Factors Affecting Driver Speed Choice along Two-Lane Rural Highway Transition Zones
Publication: Journal of Transportation Engineering
Volume 136, Issue 8
Abstract
Two-lane rural highways attract trips between traffic generators such as residential villages or small commercial areas and are generally uninterrupted flow facilities that provide a high level of mobility with high posted speeds limits. When passing through developed areas, the posted speed limit may be lowered to encourage reduced vehicle operating speeds. No published guidelines currently exist for the design of transition zones that connect high- to low-speed operating environments on two-lane rural highways. The objective of this research was to collect operating speed and roadway characteristic data along two-lane rural highway transition zones in Pennsylvania to explore the roadway, roadside, and traffic control factors that are associated with driver speed differentials. Single- and multilevel models were estimated and compared. The posted speed limit reduction as well as a change in the paved shoulder width, total number of driveways, various advance warning signs, the transition zone length, and the presence of horizontal curves were shown to increase the expected speed reduction in transition zones in the models. Additionally, drivers entering transition zones at higher speeds were found to have greater speed reductions than drivers entering the transition zone at lower speeds.
Get full access to this article
View all available purchase options and get full access to this article.
References
American Association of State Highway and Transportation Officials. (2004). A policy on geometric design of highway and streets, AASHTO, Washington, D.C.
Donnell, E. T., and Cruzado, I. (2007). “Effectiveness of speed minders in reducing driving speeds on rural highways in Pennsylvania.” Rep. No. FHWA-PA-2007-023-510401-12, The Pennsylvania Transportation Institute, University Park, Pa.
Federal Highway Administration. (2000). Manual on uniform traffic control devices, Federal Highway Administration, Washington, D.C.
Federal Highway Administration. (2003). Manual on uniform traffic control devices, Federal Highway Administration, Washington, D.C.
Federal Highway Administration. (2004). Highway statistics, Federal Highway Administration, Washington, D.C.
Federal Highway Administration. (2008). “The U.S. Department of Transportation Rural Safety Initiative.” ⟨www.dot.gov/affairs/ruralsafety/ruralsafetyinitiativeplan.htm⟩ (Nov. 22, 2008).
Fitzpatrick, K., Elefteriadou, L., Harwood, D. W., Collins, J. M., McFadden, J., Anderson, I. B., Krammes, R. A., Irizarry, N., Parma, K. D., Bauer, K. M., and Passetti, K. (2000). “Speed prediction for two-lane rural highways.” Rep. No. FHWA-RD-99-171, Federal Highway Administration, McLean, Va.
Lamm, R., Psarianos, B., and Cafiso, S. (2002). “Safety evaluation process for two-lane rural roads: A 10-year review.” Transportation Research Record. 1796, Transportation Research Board of the National Academies, Washington, D.C.
McFadden, J., and Elefteriadou, L. (2000). “Evaluating horizontal alignment design consistency of two-lane rural highways.” Transportation Research Record. 1737, Transportation Research Board of the National Academies, Washington, D.C.
McLean, J. (1979). “An alternative to the design speed concept for low-speed alignment design.” Transportation Research Record. 702, Transportation Research Board of the National Academies, Washington, D.C.
Misaghi, P., and Hassan, Y. (2005). “Modeling operating speed and speed differential on two-lane rural roads.” J. Transp. Eng., 131(6), 408–418.
National Highway Traffic Safety Administration. (2005). “Fatality analysis reporting system.” ⟨www.-fars.nhtsa.gov⟩ (Nov. 23, 2008).
Neter, J., Kutner, M., Wasserman, W., and Nachtsheim, C. (1996). Applied linear statistical models, McGraw-Hill, New York.
Ottesen, J. L., and Krammes, R. A. (2000). “Speed-profile model for a design-consistency evaluation procedure in the United States.” Transportation Research Record. 1701, Transportation Research Board of the National Academies, Washington, D.C.
Park, Y. -J., and Saccomanno, F. (2006). “Evaluating speed consistency between successive elements of a two-lane rural highway.” Transp. Res., Part A, 40(5), 375–385.
Poe, C. M., and Mason, J. M. (2000). “Analyzing influence of geometric design on operating speeds along low-speed urban streets.” Transportation Research Record. 1737, Transportation Research Board of the National Academies, Washington, D.C.
Schurr, K., McCoy, P. T., Pesti, G., and Huff, R. (2002). “Relationship of design, operating, and posted speeds on horizontal curves of rural two-lane highways in Nebraska.” Transportation Research Record. 1796, Transportation Research Board of the National Academies, Washington, D.C.
Stamatiadis, N., Pigman, J. G., and Hartman, D. (2004). “Safety consequences of flexibility in highway design for rural communities.” Final Rep. for National Cooperative Highway Research Program Project No. 15-22, Univ. of Kentucky, Lexington, Ky.
Stamatiadis, N., Pigman, J. G., and Hartman, D. (2006). “Safety consequences from design flexibility in rural to urban transitions.” Proc., 85th Annual Meeting of the Transportation Research Board, Paper No. 06-0550, Transportation Research Board, Washington, D.C.
Tarris, J., Poe, C., Mason, J. M., and Goulias, K. (1996). “Predicting operating speeds on low-speed urban streets: Regression and panel analysis approaches.” Transportation Research Record. 1523, Transportation Research Board of the National Academies, Washington, D.C.
Washington, S. P., Karlaftis, M. G., and Mannering, F. L. (2003). Statistical and econometric methods for transportation data analysis, Chapman & Hall/CRC, Boca Raton, Fla.
Information & Authors
Information
Published In
Copyright
© 2010 ASCE.
History
Received: May 27, 2009
Accepted: Nov 9, 2009
Published online: Dec 21, 2009
Published in print: Aug 2010
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.