Selection of Pumping Configuration for Closed Water Distribution Systems
Publication: Journal of Water Resources Planning and Management
Volume 142, Issue 6
Abstract
This paper provides an insight into the selection of the most suitable configuration for closed distribution systems (i.e., systems with no storage capacity). The analysis is developed considering a wide ranges of operational scenarios in terms of flows and required heads. For each scenario, various design configurations are considered and compared. Results show that using more than a minimum of pumps can have lower operational and total costs thanks to the pumps operating closer to their best efficiency point. Small additional benefits in terms of operational and total costs may be obtained as a result of the introduction of the variable speed drive in at least one of the station pumps. Similar costs are obtained in the configuration where large pumps are flanked by a small jockey pump operating at low demand times. The design solution made up of large pumps fitted with a downstream hydropneumatic tank also represents a valid alternative option from the economical viewpoint for small flows.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors would like to thank the reviewers for their helpful comments on the initial submittal of the paper.
References
AWWA (American Water Works Association). (2015). “Energy management for water utilities.” Denver.
GLUMRB (Great Lakes and Upper Mississippi River Board of State Public Health and Environmental Managers). (1992). “Recommended standards for water works.” Albany, NY.
Leiby, V., and Burke, M. (2011). Energy efficiency best practices for North American drinking water utilities, Water Research Foundation, Denver.
U.S. EPA. (2009). “Ensuring a sustainable future: An energy management guidebook for wastewater and water utilities.”, U.S. Environmental Protection Agency Office of Wastewater Management, Cincinnati.
Walski, T. M. (2001). “Don’t forget energy cost when selecting pumps.” AWWA Annual Conf., AWWA, Denver.
Walski, T. M. (2011). “Practical tips for reducing energy use.” Computing and Controls in the Water Industry, Univ. of Exeter, U.K.
Walski, T. M. (2012). “Planning-level capital cost estimates for pumping.” J. Water Resour. Plann. Manage., 307–310.
Walski, T. M., Hartell, W., and Wu, Z. Y. (2010). “Developing system head curves for closed systems.” J. Am. Water Works Assoc., 102(9), 84–89.
Walski, T. M., Sharkey, M., and Pflanz, M. (2011). “What happens when your pump loses power?” AWWA Distribution Symp., AWWA, Denver.
Walski, T. M., Wu, Z. Y., and Bowdler, D. (2006). “Finding thieves in your water system.” AWWA Annual Conf., AWWA, Denver.
Water Environment Federation (WEF). (2009). “Energy conservation in water and wastewater facilities.” Alexandria, VA.
WaterGEMS [Computer software]. Bentley Systems, Exton, PA.
Information & Authors
Information
Published In
Copyright
© 2016 American Society of Civil Engineers.
History
Received: Apr 1, 2015
Accepted: Nov 9, 2015
Published online: Jan 21, 2016
Published in print: Jun 1, 2016
Discussion open until: Jun 21, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.