Decontamination of Radionuclides from Concrete by Microwave Heating. I: Theory
This article has a reply.
VIEW THE REPLYPublication: Journal of Engineering Mechanics
Volume 129, Issue 7
Abstract
The paper analyzes a proposed scheme of decontamination of radionuclides from concrete structures, in which rapid microwave heating is used to spall off a thin contaminated surface layer. The analysis is split in two parts: (1) the hygrothermal part of the problem, which consists in calculating the evolution of the temperature and pore pressure fields, and (2) the fracturing part, which consists in predicting the stresses, deformations and fracturing. The former is assumed to be independent of the latter, but the latter is coupled to the former. The heat and moisture transfer governing the temperature and pore pressure fields induced by the decontamination process is analyzed using an improved form of Bažant and Thonguthai’s model for heat and moisture transfer in concrete at high temperatures. The rate of the distributed source of heat due to the interaction of microwaves with the water contained in concrete is calculated on the basis of the standing wave normally incident to the concrete wall. Since the microwave time period is much shorter than the time a heating front takes to propagate over the length of microwave, and since concrete is heterogeneous, the ohmic power dissipation rate is averaged over both the time period and the wavelength. The reinforcing bars parallel to the surface are treated as a smeared steel layer. The recently developed microplane model M4 serves as the constitutive model for nonlinear deformation and distributed fracturing of concrete. Application of the present model in numerical computations is relegated to a companion paper which follows.
Get full access to this article
View all available purchase options and get full access to this article.
References
Ahmed, G. N., and Hurst, J. P.(1997). “Coupled heat and mass transport phenomena in siliceous aggregate concrete slabs subjected to fire.” Fire Mater., 21, 161–168.
American Concrete Institute. (ACI). (1994). “Prediction of creep, shrinkage, and temperature effects in concrete structures.” ACI manual of concrete pratice Part 1: Materials and general properties of concrete, ACI 209R-92, Detroit.
Bažant, Z. P.(1972). “Thermodynamics of interacting continuua with surfaces and creep analysis of concrete structures.” Nucl. Eng. Des., 20, 477–505.
Bažant, Z. P. (1975). “Theory of creep and shrinkage in concrete structures: A precis of recent developments.” Mechanics today, S. Nemat-Nasser, ed., Vol. 2, Pergamon, New York, 1–93.
Bažant, Z. P., and Baweja, S. (1995). “Justification and refinement of Model B3 for concrete creep and shrinkage. 1. Statistics and sensitivity.” Materials and structures, Vol. 28, RILEM, Paris, 415–430.
Bažant, Z. P., and Baweja, S. (2000). “Creep and shrinkage prediction model for analysis and design of concrete structures: Model B3—short form.” Adam Neville Symposium: Creep and shrinkage—structural design effects, ACI SP-194, A. Al-Manaseer, ed., American Concrete Institute, Farmington Hills, Mich., 85–100.
Bažant, Z. P., Caner, F. C., Adley, M. D., and Akers, S. A.(2000a). “Fracture rate effect and creep in microplane model for dynamics.” J. Eng. Mech., 126(9), 962–970.
Bažant, Z. P., Caner, F. C., Carol, I., Adley, M. D., and Akers, S. A.(2000b). “Microplane model M4 for concrete I: Formulation with work-conjugate deviatoric stress.” J. Eng. Mech., 126(9), 944–953.
Bažant, Z. P., and Chern, J.(1987). “Stress-induced thermal and shrinkage strains in concrete.” J. Eng. Mech., 113(10), 1493–1511.
Bažant, Z. P., Hauggaard, A. B., Baweja, S., and Ulm, F.(1997). “Microprestress-solidification theory for concrete creep. I: Aging and drying effects.” J. Eng. Mech., 123(11), 1188–1194.
Bažant, Z. P., and Kaplan, M. F. (1996). Concrete at high temperatures, Longman, London.
Bažant, Z. P., and Najjar, L. J. (1972). “Nonlinear water diffusion in nonsaturated concrete.” Materials and Structures, Vol. 5, RILEM, Paris, 3–20.
Bažant, Z. P., and Thonguthai, W.(1978). “Pore pressure and drying of concrete at high temperature.” J. Eng. Mech. Div., Am. Soc. Civ. Eng., 104(5), 1059–1079.
Bažant, Z. P., and Thonguthai, W.(1979). “Pore pressure in heated concrete walls: Theoretical prediction.” Mag. Concrete. Res., 31(107), 67–76.
Bažant, Z. P., and Xi, Y.(1994). “Drying creep of concrete: constitutive model and new experiments separating its mechanisms.” Mater. Struct., 27, 3–14.
Bažant, Z. P., and Zi, G. (2001). “Spatial and temporal scaling of concrete response to extreme environments.” Proc., 3rd Int. Conf., Concrete Under Severe Conditions, N. Banthia, K. Sakai, and O. E. Gjørv, eds., Univ. of British Columbia, Vancouver, BC, 3–10.
Brocca, M., and Bažant, Z. P.(2000). “Microplane model and metal plasticity.” Appl. Mech. Rev., 53(10), 265–281.
Caner, F. C., and Bažant, Z. P.(2000). “Microplane model M4 for concrete II: Algorithm and calibration.” J. Eng. Mech., 126(9), 954–961.
Chapman, A. J. (1987). Fundamentals of heat transfer, Macmillan, New York.
Cheng, D. K. (1983). Field and wave electromagnetics, Addison–Wesley, London.
England, G. L., and Ross, A. D. (1970). “Shrinkage, moisture and pore pressure in heated concrete.” Proc., American Concrete Institute Int. Seminar on Concrete for Nuclear Reactors, West Berlin, Germany, Special Publication No. 34, 883–907.
Felicetti, R., and Gambarova, G.(1998). “Effects of high temperature on the residual compressive strength of high siliceous concretes.” ACI Mater. J., 95(4), 395–406.
Gawin, D., Majorana, C. E., and Schrefler, B. A.(1999). “Numerical analysis of hygrothermal behaviour and damage of concrete at high temperature.” Mech. Cohesive-Frict. Mater., 4, 37–74.
Hansen, W., and Almudaiheem, J. A.(1987). “Ultimate drying shrinkage of concrete-Influence of major parameters.” ACI Mater. J., 84(3), 217–223.
Harmathy, T. Z.(1970). “Thermal properties of concrete at elevated temperature.” J. Mater., 5(1), 47–75.
Harmathy, T. Z., and Allen, L. W.(1973). “Thermal properties of selected masonry unit concrete.” ACI J., 70(15), 132–142.
Hasted, J. B., and Shah, M. A.(1964). “Microwave absorption by water in building materials.” Br. J. Appl. Phys., 15, 825–836.
Hertz, K. (1981). “Microwave heating for fire material testing of concrete—A theoretical study,” Institute of Building Design Rep. No. 144, Technical Univ. of Denmark, Lyngby, Denmark.
Hertz, K. (1983). “Microwave heating for fire material testing of concrete—an experimental study.” Institute of Building Design, Rep. No. 164, Technical Univ. of Denmark, Denmark.
Jones, H. R. N. (2000). Radiation heat transfer, Oxford Univeristy Press, Oxford.
Lagos, L. E., Li, W., and Ebadian, M. A.(1995). “Heat transfer within a concrete slab with a finite microwave heating source.” Int. J. Heat Mass Transf., 38(5), 887–897.
Li, W., Ebadian, M. A., White, T. L., and Grubb, R. G.(1993). “Heat transfer within a concrete slab applying the microwave decontamination process.” J. Heat Transfer, 115, 42–50.
Mainguy, M., Coussy, O., and Baroghel-Bouny, V.(2001). “Role of air pressure in drying of weakly permeable materials.” J. Eng. Mech., 127(6), 582–592.
Meredith, R. J. (1998). Engineer’s handbook of industrial microwave heating, The Institution of Electrical Engineers, London.
Metaxas, R. C., and Meredith, R. J. (1983). Industrial microwave heating, IEEE Power Engineering Series 4, Peter Peregrinus Ltd., Exeter, England.
Moukwa, M., Brodwin, M., Christo, S., Chang, J., and Shah, S. P.(1991). “The influence of the hydration process upon microwave properties of cements.” Cem. Concr. Res., 21, 863–872.
Neville, A. M. (1997). Properties of concrete, 4th Ed, Wiley, New York.
Shah, M. A., Hasted, J. B., and Moore, L.(1965). “Microwave absorption by water in building materials: Aerated concrete.” Br. J. Appl. Phys., 16, 1747–1754.
Spalding, B.(2000). “Volatility and extractability of Strontium-85, Cesium-134, Cobalt-57, and Uranium after heating hardened portland cement paste.” Environ. Sci. Technol., 34, 5051–5058.
Taoukis, P., Davis, E. A., Davis, H. T., Gordon, J., and Talmon, Y.(1987). “Mathematical modeling of microwave thawing by the modified isotherm migration method.” J. Food. Sci., 52(2), 455–463.
Thuéry, J. (1992). Microwaves: industrial, scientific, and medical applications, Artech House, Boston, 104.
Ulm, F.-J., Coussy, O., and Bažant, Z. P.(1999). “The “chunnel” fire I: chemoplastic softening in rapidly heated concrete.” J. Eng. Mech., 125(3), 272–282.
Vodák, F., Černý, R., Drchalová, J., Hošková, Š., Kapičková, O., Michalko, O., Semerák, P., and Toman, J.(1997). “Thermophysical properties of concrete for nuclear-safety related structures.” Cem. Concr. Res., 27(3), 415–426.
von Hippel, A. R. (1954). Dielectric materials and applications, MIT Press, Cambridge, Mass.
Wace, P. F., Harker, A. H., and Hills, D. L. (1989). “Removal of concrete layers from biological shield by microwaves.” Rep. No. EUR 12185, Nuclear Science and Technology, Commission of the European Communities, Brussels, Belgium.
Wait, J. R. (1985). Electromagnetic wave theory, Harper & Row, New York.
Watson, A. (1968a). “Curing of concrete.” Microwave power engineering, E. C. Okress, ed., Vol. 2, Academic, New York.
Watson, A. (1968b). “Breaking of concrete.” Microwave power engineering, E. C. Okress, ed., Vol. 2, Acdemic, New York.
Wei, C. K., Davis, H. T., Davis, E. A., and Gordon, J.(1985). “Heat and mass transfer in water-laden sandstone: microwave heating.” AIChE J., 31(5), 842–848.
White, T. L., Foster, D., Jr., Wilson, C. T., and Schaich, C. R. (1995). “Phase II microwave concrete decontamination results.” ORNL Rep. No. DE-AC05-84OR21400, Oak Ridge National Laboratory, Oak Ridge, Tenn.
Zhukov, V. V., and Schenchenko, V. I. (1974). “Investigation of causes of possible spalling and failure of heat-resistant concretes at drying, first heating and cooling.” Zharostoikie betony (Heat-resistant concretes), K. D. Nekrasov, ed., Stroizdat, Moscow, 32–45.
Zi, G., and Bažant, Z. P.(2001). “Continuous relaxation spectrum for concrete creep and its incorporation into microplane model M4.” J. Eng. Mech., 128(12), 1331–1336.
Zi, G., and Bažant, Z. P.(2003). “Decontamination of radionuclides from concrete by microwave heating. II: Computations.” J. Eng. Mech., 129(7), 785–792.
Information & Authors
Information
Published In
Journal of Engineering Mechanics
Volume 129 • Issue 7 • July 2003
Pages: 777 - 784
Copyright
Copyright © 2003 American Society of Civil Engineers.
History
Received: Mar 12, 2002
Accepted: Oct 29, 2002
Published online: Jun 13, 2003
Published in print: Jul 2003
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.