Preliminary Evaluation of Baseline Relative Accuracies Using L1 Frequency Observations of Navigation-Grade GARMIN Receivers
Publication: Journal of Surveying Engineering
Volume 137, Issue 1
Abstract
Handheld navigation global positioning system (GPS) receivers are significantly cheaper and their position determination accuracy is less than their geodetic-grade counterparts. Although the main observable in most low-cost handheld GPS receivers is the coarse acquisition (C/A) code, some receive L1 frequency observations and utilize them to smooth the code measurements. In this technical paper, we examined the use of the C/A code and L1 phase observations captured by two GARMIN eTrex receivers in a postprocessing mode. We used software applications that send low level commands to download and save the receiver data stream and convert the observations into standard RINEX file format. Nineteen baselines with different lengths were observed using the eTrex receivers and dual frequency geodetic-grade receivers. The baseline lengths were derived from the eTrex observations and compared to corresponding ones derived from the higher accuracy geodetic-grade receiver observations. Several tests were conducted to analyze the effect of potential error sources on the achieved accuracy. The results showed that low satellite angles and existing cycle slips contributed to the errors in the processed eTrex data. The implementation of a cycle slip detection algorithm and their subsequent deletion significantly enhanced the obtained baseline relative accuracy to a finally limited range of 1.8–13.4 cm/km.
Get full access to this article
View all available purchase options and get full access to this article.
References
Awad, A. I. (2009). “Enhancement of the accuracy of low cost GPS receivers.” M.S. thesis, Dept. of Public Works, Faculty of Engineering, Ain Shams Univ., Cairo, Egypt.
Cosser, E., Hill, C. J., Roberts, G. W., Meng, X., Moore, T., and Dodson, A. H. (2004). “Bridge monitoring with Garmin handheld receivers.” Proc., 1st FIG Int. Symp. on Engineering Surveys for Construction Works and Structural Engineering, Nottingham, U.K.
El-Mowafy, A. (2005). “Decimeter level mapping using differential phase measurements of GPS handheld receivers.” Surv. Rev., 38(295), 47–57.
El-Rabbany, A. (2002). Introduction to the global positioning system (GPS), Artech House Mobile Communication Series, Boston, London.
Fath-Allah, T. (2004). “Accuracy study of GPS surveying operations involving long baselines.” Ph.D. thesis, Dept. of Public Works, Faculty of Engineering, Ain Shams Univ., Cairo, Egypt.
Galán, A. T. (2000). “Preliminary results of postprocessing G12 raw data.” ⟨http://artico.lma.fi.upm.es/numerico/miembros/antonio/async/node4.html⟩ (May 5, 2010).
Hofmann-Wellenhof, B., Lichtenegger, H., and Collins, J. (2001). Global positioning system—Theory and practice, 5th Revised Ed., Springer, Wien, New York.
Kim, D., and Langley, R. (2000). “The multi-path divergence problem in GPS carrier-smoothed code pseudorange.” Proc., 47th Annual Conf. of the Canadian Aeronautics and Space Institute, Canadian Aeronautics and Space Institute, Ottawa.
Kim, E., Walter, T., and Powell, J. D. (2007). “Adaptive carrier smoothing using code and carrier divergence.” Proc., Institute of Navigation (ION 2007), San Diego.
Ouzeau, C., Macabiau, C., Escher, A., and Roturier, B. (2007). “Compliance of single frequency ionospheric delay estimation and cycle slip detection with civil aviation requirements.” Proc., 2007 National Technical Meeting of the Institute of Navigation, San Diego.
Rabah, M. M. (1998). “Enhancing kinematic GPS ambiguity resolution for medium baselines using a regional ionospheric model in real-time.” Ph.D. thesis, Institute of Physical Geodesy, Darmstadt Univ. of Technology, Darmstadt, Germany.
Ragab, A. F., and Fath-Allah, T. F. (2007). “Aiding the GPS planning process using positional error analysis.” Scientific Bulletin, Faculty of Engineering, Ain Shams Univ., 42(3), 299–321.
Rodríguez-Pérez, J. R., Álvarez, M. F., and Sanz-Ablanedo, E. (2007). “Assessment of low-cost GPS receiver accuracy and precision in forest environments.” J. Surv. Eng., 133(4), 159–167.
Rokhmana, C. A. (2006). “Some aspects on developing a truly low-cost mapping system using handheld gps and camcorder.” Proc., XXIII FIG Congress, Munich, Germany.
Schwieger, V. (2003). “Using handheld GPS receivers for precise positioning.” Proc., 2nd FIG Regional Conf., Marrakech, Morocco.
Seeber, G. (1993). Satellite geodesy: Foundations, methods, and applications, Walter de Gruyter, Berlin, New York.
Zurutuza, J., and Sevilla, M. J. (2007). “Influence of the cutoff angle and the bearing in high-precision GPS vector determination.” J. Surv. Eng., 133(2), 90–94.
Information & Authors
Information
Published In
Journal of Surveying Engineering
Volume 137 • Issue 1 • February 2011
Pages: 26 - 32
Copyright
© 2011 ASCE.
History
Received: Mar 20, 2010
Accepted: Jul 22, 2010
Published online: Jul 30, 2010
Published in print: Feb 2011
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.