The Challenge of Air Valves: A Selective Critical Literature Review
Publication: Journal of Water Resources Planning and Management
Volume 141, Issue 10
Abstract
One key alternative for removing, preventing, and effectively coping with the often vexing presence of air in water pipelines is the combination air-vacuum valve. Despite their often effective role, such valves can be highly problematic if not well designed and maintained. This paper critically reviews the current design, application, functionality, and simulation of air valves and the associated shortcomings, with a primary focus on air/vacuum valves (AVVs). It is argued that the efficient number of air valves along undulating pipelines is yet to be fully articulated. Air-valve simulations should expressively consider their dynamic behavior, the physical behavior of any air pockets that might form below an air valve, and the varying character of the water surface at the air valve location. There is a pressing need for a comprehensive and systematic study on the proper sizing and location of AVVs for the transient protection of systems. Overall, the efficient application of AVVs requires broad research and development theoretically (i.e., their physical behavior and improved numerical simulations) and experimentally, as well as field studies to document their in situ dynamic behavior and operational efficiency.
Get full access to this article
View all available purchase options and get full access to this article.
References
Arregui, F. J., et al. (2003). Air valves dynamic behavior, ITA, Universitat Polytecnica Valencia, Valencia, Spain.
AWWA (American Water Works Association). (2001). Manual of water supply practices—M51: Air-release, air-vacuum, and combination air valves, 1st Ed., Denver.
Bergant, A., Bournaski, E., Arregui, F., and Kruisbrink, A. (2004). “Column separation measurements in a large-scale experimental apparatus.” Proc., 9th Int. Conf. on Pressure Surge Analysis for Design and Operation, BHR Group, Bedfordshire, U.K., 589–604.
Bergant, A., Kruisbrink, A., and Arregui, F. (2012). “Dynamic behaviour of air valves in a large-scale pipeline apparatus.” J. Mech. Eng., 58(4), 225–237.
Besner, M. C., et al. (2010). “Negative pressures in full-scale distribution system: Field investigation, modelling, estimation of intrusion volumes and risk for public health.” Drinking Water Eng. Sci., 3(2), 101–106.
Bianchi, A., Mambretti, S., and Pianta, P. (2007). “Practical formulas for the dimensioning of air valves.” J. Hydraul. Eng., 1177–1180.
Cabrera, E., Fuertes, V. S., García-Serra, J., Arregui, F., Gascón, L., and Palau, V. (2003). “Reviewing air valves selection.” Proc., Pumps, Electromechanical Devices and Systems Applied to Urban Water Management, A. A. Balkema, Lisse, Netherlands, 633–640.
Carlos, M., Arregui, F. J., Cabrera, E., and Palau, C. V. (2011). “Understanding air release through air valves.” J. Hydraul. Eng., 461–469.
Collins, R. P., Boxall, J. B., Karney, B. W., Brunone, B., and Meniconi, S. (2012). “How severe can transients be after a sudden depressurization?” J. Am. Water Works Assoc., 104(4), E243–E251.
De Martino, G., Fontana, N., and Giugni, M. (2008). “Transient flow caused by air expulsion through an orifice.” J. Hydraul. Eng., 1395–1399.
Devine, J. G., and Creasey, J. D. (1997). “Surge suppression: Care at all stages.” J. Chartered Inst. Water Environ. Manage., 11(5), 341–345.
DVGW (German Technical and Scientific Association for Gas and Water). (2005). “Dynamic pressure variations in water supply systems.”, Wirtschafts- und Verlagsgesellschaft Gas und Wasser mbH, Bonn, Germany.
Escarameia, M. (2005). Air problems in pipelines, a design manual, HR Wallington, Oxfordshire, U.K.
Espert, V. B., García-Serra, J., and Koelle, E. (2008). “The use of air valves as protection devices in pressure hydraulic transients.” Proc., Surge Analysis-System Design, Simulation, Monitoring and Control, 10th Int. Conf. on Pressure Surges, BHR Group, Bedfordshire, U.K., 183–197.
European Commission. (1997). “European Pressure Equipment Directive.”, Official Journal of the European Communities, L181(1), 〈http://ec.europa.eu/enterprise/sectors/pressure-and-gas/documents/ped/〉.
Gregory, J., Henry, P. E., and Aaron, N. D. (2006). “Meeting the standard—Air release valve and PCCP rehabilitation.” Proc., Pipeline Division Specialty Conf., ASCE, Reston, VA, 49–56.
Lee, T. S. (1999). “Air influence on hydraulic transients on fluid system with air valves.” J. Fluids Eng., 121(3), 646–650.
Lee, T. S., and Leow, L. C. (1999). “Numerical study on the effects of air valve characteristics on pressure surges during pump trip in pumping systems with air entrainment.” Int. J. Numer. Methods Fluids, 29(6), 645–655.
Li, G., Baggett, C. C., and Rosario, R. A. (2009). “Air/vacuum valve breakage caused by pressure surges—Analysis and solution.” Proc., World Environmental and Water Resources Congress: Great Rivers, ASCE, Reston, VA, 112–121.
Lingireddy, S., Wood, D. J., and Zloczower, N. (2004). “Pressure surges in pipeline systems resulting from air releases.” J. Am. Water Works Assoc., 96(7), 88–94.
Lubbers, C. L. (2007). “On gas pockets in wastewater pressure mains and their effect on hydraulic performance.” Ph.D. thesis, Delft Univ. of Technology, Delft, Netherlands.
Lubbers, C. L., and Clemens, F. H. L. R. (2005). “Capacity reduction caused by air intake at wastewater pumping stations.” Proc., Water and Wastewater Pumping Stations Conf., BHR Group, Cranfield, U.K., 119–131.
Lucca, Y. F. L. D., Aquino, G. A., and Filho, J. G. D. (2010). “Experimental apparatus to test air trap valves.” IOP Conf. Series: Earth and Environmental Science, Vol. 12, Institute of Physics Publishing (IOP), Great Britain.
Martin, C. S., and Lee, N. (2012). “Measurement and rigid column analysis of expulsion of entrapped air from a horizontal pipe with an exit orifice.” Proc., 11th Int. Conf. on Pressure Surges, BHR Group, Cranfield, U.K., 527–542.
Martin, C. S., and Lee, N. H. (2000). “Rapid expulsion of entrapped air through an orifice.” Proc., 8th Int. Conf. on Pressure Surges-Safe Design and Operation of Industrial Pipe Systems, BHR Group, Cranfield, U.K.
McPherson, D. L. (2009). “Air valve sizing and location: A prospective.” Proc., Pipeline Division Int. Conf. Pipelines 2009: Infrastructure’s Hidden Assets, Curran Associates, San Diego, 905–919.
McPherson, D. L., and Haeckler, Ch. (2012). “Untangling the mysteries of air valves.” Proc., Pipeline Division Int. Conf. Pipelines 2012: Innovations in Design, Construction, Operations, and Maintenance—Doing More with Less, R. J. Card and M. K. Kenny, eds., ASCE, Reston, VA, 983–989.
Pothof, I. W. M., and Clemens, F. H. L. R. (2010). “On elongated air pockets in downward sloping pipes.” J. Hydraul. Res., 48(4), 499–503.
Radulj, D. (2007). “The role of air valves in water distribution systems.” B.Sc. thesis, Univ. of Toronto, Toronto.
Ramezani, L., and Karney, B. (2013). “Water column separation and cavity collapse for pipelines protected with air vacuum valves: Understanding the essential wave processes.” Hydraulic Surge and Air Control Symp. Number 1, A.R.I Flow Control Accessories, Kibbutz Kfar Charuv, Israel.
Stephenson, D. (1997). “Effects of air valves and pipework on water hammer pressures.” J. Transp. Eng., 101–106.
Tchobanoglous, G., and Metcalf, E. (1981). Wastewater engineering: Collection and pumping of wastewater, 3rd Ed., McGraw-Hill College, New York.
Thomas, S. (2003). Air management in water distribution systems: A new understanding of air transfer, Clear Water Legacy, Burlington, ON, Canada.
Tukker, M., Kooij, K., and Pothof, I. (2013). Hydraulic design and management of wastewater transport systems CAPWAT manual, Stichting Deltares, Netherlands.
Wylie, E. B., and Streeter, V. L. (1993). Fluid transient in systems, Prentice-Hall, Englewood Cliffs, NJ.
Yang, K. L., and Shi, W. X. (2005). “Control of pipeline hydraulic transients in south to north water transfer project.” Shuili Xuebao/J. Hydraul. Eng., 36(10), 1176–1182.
Zhou, F., Hicks, F., and Steffler, P. (2004). “Analysis of effect of air pocket on hydraulic failure of urban drainage infrastructure.” Can. J. Civ. Eng., 31(1), 86–94.
Zhou, F., Hicks, F. E., and Steffler, P. M. (2002a). “Observations of air–water interaction in a rapidly filling horizontal pipe.” J. Hydraul. Eng., 635–639.
Zhou, F., Hicks, F. E., and Steffler, P. M. (2002b). “Transient flow in a rapidly filling horizontal pipe containing trapped air.” J. Hydraul. Eng., 625–634.
Zhu, M., Zhang, X., Zhang, Y., and Wang, T. (2006). “Study on water hammer prevention in pumping water supply systems by multi-valves.” Proc., Int. Conf. on Hybrid Information Technology, IEE Computer Society Press, Los Alamitos, 342–346.
Zloczower, N. (2010). “Reduction of damage and hindrance to wastewater transmission systems caused by air pockets by deployment of air valves.” Proc., Pipelines 2010: Climbing New Peaks to Infrastructure Reliability—Renew, Rehab, and Reinvest, ASCE, Reston, VA, 449–462.
Information & Authors
Information
Published In
Journal of Water Resources Planning and Management
Volume 141 • Issue 10 • October 2015
Copyright
© 2015 American Society of Civil Engineers.
History
Received: Aug 15, 2014
Accepted: Jan 30, 2015
Published online: Mar 18, 2015
Discussion open until: Aug 18, 2015
Published in print: Oct 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.