Effectiveness of Temporary Rumble Strips in Alerting Motorists in Short-Term Surveying Work Zones
Publication: Journal of Transportation Engineering
Volume 141, Issue 10
Abstract
Many surveyors who work in/near live traffic encounter unique safety challenges as they are frequently exposed to fast moving vehicles. Unlike traditional work zones, safety countermeasures at surveying sites are usually limited to advanced-warning signs, traffic cones and reflective safety vests. As a result, motorists may not be well alerted for the presence of surveyors. Because of the unique safety challenges encountered by surveyors and the motorists, this study aims to quantify the effectiveness of using temporary rumble strips, as a potential safety countermeasure in enhancing safety at surveying work sites. A type of portable plastic rumble strip (PPRS) was tested at eight land surveying sites in New Jersey. The effectiveness of PPRS was evaluated based on selected surrogate measures of effectiveness (SMOE) that were extracted from the video data recorded during the 2-h field test at each site. Statistically significant reductions in driving speed and speeding proportion, and increases in braking rate were found when the rumble strips were deployed during the field tests. These observed changes suggest that the deployment of PPRS can be a useful countermeasure to increase motorists’ awareness at land surveying sites. The findings can serve as a reference for practitioners when deploying temporary and portable traffic control device in these unique short-term work zones.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors thank the New Jersey Department of Transportation (NJDOT) for coordinating the field tests with their survey crews. The authors also appreciate Dr. Eren Erman Ozguven, Florida A&M University-Florida State University; Mr. Ender Faruk Morgul, New York University; Dr. Jian Li, Tongji University, and Mr. Hassan Hashmi, New Jersey Institute of Technology who helped with the collection and processing of field data at various stages of this study. The contents of this paper reflect views of the authors who are responsible for the facts and accuracy of the data presented herein. The contents of the paper do not necessarily reflect the official views or policies of the sponsoring agencies. The authors also appreciate the valuable comments and suggestions of the anonymous reviewers and the journal editors that greatly helped improve the paper.
References
Bernhardt, K. L. S., Virkler, M. R., and Shaik, N. M. (2001). “Evaluation of supplementary traffic control measures for freeway work-zone approaches.”, Transportation Research Board, Washington, DC.
FHWA. (2009). “Manual on uniform traffic control devices (MUTCD).” Federal Highway Administration, U.S. Dept. of Transportation, Washington, DC.
Fontaine, M. D. (2002). “Innovative traffic control devices to improve safety at rural short-term maintenance work zones.” Making Work Zones Work Better Workshop, Federal Highway Administration and Maryland State Highway Administration, College Park, MD.
Fontaine, M. D., and Carlson, P. J. (2001). “Evaluation of speed displays and rumble strips at rural-maintenance work zones.”, Transportation Research Board, Washington, DC.
Garber, N. J., and Gadiraju, R. (1988). Speed variance and its influences on accidents, Univ. of Virginia, Charlottesville, VA.
Heaslip, K., Schrock, S. D., Wang, M.-H., Rescot, R., Bai, Y., and Brady, B. (2010). “A closed-course feasibility analysis of temporary rumble strips for use in short-term work zones.” J. Transp Safety Secur., 2(4), 299–311.
Hildebrand, E. D., Wilson, F. R., and Copeland, J. J. (2003). “Speed management strategies for rural temporary work zone.” Proc., Canadian Multidisciplinary Road Safety Conf. XIII, Canadian Association of Road Safety Professionals, Ottawa.
Homburger, W. S., Hall, J. W., Loutzenheiser, R. C., and Reilly, W. R. (1996). “Spot speed studies.” Fundamentals of traffic engineering, Institute of Transportation Studies, Univ. of California, Berkeley, CA, 6.1–6.9.
Leaf, W. A., and Preusser, D. F. (1999). “Literature review on vehicle travel speeds and pedestrian injuries.”, National Highway Traffic Safety Administration, Washington, DC.
McAvoy, D. S., Savolainen, P. T., Reddy, V., Pinapaka, S. V., Santos, J. B., and Datta, T. K. (2009). “Evaluation of temporary removable rumble strips for speed reduction.” TRB 88th Annual Meeting Compendium of Papers DVD, Transportation Research Board, Washington, DC.
Meyer, E. (2000). “Evaluation of orange removable rumble strips for highway work zones.”, Transportation Research Board, Washington, DC.
NJDOT (New Jersey Department of Transportation). (2000). New Jersey DOT survey manual, Bureau of Civil Engineering, Office of Survey Services, New Jersey Dept. of Transportation, Trenton, NJ.
Peden, M., et al. (2004). World report on road traffic injury prevention, World Health Organization, Geneva.
PPS (Plastic Safety System). (2012). Temporary portable rumble strips, Cleveland.
Schrock, S. D., Heaslip, K., Wang, M.-H., Jasrotia, R., Rescot, R., Brady, B. (2010a). “Closed course testing of portable rumble strips to improve truck safety at work zones.”, Univ. of Kansas, Lawrence, KS.
Schrock, S. D., Heaslip, K. P., Wang, M.-H., Jasrotia, R., Rescot, R. (2010b). “Closed-course test and analysis of vibration and sound generated by temporary rumble strips for short-term work zones.”, Transportation Research Board, Washington, DC.
Sun, C., Edaram, P., and Ervin, K. (2011a). “Elevated-risk work zone evaluation of temporary rumble strips.” J. Transp. Safety Secur., 3(3), 157–173.
Sun, C., Edaram, P., and Ervin, K. (2011b). “Low-volume highway work zone evaluation of temporary rumble strips.” TRB 90th Annual Meeting Compendium of Papers DVD, Transportation Research Board, Washington, DC.
Walton, S., and Meyer, E. (2002). “The effect of rumble strip configuration on sound and vibration levels.” ITE J., 72(12), 28–32.
Wang, M.-H., Schrock, S. D., Bai, Y., and Rescot, R. (2011a). “Evaluation of innovative traffic safety devices at short-term work zones.”. Univ. of Kansas, Lawrence, KS.
Wang, M.-H., Schrock, S. D., Rescot, R., and Bornheimer, C. (2011b). “Evaluation of portable plastic rumble strips at short-term maintenance work zones.” TRB 90th Annual Meeting Compendium of Papers DVD, Transportation Research Board, Washington, DC.
Yang, H., Bartin, B., Ozbay, K., and Chien, S. I. -J. (2014). “Investigating motorists’ behaviors in response to supplementary traffic control devices at land surveying work sites.” Traffic Inj. Prev., 15(4), 424–430.
Zech, W. C., Mohan, S., and Domochowski, J. (2005). “Evaluation of rumble strips and police presence as speed control measures in highway work zones.” Pract. Period. Struct. Des. Constr., 267–275.
Information & Authors
Information
Published In
Copyright
© 2015 American Society of Civil Engineers.
History
Received: Aug 21, 2014
Accepted: Apr 10, 2015
Published online: Jun 10, 2015
Published in print: Oct 1, 2015
Discussion open until: Nov 10, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.