Abstract
Network model detail can influence the accuracy of results from analyses of water distribution systems. Previous work has shown the limitations of skeletonized network models when considering water quality and hydraulic effects. Loss of model detail is potentially less important for aggregated effects such as the systemwide health effects associated with a contamination event, but has received limited attention. The influence of model detail on such effects is examined here by comparing results obtained for contamination events using three large network models and several skeletonized versions of the models. Loss of model detail decreases the accuracy of estimated aggregated adverse effects related to contamination events. It has the potential to have a large negative influence on the results of consequence assessments and the design of contamination warning systems. However, the adverse influence on analysis results can be minimized by restricting attention to high percentile effects (i.e., 95th percentile or higher).
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The U.S. Environmental Protection Agency’s (EPA’s) Office of Research and Development funded, managed, and participated in the research described here under an interagency agreement. The views expressed in this paper are those of the authors and do not necessarily reflect the views or policies of EPA. Mention of trade names or commercial products does not constitute endorsement or recommendation for use. Work at Argonne National Laboratory was sponsored by the EPA under an interagency agreement through U.S. Department of Energy Contract DE-AC02-06CH11357.
Disclaimer
Because the information is confidential, the identity of the WDSs used in this paper or any information that could be used to identify them cannot be disclosed.
References
Bahadur, R., Johnson, J., Janke, R., and Samuels, W. B. (2008). “Impact of model skeletonization on water distribution model parameters as related to water quality and contaminant consequence assessment.” 8th Annual Water Distribution System Analysis Symp., ASCE, Reston, VA.
Berry, J., Boman, E., Riesen, L. A., Hart, W. E., Phillips, C. A., and Watson, J.-P. (2012). “User’s manual TEVA-SPOT Toolkit 2.5.2.”, National Homeland Security Research Center, Office of Research and Development, U.S. Environmental Protection Agency, Cincinnati, OH.
Black, W. R. (2003). Transportation: A geographical analysis, The Guilford Press, New York, 78.
Blokker, E. J. M., Vreeburg, J. H. G., Buchberger, S. G., and van Dijk, J. C. (2008). “Importance of demand modelling in network water quality models: A review.” Drink. Water Eng. Sci., 1(1), 27–38.
Davis, M. J., and Janke, R. (2008). “Importance of exposure model in estimating impacts when a water distribution system is contaminated.” J. Water Resour. Plann. Manage., 449–456.
Davis, M. J., and Janke, R. (2009). “Development of a probabilistic timing model for the ingestion of tap water.” J. Water Resour. Plann. Manage., 397–405.
Davis, M. J., and Janke, R. (2011). “Patterns in potential impacts associated with contamination events in water distribution systems.” J. Water Resour. Plann. Manage., 1–9.
Davis, M. J., Janke, R., and Magnuson, M. L. (2013). “A framework for estimating the adverse health effects of contamination events in water distribution systems and its application.” Risk Anal., 498–513.
Eggener, C. L., and Polkowski, L. B. (1976). “Network models and the impact of modeling assumptions.” J. Am. Water Works Assoc., 68(4), 189–196.
Giustolisi, O., Laucelli, D., Beradi, L., and Savić, D. A. (2012). “Computationally efficient modeling method for large water network analysis.” J. Hydraul. Eng., 313–326.
Grayman, W. M., Males, R. M., and Clark, R. M. (1991). “The effects of skeletonization on distribution system modeling.” Proc. AWWA Conf. on Computers in the Water Industry, American Water Works Association, Denver, CO, 661–684.
Grayman, W. M., and Rhee, H. (2000). “Assessment of skeletonization in network models.” Proc. ASCE Water Resource Engineering and Water Resources Planning and Management Conf., ASCE, Reston, VA.
Innovyze. (2005). Infowater skeletonizer: Users guide, Pasadena, CA.
Janke, R., et al. (2009). “Sensor network design and performance in water systems dominated by multi-story buildings.” Proc. World Environ. and Water Resources Congress 2009, ASCE, Reston, VA.
Janke, R., Murray, R., Uber, J., Bahadur, R., Taxon, T., and Samuels, W. (2007). “Using TEVA to assess impact of model skeletonization on contaminant consequence assessment and sensor placement design.” Proc. World Environ. and Water Resources Congress 2007, ASCE, Reston, VA.
Jung, B. S., Boulos, P. F., and Wood, D. J. (2007). “Pitfalls of water distribution model skeletonization for surge analysis.” J. Am. Water Works Assoc., 99(12), 87–98.
Klise, K. A., Phillips, C. A., and Janke, R. J. (2013). “Two-tiered sensor placement for large water distribution network models.” J. Infrastruct. Syst., 465–473.
Martinez Alzamora, F., Ulanicki, B., and Salomons, E. (2014). “Fast and practical method for model reduction of large-scale water-distribution networks.” J. Water Resour. Plann. Manage., 444–456.
Perelman, L., and Ostfeld, A. (2008). “Water distribution system aggregation for water quality analysis.” J. Water Resour. Plann. Manage., 303–309.
Perelman, L., Maslia, M. L., Ostfeld, A., and Sautner, J. B. (2008). “Using aggregation/skeletonization network models for water quality simulations in epidemiologic studies.” J. Am. Water Works Assoc., 100(6), 122–133.
Rossman, L. A. (2000). “EPANET 2 users manual.”, National Risk Management Research Laboratory, Office of Research and Development, U.S. Environmental Protection Agency, Cincinnati, OH.
Shang, F., Uber, J. G., and Rossman, L. A. (2008). “Modeling reaction and transport of multiple species in water distribution systems.” Environ. Sci. Technol., 42(3), 808–814.
Simpson, A., Elhay, S., and Alexander, B. (2014). “Forest-core partitioning algorithm for speeding up analysis of water distribution systems.” J. Water Resour. Plann. Manage., 435–443.
U.S. EPA (U.S. Environmental Protection Agency). (2000). “Estimated per capita water ingestion in the United States.”, Office of Water, U.S. EPA, Washington, DC.
U.S. EPA. (2004). “Estimated per capita water ingestion and body weight in the United States—An update.”, Office of Water, Washington, DC.
U.S. EPA. (2012). “Threat ensemble vulnerability assessment—Sensor placement optim1ization tool (TEVA-SPOT) graphical user interface user’s manual.” Version 2.3.1, National Homeland Security Research Center, Office of Research and Development, Cincinnati, OH.
Walski, T. M., Chase, D. V., Savic, D. A., Grayman, W., Beckwith, S., and Koelle, E. (2003). Advanced water distribution modeling and management, Haestad Press, Waterbury, CT.
Watson, J., Murray, R., and Hart, W. (2009). “Formulation and optimization of robust sensor placement problems for drinking water contamination warning systems.” J. Infrastruct. Syst., 330–339.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Jul 25, 2013
Accepted: Jan 21, 2014
Published online: Jan 22, 2014
Discussion open until: Nov 23, 2014
Published in print: Jan 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.