Bed Shear Stress Boundary Condition for Storage Tank Sedimentation
This article has a reply.
VIEW THE REPLYPublication: Journal of Environmental Engineering
Volume 129, Issue 7
Abstract
Computational fluid dynamics-based (CFD) software tools enable engineers to simulate flow patterns and sediment transport in ancillary structures of sewer systems. Lagrangian particle tracking represents a computationally efficient technique for modeling sediment transport. In order to represent the process of sedimentation in storage tanks, careful consideration must be given to the boundary condition at the bottom of the tanks. None of the boundary conditions currently available in the FLUENT CFD software appears to represent the observed behavior of sediment particles, which may become resuspended after first contact with the bed if the local flow velocity is sufficiently high. In this study, a boundary condition based on bed shear stress has been implemented in FLUENT and evaluated against laboratory data. A particle is trapped if the local bed shear stress is below the critical bed shear stress; otherwise, the particle is resuspended. The approach gives satisfactory agreement with measured sedimentation efficiency data, and the simulated spatial distribution is very similar to the sediment distribution observed in a laboratory tank.
Get full access to this article
View all available purchase options and get full access to this article.
References
Benelmouffok, D. E., and Yu, S. L.(1989). “Two-dimensional numerical modeling of hydrodynamics and pollutant transport in a wet detention pond.” Water Sci. Technol., 21, 727–738.
Calabrese, R. V., and Middleman, S.(1979). “The dispersion of discrete particles in a turbulent fluid field.” AIChE J., 25(6), 1025–1035.
Domgin, J. F., Huilier, D., Burnage, H., and Gardin, P.(1997). “Coupling of a Lagrangian model with a CFD code: Application to the numerical modeling of the turbulent dispersion of droplets in a turbulent pipe flow.” J. Hydraul. Res., 35(4), 473–489.
FLUENT (1997). Fluent user’s guide-version 4.4, Fluent Inc., Lebanon, NH.
Foundation for Water Research (FWR). (1998). Urban pollution management (UPM) manual, UK.
German, J., and Kant, H. (1998). “FEM-analys av strömningsförhållanden i en dagvattendamm (FEM-analysis of the hydraulic conditions in a stormwater detention pond)” Vatten, No. 54, 183–190 (in Swedish).
Luyckx, G., Vaes, G., and Berlamont, J.(1999). “Experimental investigation on the efficiency of a high side weir overflow.” Water Sci. Technol., 39(2), 61–68.
Morsi, S. A., and Alexander, A. J.(1972). “An investigation of particle trajectories in two-phase flow systems.” J. Fluid Mech., 55(2), 193–208.
Olsen, N. R. B., and Skoglund, M.(1994). “Three-dimensional numerical modeling of water and sediment flow in a sand trap.” J. Hydraul. Res., 32(6), 833–843.
Pettersson, T. J. R.(1997). “FEM-modeling of open stormwater detention ponds.” Nord. Hydrol., 28(4/5), 339–350.
Stovin, V. R. (1996). “The prediction of sediment deposition in storage chambers based on laboratory observations and numerical simulation.” PhD thesis, Univ. of Sheffield, UK.
Stovin, V. R. (2000). “The development of a simulation strategy for the prediction of sediment deposition in storage chambers.” Final report to the Engineering and Physical Science Research Council (EPSRC), GR/L79205, Swindon, UK. 〈http://www.shef.ac.uk/uni/projects/ssc/〉
Stovin, V. R., and Saul, A. J.(1998). “A Computational fluid dynamics (CFD) particle tracking approach to efficiency prediction.” Water Sci. Technol., 37(1), 285–293.
Stovin, V. R., and Saul, A. J.(2000). “Computational fluid dynamics and the design of sewage storage chambers.” J.CIWEM, 14(2), 103–110.
Ta, C. T. (1999). “Computational fluid dynamic model of storm tank.” Proc., 8th Int. Conf. Urban Storm Drainage, Sydney, Australia, Vol. 3, 1279–1286.
Thomson, D. J.(1987). “Criteria for the selection of stochastic models of particle trajectories in turbulent flows.” J. Fluid Mech., 180, 529–556.
Wilkinson, D., and Waldie, B.(1994). “CFD and experimental studies of fluid and particle flow in horizontal primary separators.” Trans. Inst. Chem. Eng., Part A, 72(A), 189–196.
Wu, W., Rodi, W., and Wenka, T.(2000) “3D numerical modeling of flow and sediment transport in open channels.” J. Hydraul. Eng., 126(1), 4–15.
Information & Authors
Information
Published In
Copyright
Copyright © 2003 American Society of Civil Engineers.
History
Received: Jul 23, 2001
Accepted: Sep 13, 2002
Published online: Jun 13, 2003
Published in print: Jul 2003
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.