Operational Considerations for Terrestrial Laser Scanner Use in Highway Construction Applications
Publication: Journal of Surveying Engineering
Volume 138, Issue 4
Abstract
A 2010 survey of terrestrial laser scanner (TLS) usage among state highway agencies indicated that TLS is being increasingly used for highway construction applications among transportation agencies in the United States and Canada. To observe variations in TLS measurements for typical highway conditions, two roadway sites were studied; a 20-year-old asphalt surface and a new concrete surface. Repeated scans were conducted using a Leica ScanStation II to investigate the effects of pavement surface type and reflectance, point density, number and layout of targets, and survey method for establishing control points. Typical target arrangements were not found to greatly affect the resulting scan data for the equipment used in the study. It was observed in this case study that the collected TLS data demonstrated better relative elevation results based on the control and checkpoints established using total stations than on the control and checkpoints established using a real-time kinematic global positioning system. When using the Leica ScanStation II, reflectance of a sample of typical concrete pavement was not observed to vary greatly between 1-month-old and 1-year-old surfaces. Reflectance of asphalt pavement was observed to vary significantly between several examined surfaces ranging from new to 20 years old.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors wish to thank Mr. Danny Shealy and Mr. Charles Eleazer of the SCDOT State Construction Office and Mr. Milt Fletcher of the SCDOT Office of Materials and Research for their active support and enthusiasm for this emerging technology. The authors also extend their appreciation to Mr. Bart Dominick of the SCDOT Office of Materials and Research and Mr. Dennis Branham from the SCDOT Surveys Office for their time and expert assistance.
References
AASHTO. (2004). A policy on geometric design of highways and streets, 5th Ed., AASHTO, Washington, DC, 309–381.
Baus, R. L., and Henderson, A. T. (2008). “Development of improved rideability specifications for rigid pavements and bridge decks.” Rep. No. FHWA-SC-08-02, Columbia, SC, 〈http://www.clemson.edu/t3s/scdot/pdf/projects/SPR_657.pdf〉 (Aug. 17, 2011).
Boehler, W., Vicent, M. B., and Marbs, A. (2003). “Investigating laser scanner accuracy.” Proc., XIXth Int. Scientific Committee for Documentation of Cultural Heritage (CIPA) Symp., International Scientific Committee for Documentation of Cultural Heritage (CIPA), Antalya, Turkey. 〈http://cipa.icomos.org/text%20files/antalya/189.pdf 〉 (Oct. 15, 2011).
California Department of Transportation (Caltrans). (2011). “Terrestrial laser scanning specifications.” California Department of Transportation surveys manual, Chapter 15, 〈http://www.dot.ca.gov/hq/row/landsurveys/SurveysManual/15_Surveys.pdf〉 (Aug. 17, 2011).
Clark, J., and Robson, S. (2004). “Accuracy of measurements made with a Cyrax 2500 laser scanner against surfaces of known color.” Surv. Rev., 37(294), 626–638.
Gordon, S. J., and Lichti, D. D. (2004). “Terrestrial laser scanners with a narrow field of view: the effect on 3D resection solutions.” Surv. Rev., 37(292), 448–468.
Hejbudzka, K., Lindenbergh, R., Soudarissanane, S., and Humme, A. (2010). “Influence of atmospheric conditions on the range distance and number of returned points in Leica ScanStation 2 point clouds.” Int. Arch. Photogramm. Remote Sens. Spatial Inf. Sci., XXXVIII(5), 282–287.
Henning, W. (2010). “National Geodetic Survey user guidelines for single base real time GNSS positioning.” 〈http://www.ngs.noaa.gov/PUBS_LIB/NGSRealTimeUserGuidelines.v1.1.pdf〉 (Dec. 20, 2011).
Hiremagalur, J., Yen, K.S., Lasky, T.A., and Ravani, B. (2009). “Testing and performance evaluation of fixed terrestrial three-dimensional laser scanning systems for highway applications.” Transportation Research Record 2098, Transportation Research Board, Washington, DC, 29–40.
Johnson, A. M., Smith, B. C., Hong Johnson, W., and Gibson, L. W. (2010). “Evaluating the effect of slab curling on IRI for South Carolina concrete pavements.” Rep. No. FHWA-SC-10-04, Columbia, SC, 〈http://www.clemson.edu/t3s/scdot/pdf/projects/SPR%20688%20final%20report.pdf〉 (Aug. 17, 2011).
Karamihas, S. M., Perera, R. W., Gillespie, T. D., and Kohn, S. D. (2001). “Diurnal changes in profile of eleven jointed PCC pavements.” Proc., 7th Int. Conf. on Concrete Pavements, Vol. 1, International Society for Concrete Pavements, Orlando, FL, 69–80.
Kersten, T., Mechelke, K., Lindstaedt, M., and Sternberg, H. (2008). “Geometric accuracy investigations of the latest terrestrial laser scanning.” Proc., FIG Working Week, Integrating Generations, International Federation of Surveyors (FIG), Stockholm, Sweden, 〈http://www.fig.net/pub/fig2008/papers/ts02d/ts02d_01_mechelke_etal_2785.pdf〉 (Aug. 17, 2011).
Lapine, L. A., and Wellslager, M. J. (2007). “GPS + GLONASS for precision: South Carolina’s GNSS virtual reference network.” InsideGNSS, 2(5), 50–57.
Lichti, D. D., Gordon, S. J., Stewart, M. P., Franke, J., and Tsakiri, M. (2002). “Comparison of digital photogrammetry and laser scanning.” Proc., CIPA WG6 Int. Workshop on Scanning for Cultural Heritage Recording, CIPA, Corfu, Greece, 39–44. 〈http://scanning.fh-mainz.de/applications/lichti.pdf〉 (Aug. 17, 2011).
Lichti, D., Gordon, S., and Tipdecho, T. (2005). “Error models and propagation in directly georeferenced terrestrial laser scanner networks.” J. Surv. Eng., 131(4), 135–142.
Lichti, D. D., Stewart, M. P., Tsakiri, M., and Snow, A. J. (2000). “Calibration and testing of a terrestrial laser scanner.” Int. Arch. Photogramm. Remote Sens., XXXIII(B5), 485–492.
National Digital Elevation Program (NDEP). (2004). “Guidelines for digital elevation data. Version 1.0.” 〈http://www.ndep.gov/NDEP_Elevation_Guidelines_Ver1_10May2004.pdf〉 (Aug. 17, 2011).
North Carolina Department of Transportation (NCDOT). (2009). “Standards for high density laser scanning of pavement.” Proc., 2009-2, NCDOT, Raleigh, NC.
Olsen, M. J., Johnstone, E., Driscoll, N., Ashford, S. A., and Kuester, F. (2009). “Terrestrial laser scanning of extended cliff sections in dynamic environments: Parameter analysis.” J. Surv. Eng., 135(4), 161–169.
Pauls, J. T. (1927). “Progress report on the experimental curing slabs at Arlington, Virginia.” Highway Research Board Proceedings, Vol. 6, Highway Research Board, Transportation Research Board, Washington, DC, 192–201.
Pfeifer, N., Dorninger, P., Haring, A., and Fan, H. (2007). “Investigating terrestrial laser scanning intensity data: Quality and functional relations.” Proc., VIII Int. Conf. on Optical 3-D Measurement Techniques, International Society for Photogrammetry and Remote Sensing (ISPRS), International Association of Geodesy (IAG), and FIG, Zurich, Switzerland, 328–337. 〈http://publik.tuwien.ac.at/files/pub-geo_1932.pdf〉 (Aug. 17, 2011).
Souleyrette, R., Hallmark, S., Pattnaik, S., O’Brien, M., and Veneziano, D. (2003). “Grade and cross slope estimation from LIDAR-based surface models.” Rep. No. MTC-2001-02, Ames, IA, 〈http://www.intrans.iastate.edu/reports/LIDAR_Grade.pdf〉 (Oct. 15, 2011).
South Carolina Department of Transportation (SCDOT). (2009). “Cross slope verification.” 〈http://www.scdot.org/doing/pdfs/Sup_Specs/Cross_Slope_Verification.pdf〉 (Aug. 17, 2011).
Staiger, R. (2005). “The geometrical quality of terrestrial laser scanner (TLS).” Proc., FIG Working Week, FIG, Cairo, Egypt, 〈http://www.fig.net/pub/cairo/papers/ts_38/ts38_05_staiger.pdf〉 (Aug. 17, 2011).
Westergaard, H. M. (1927). “Analysis of stresses in concrete pavements due to variations of temperature.” Highway Research Board Proceedings, Vol. 6, Highway Research Board, Transportation Research Board, Washington, DC, 201–215.
Young, A. P., et al. (2010). “Comparison of airborne and terrestrial LIDAR estimates of seacliff erosion in Southern California.” Photogramm. Eng. Remote Sens., 76(4), 421–427.
Information & Authors
Information
Published In
Journal of Surveying Engineering
Volume 138 • Issue 4 • November 2012
Pages: 214 - 222
Copyright
© 2012 American Society of Civil Engineers.
History
Received: Mar 9, 2011
Accepted: Feb 8, 2012
Published online: Feb 10, 2012
Published in print: Nov 1, 2012
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.