Validated Mechanistic Model for Geogrid Base Reinforced Flexible Pavements
Publication: Journal of Transportation Engineering
Volume 135, Issue 12
Abstract
A mechanistic response model was recently developed at the University of Illinois to analyze geogrid base reinforced flexible pavements designed for low to moderate traffic volumes with a relatively thin hot-mix asphalt surface layer. This model utilizes the finite element approach and properly considers (1) the nonlinear, stress-dependent behavior of pavement foundation geomaterials, i.e., unbound aggregates and fine-grained soils; (2) anisotropic behavior of the granular base layer; and (3) the compaction and preloading induced unbound aggregate base residual stresses. To validate the developed mechanistic model, field response data were collected from instrumented full-scale pavements constructed with both geogrid reinforced and control test sections. The model predictions using the nonlinear and anisotropic characterizations of the granular base layer moduli were found to better capture the magnitudes and the trends in the measured response data. After trafficking to failure of the pavement test sections, pavement trench studies were conducted to gather constructed layer thicknesses and additional forensic data in an effort to provide refined inputs for the mechanistic response model. An increase in stiffness observed around the geogrid reinforcement in the field was properly modeled by the use of horizontal residual stresses above the geogrid, which resulted in a better match of the predicted with the measured pavement responses of the reinforced sections. As a result, the mechanistic model predictions computed at different locations in the test sections compared reasonably well with a large number of field measured responses under different load levels.
Get full access to this article
View all available purchase options and get full access to this article.
References
Al-Qadi, I. L., Loulizi, A., Janajreh, I., and Freeman, T. E. (2006). “Pavement response to dual and new wide-base tires at the same tire pressure.” Transportation Research Record. 1806, Transportation Research Board, Washington, D.C., 38–47.
Al-Qadi, I. L., Tutumluer, E., Dessouky, S., and Kwon, J. (2007). “Mechanistic response measurements of geogrid reinforced flexible pavements to vehicular loading.” Proc., Geosynthetics 2007 Conf. (CD-ROM), International Geosynthetic Society, Washington, D.C.
Christopher, B. R., Berg, R. R., and Perkins, S. W. (2001). “Geosynthetic reinforcement in roadway sections.” NCHRP Synthesis for NCHRP Project, Task 112, Final Rep. 20-7, 119.
Desai, C. S. (2001). “Chapter 11: Mechanics of materials and interfaces.” The disturbed state concept: The DSC for interfaces and joints, CRC, Boca Raton, Fla., 421–476.
Kwon, J., Kim, M., and Tutumluer, E. (2005a). “Interface modeling for mechanistic analysis of geogrid reinforced flexible pavements.” Proc., GeoFrontiers Conf., Geo-Institute Geotechnical Special Publication (GSP) 130: Advances In Pavement Engineering (CD-ROM), C. W. Schwartz, E. Tutumluer, and L. Tashman, eds., ASCE, Reston, Va.
Kwon, J., Tutumluer, E., and Kim, M. (2005b). “Development of a mechanistic model for geosynthetic-reinforced flexible pavements.” Geosynthet. Int., 12(6), 310–320.
Kwon, J., Tutumluer, E., and Konietzky, H. (2008). “Aggregate base residual stresses affecting geogrid reinforced flexible pavement response.” Int. J. Pavement Eng., 9(4), 275–285.
Kwon, J., Tutumluer, E., Konietzky, H., and Keip, M. -A. (2006). “Investigation of geogrid base reinforcement mechanisms considering residual stress and confinement effects.” Proc., 8th Int. Conf. on Geosynthetics, International Geosynthetic Society, Yokohama, Japan.
Loulizi, A., Al-Qadi, I. L., Lahouar, S., and Freeman, T. E. (2001). “Data collection and management of the instrumented smart road flexible pavement sections.” Transportation Research Record. 1767, Transportation Research Board, Washington, D.C., 142–151.
McDowell, G. R., Harireche, O., Konietzky, H., Brown, S. F., and Thom, N. H. (2006). “Discrete element modelling of geogrid-reinforced aggregates.” Geotech. Eng., 159, 35–48.
Seyhan, U., and Tutumluer, E. (2002). “Anisotropic modular ratios as unbound aggregate performance indicators.” J. Mater. Civ. Eng., 14(5), 409–416.
Thompson, M. R., and Elliott, R. P. (1985). “ILLI PAVE based response algorithms for design of conventional flexible pavements.” Transportation Research Record. 1043, Transportation Research Board, Washington, D.C., 50–57.
Thompson, M. R., and Robnett, Q. L. (1979). “Resilient properties of subgrade soils.” J. Transp. Eng., 105(TE1), 71–89.
Tielking, J. T., and Roberts, F. L. (1987). “Tire contact pressure and its effect on pavement strain.” J. Transp. Eng., 113(1), 56–71.
Tutumluer, E., Adu-Osei, A., Little, D. N., and Lytton, R. L. (2001). “Field validation of the cross-anisotropic behavior of unbound aggregate bases—A deliverable of the international center for aggregates research 502 project: Structural characteristics of aggregate bases to meet AASHTO 2002 design requirements.” Research Rep. No. 502-2, International Center for Aggregates Research.
Tutumluer, E., Little, D. N., and Kim, S. (2003). “A validated model for predicting field performance of aggregate base courses.” Transportation Research Record. 1837, Transportation Research Board, Washington, D.C., 41–49.
Tutumluer, E., and Thompson, M. R. (1997). “Anisotropic modeling of granular bases in flexible pavements.” Transportation Research Record. 1577, Transportation Research Board, Washington, D.C., 18–26.
Uzan, J. (1985). “Characterization of granular materials.” Transportation Research Record. 1786, Transportation Research Board, Washington, D.C., 52–59.
Information & Authors
Information
Published In
Copyright
© 2009 ASCE.
History
Received: Apr 8, 2008
Accepted: Mar 16, 2009
Published online: Mar 18, 2009
Published in print: Dec 2009
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.