tar sand; engineering geology 30 . Elsevier Science Publishers B.V., Amsterdam, The Netherlands, 325–336.
12.
Slattery, J. C. (1990). Interfacial transport phenomena . Springer-Verlag, New York, N.Y., 1159.
13.
Vesic, A. S.(1973). “Analysis of ultimate loads on shallow foundations.”J. Soil Mech. and Found. Div., ASCE, 99(1), 45–73.
Information & Authors
Information
Published In
Copyright
Copyright © 1995 American Society of Civil Engineers.
History
Published online: May 1, 1995
Published in print: May 1995
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.