Modeling the Behavior of Steel-Fiber Reinforced Concrete Ground Slabs. II: Development of Slab Model
This article is a reply.
VIEW THE ORIGINAL ARTICLEPublication: Journal of Transportation Engineering
Volume 137, Issue 12
Abstract
Steel-fiber reinforced concrete (SFRC) brings favorable properties to concrete pavements. The use of the material is limited by the lack of an appropriate analysis method. This paper is the second in a series of two aimed at providing a modeling approach, which can be used to model the behavior of SFRC concrete and SFRC ground slabs. In this paper, a finite-element model, capable of simulating the nonlinear behavior of the SFRC slab, is proposed and compared with the slab’s experimental response. An approximate model describing the behavior of the support layers is developed using results from a plate-bearing test. The same support model is adopted for the analysis of the combined structure of the slab and the support. The material model developed and tested in the first paper, for the SFRC containing of steel fiber, is adopted for the analysis of the SFRC slabs. In addition, a parameter study is conducted to investigate the influence of concrete strength, steel-fiber content, and the support stiffness on the load displacement () response of SFRC ground slabs.
Get full access to this article
View all available purchase options and get full access to this article.
References
American Concrete Institute (ACI) Committee 523. (2000). “Guide for cast-in-place low density concrete.” ACI Manual of Concrete Practice: Part 5. ACI 523. IR-92.
Barros, J. A. O., and Figuieras, J. A. (2001). “Model for the analysis of steel fiber reinforced concrete slabs on grade.” Comput. Struct., 79(1), 97–106.
Beckett, D. (1990). “Comparative test on plain, fabric reinforced, and steel fiber reinforced concrete ground slabs.” Concrete, 24(3), 43–45.
Bekaert. (1998). “Why Dramix steel fiber reinforced concrete for floors.” Brussels, Belgium.
Bekaert. (1999). “Dramix steel fibers for the precast industry.” Brussels, Belgium.
Bischoff, P. H., Valsangkar, A. J., and Irving, J. A. (1996). “Experimental study of concrete floor slabs on grade.” Proc., Canadian Soc. for Civil Engineering Annual Conf., Vol. IIa, Montréal, 273–282.
Bischoff, P. H., Valsangkar, A. J., and Irving, J. (2003). “Use of fibers and welded-wire reinforcement in construction of slabs on ground.” Pract. Period. Struct. Des. Constr., 8(1), 41–46.
Chen, S. (2004). “Strength of steel fiber reinforced concrete ground slabs.” Proc., ICE Struct. Build., 157(2), 157–163.
Chen, W. F. (1982). Plasticity in reinforced concrete, 1st Ed., McGraw-Hill, New York.
Elsaigh, W. A. (2001). “Steel fiber reinforced concrete ground slabs.” M.Eng. dissertation, Univ. of Pretoria, Pretoria, South Africa.
Elsaigh, W. A. (2007). “Modeling the behavior of steel fiber reinforced concrete ground slabs.” Ph.D. dissertation, Univ. of Pretoria, Pretoria, South Africa.
Elsaigh, W. A., and Kearsley, E. P. (2006). “Effect of matrix strength on performance of steel fiber reinforced concrete.” Proc., 3rd Young Concrete Engineers’ Practitioners’ and Technologists’ Conf., Midrand, South Africa.
Elsaigh, W. A., Kearsley, E. P., and Robberts, J. M. (2005). “Steel fiber reinforced concrete for road pavement applications.” Proc., 24th Annual Southern African Transport Conf., Pretoria, South Africa.
Falkner, H., Huang, Z., and Teutsch, M. (1995a). “Comparative study of plain and steel fiber reinforced concrete ground slabs.” Concr. Int., 17(1), 45–51.
Falkner, H., Huang, Z., and Teutsch, M. (1995b). Untersuchung des Trag-und Verformungsverhaltens von Industriefußböden aus Stahlfaserbeton, Heft No. 117, Institut Für Baustoffe, Massivbau und Brandschutz (IBMB), Braunschweig, Germany (in German).
Gehring, D. (1982). “Steel fiber concrete saves $1 m.” Int. Construct., 21(3), 19–20.
Grondziel, M. (1989). “Restoration of concrete floors with steel-fiber concrete for aircraft at Frankfurt airport.” Proc., Int. Conf. on Recent Developments in Fiber Reinforced Cements and Concrete, R. N. Swamy and B. Barr, eds., Elsevier Science Publishers, Oxford, UK, 610–619.
Hoff, G. C. (1985). “Use of steel fiber reinforced concrete in bridge decks and pavements.” Proc., Steel Fiber Concrete US-Sweden Joint Seminar (NSF-STU), Swedish Cement and Concrete Research Institute, Stockholm, Sweden, 67–108.
Holcim. (2006). Holcim material handbook, 2nd Ed., Johnson Heydenberg Afrika, Holcim, South Africa.
Johnston, C. D. (1984). “Steel fiber reinforced concrete pavement trials.” Concr. Int.: Des. Constr., 6(12), 39–43.
Kupfer, H., Hilsdorf, H. K., and Rusch, H. (1969). “Behavior of concrete under biaxial stresses.” J. Am. Concr. Inst., 66(8), 656–666.
Lankard, D. R., and Newell, J. K. (1978). “Preparation of highly reinforced steel fiber reinforced concrete composites.” Proc., Int. Symp., American Concrete Institute, Detroit, 287–304.
Losberg, A. (1978). “Pavements and slabs on grade with structurally active reinforcement.” J. Am. Concr. Inst., 75(12), 647–657.
Meda, A., and Plizzari, G. A. (2004). “New design approach for steel fiber-reinforced concrete slab-on-ground based on fracture mechanics.” ACI Struct. J., 101(3), 298–303.
Meyerhof, G. G. (1962). “Load carrying capacity of concrete pavements.” J. Soil Mech. Found. Div., 88(3), 89–116.
MSC.Marc [Computer software]. MSC, Santa Ana, CA.
Nemegeer, D. (1996). “Design guidelines for Dramix steel wire fiber reinforced concrete.” Indian Concr. J., 70(10), 575–584.
Parker, F., Jr., and Rice, J. L. (1977). “Steel fibrous concrete for airport pavements.” Proc., Int. Conf. on Concrete Pavement Design, Purdue Univ., West Lafayette, IN, 541–555.
Rao, K. S. S., and Singh, S. (1986). “Concentrated load-carrying capacity of concrete slabs on ground.” J. Struct. Eng., 112(12), 2628–2645.
Schrader, E. K. (1985). “Fiber reinforced concrete pavements and slabs (a state-of-the-art report).” Proc., Steel Fiber Concrete US-Sweden Joint Seminar (NSF-STU), Swedish Cement and Concrete Research Institute, Stockholm, Sweden, 109–131.
Theyse, H. L., De Beer, M., and Rust, F. C. (1996). “Overview of the South African mechanistic pavement design analysis method.” Transportek, CSIR, DP-96/005, Pretoria, South Africa.
Vandewalle, M. (1990). “The use of steel fiber reinforced concrete in heavy duty port pavements.” Proc., 6th Int. Symp. on Concrete Roads: Theme B, Madrid, Spain, 121–128.
Verhoeven, K. (1989). “Thin overlays of steel fiber reinforced concrete and continuously reinforced concrete: State-of-the-art in Belgium.” Proc., 4th Int. Conf. on Concrete Pavement Design and Rehabilitation, Purdue Univ., West Lafayette, IN, 205–219.
Information & Authors
Information
Published In
Copyright
© 2011 American Society of Civil Engineers.
History
Received: Jun 26, 2010
Accepted: Jun 29, 2011
Published online: Jul 1, 2011
Published in print: Dec 1, 2011
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.