Behavior of CFST Column to Concrete-Filled U-Shaped Steel Beam Joints with Slabs under Cyclic Loading
Publication: Journal of Structural Engineering
Volume 148, Issue 3
Abstract
This study proposes a through-beam composite joint system to connect square concrete-filled steel tubular (CFST) columns and concrete-filled U-shaped steel (CFUS) beams. In the joint system, channel-shaped holes in the square steel tube allow direct load transfer of the beam. Two procedures for constructing the joints, denoting two types of joint details (i.e., Type-I and Type-II), are proposed to facilitate field installation. Six cruciform joints were tested under combined constant axial compression and cyclic lateral loading. Three Type-I joints were tested. The main test parameters were the loading procedure and the axial load ratio applied on the CFST column. All Type-I specimens reached their beam flexural capacities followed by the fracture of fillet welds at beam ends, as well as the fracture of the reduced steel section within the joint zone. Three Type-II joints were constructed with the same column and beam section dimensions as the Type-I specimens. The main test parameters were the additional flexural rebars at beam ends and the axial load ratio. All Type-II specimens reached their beam flexural capacities, followed by the fracture of the heat-affected zone at beam ends. All specimens failed in a ductile manner, had favorable hysteretic performance, and complied with the acceptance criteria. Design considerations are proposed based on the test and analysis results.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
Some or all data, models, or code that support the findings of this study are available from the corresponding author upon reasonable request.
Acknowledgments
The authors greatly appreciate the financial support provided by the National Natural Science Foundation of China (Nos. 51878097 and 51890902), the Natural Science Foundation of Chongqing (No. cstc2019jcyj-xfkx0007), and the National Program on Key Research and Development Project (No. 2017YFC0703805). The opinions expressed in this paper are solely the authors’ own.
References
ACI (American Concrete Institute). 2005. Acceptance criteria for moment frames based on structural testing and commentary. ACI 374.1-05. Farmington Hills, MI: ACI.
ACI (American Concrete Institute). 2013. Guide for testing reinforced concrete structural elements under slowly applied simulated seismic loads. ACI 374.2R-13. Farmington Hills, MI: ACI.
AISC. 2016a. Seismic provisions for structural steel buildings. ANSI/AISC 341-16. Chicago: AISC.
AISC. 2016b. Specification for structural steel buildings. ANSI/AISC 360-16. Chicago: AISC.
Chen, L., A. Li, F. Lu, Y. Lou, and P. Li. 2007. “Experimental study on joints of outer-plated steel-concrete composite beam and reinforced concrete columns.” China Civ. Eng. J. 40 (11): 41–47. https://doi.org/10.15951/j.tmgcxb.2007.11.013.
Chen, L.-H., S.-T. Li, H.-Y. Zhang, and X.-F. Wu. 2018. “Experimental study on mechanical performance of checkered steel-encased concrete composite beam.” J. Constr. Steel Res. 143 (Apr): 223–232. https://doi.org/10.1016/j.jcsr.2017.12.021.
Chopra, A. K. 2011. Dynamics of structures. 4th ed. Upper Saddle River, NJ: Prentice Hall.
Fukumoto, T., and K. Morita. 2005. “Elastoplastic behavior of panel zone in steel beam-to-concrete filled steel tube column moment connections.” J. Struct. Eng. 131 (12): 1841–1853. https://doi.org/10.1061/(ASCE)0733-9445(2005)131:12(1841).
Gibson, N., A. Filiatrault, and S. A. Ashford. 2002. “Impulsive seismic response of bridge column-cap beam joints.” ACI Struct. J. 99 (4): 470–479.
Gourley, B. C., C. Tort, M. D. Denavit, P. H. Schiller, and J. F. Hajjar. 2008. A synopsis of studies of the monotonic and cyclic behavior of concrete-filled steel tube members, connections, and frames. Urbana, IL: Newmark Structural Engineering Laboratory, Univ. of Illinois at Urbana-Champaign.
Han, L.-H., and W. Li. 2010. “Seismic performance of CFST column to steel beam joint with RC slab: Experiments.” J. Constr. Steel Res. 66 (11): 1374–1386. https://doi.org/10.1016/j.jcsr.2010.05.003.
Han, L.-H., W. Li, and R. Bjorhovde. 2014. “Developments and advanced applications of concrete-filled steel tubular (CFST) structures: Members.” J. Constr. Steel Res. 100 (Sep): 211–228. https://doi.org/10.1016/j.jcsr.2014.04.016.
Heng, P., C. Lepourry, H. Somja, and F. Palas. 2020. “Behaviour of a joint between a U-shaped steel-concrete beam and a concrete-filled steel tubular column.” J. Constr. Steel Res. 175 (Dec): 106322. https://doi.org/10.1016/j.jcsr.2020.106322.
Hwang, H.-J., T.-S. Eom, H.-G. Park, S.-H. Lee, and H.-S. Kim. 2015. “Cyclic loading test for beam-column connections of concrete-filled U-shaped steel beams and concrete-encased steel angle columns.” J. Struct. Eng. 141 (11): 04015020. https://doi.org/10.1061/(ASCE)ST.1943-541X.0001242.
Keo, P., C. Lepourry, H. Somja, and F. Palas. 2018. “Behavior of a new shear connector for U-shaped steel-concrete hybrid beams.” J. Constr. Steel Res. 145 (Jun): 153–166. https://doi.org/10.1016/j.jcsr.2018.01.028.
Lepourry, C., P. Heng, H. Somja, N. Boissonnade, and F. Palas. 2019. “An innovative concrete-steel structural system for long-span structure allowing a fast and simple erection.” Structures 21 (Oct): 55–74. https://doi.org/10.1016/j.istruc.2019.04.016.
Lin, Y., X. Zhou, W. Jiang, and Z. Yao. 2015. “Analysis on hysteretic behavior of concrete-filled square steel tubular column to steel-encased concrete composite beam connections.” China Civ. Eng. J. 48 (12): 72–81.
Liu, Y., L. Guo, B. Qu, and S. Zhang. 2017. “Experimental investigation on the flexural behavior of steel-concrete composite beams with U-shaped steel girders and angle connectors.” Eng. Struct. 131 (Jan): 492–502. https://doi.org/10.1016/j.engstruct.2016.10.037.
Liu, Y., L. Guo, and S. Zhang. 2018. “Cyclic loading tests of composite joints between concrete-filled square steel tubular column and composite beam with U-shaped steel girder.” J. Build. Struct. 39 (6): 131–140. https://doi.org/10.14006/j.jzjgxb.2018.06.014.
Lu, X., Y. Yu, T. Kiyoshi, and S. Satoshi. 2000. “Experimental study on the seismic behavior in the connection between CFRT column and steel beam.” Struct. Eng. Mech. 9 (4): 365–374. https://doi.org/10.12989/sem.2000.9.4.365.
MOHURD (Ministry of Housing and Urban-Rural Development of the People’s Republic of China). 2010a. Code for design of concrete structures. GB 50010-2010. Beijing: Architecture Industrial Press of China.
MOHURD (Ministry of Housing and Urban-Rural Development of the People’s Republic of China). 2010b. Code for seismic design of buildings. GB 50011-2010. Beijing: Architecture Industrial Press of China.
MOHURD (Ministry of Housing and Urban-Rural Development of the People’s Republic of China). 2014. Technical code for concrete filled steel tubular structures. Beijing: China Architecture & Building Press.
Nakamura, S. 2002. “Bending behavior of composite girders with cold formed steel U section.” J. Struct. Eng. 128 (9): 1169–1176. https://doi.org/10.1061/(ASCE)0733-9445(2002)128:9(1169).
Nie, J., K. Qin, and C. S. Cai. 2008. “Seismic behavior of connections composed of CFSSTCs and steel–concrete composite beams—Experimental study.” J. Constr. Steel Res. 64 (10): 1178–1191. https://doi.org/10.1016/j.jcsr.2007.12.004.
Nishiyama, I., T. Fujimoto, T. Fukumoto, and K. Yoshioka. 2004. “Inelastic force-deformation response of joint shear panels in beam-column moment connections to concrete-filled tubes.” J. Struct. Eng. 130 (2): 244–252. https://doi.org/10.1061/(ASCE)0733-9445(2004)130:2(244).
Park, H.-G., H.-J. Hwang, C.-H. Lee, C.-H. Park, and C.-N. Lee. 2012. “Cyclic loading test for concrete-filled U-shaped steel beam–RC column connections.” Eng. Struct. 36 (Mar): 325–336. https://doi.org/10.1016/j.engstruct.2011.12.033.
Park, R. 1988. “Ductility evaluation from laboratory and analytical testing.” In Proc., 9th World Conf. on Earthquake Engineering, 605–616. Tokyo: Japan Association for Earthquake Disaster Prevention.
Shi, Q., F. Ding, Y. Xuan, and A. Li. 2011. “Experimental investigation on joints connecting outer-plated steel-concrete composite beam and concrete filled steel tube column.” Eng. Mech. 28 (4): 109–115.
Thai, H.-T., B. Uy, Yamesri, and F. Aslani. 2017. “Behaviour of bolted endplate composite joints to square and circular CFST columns.” J. Constr. Steel Res. 131 (Apr): 68–82. https://doi.org/10.1016/j.jcsr.2016.12.022.
Wang, J.-F., L.-H. Han, and B. Uy. 2009. “Behaviour of flush end plate joints to concrete-filled steel tubular columns.” J. Constr. Steel Res. 65 (4): 925–939. https://doi.org/10.1016/j.jcsr.2008.10.010.
Wang, W., L. Han, and J. You. 2006. “Experimental studies on hysteretic behaviors of steel beam to concrete filled SHS column connections with stiffening ring.” China Civ. Eng. J. 39 (9): 17–25.
Wu, L., Z. Chen, and B. Rong. 2017. “Calculation method for the shear bearing capacity of diaphragm-through connections.” Adv. Struct. Eng. 20 (6): 906–916. https://doi.org/10.1177/1369433216666444.
Yi, W.-J., Y. Zhou, Y. Liu, and L. Liu. 2016. “Experimental investigation of circular reinforced concrete columns under different loading histories.” J. Earthquake Eng. 20 (4): 654–675. https://doi.org/10.1080/13632469.2015.1104749.
Zhao, Y., Y. Yang, S. Xu, J. Liu, and Y. F. Chen. 2020. “Shear connection of reinforcement stiffened cold-formed U-shaped steel and concrete composite beam.” Eng. Struct. 219 (Sep): 110862. https://doi.org/10.1016/j.engstruct.2020.110862.
Zhou, T., S. Nie, L. Lu, and B. He. 2005. “Design of concrete-filled square tube column and steel beam joint with internal diaphragms.” J. Build. Struct. 26 (5): 23–30.
Zhou, X., X. Wang, and Y. Zhang. 2010. “The analysis of the anti-seismic capacity of joints in composite frame of concrete encased by U-shaped steel plate.” Supplement, China Civ. Eng. J. 43 (S1): 163–168. https://doi.org/10.15951/j.tmgcxb.2010.s1.099.
Information & Authors
Information
Published In
Copyright
© 2021 American Society of Civil Engineers.
History
Received: Mar 1, 2021
Accepted: Oct 22, 2021
Published online: Dec 28, 2021
Published in print: Mar 1, 2022
Discussion open until: May 28, 2022
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.
Cited by
- Shubham Dangwal, Heaven Singh, Behavior of corrosion damaged non-seismically and seismically detailed reinforced concrete beam-column sub-assemblages under cyclic loading, Engineering Failure Analysis, 10.1016/j.engfailanal.2023.107135, 146, (107135), (2023).
- Dan Gan, Zhenhua He, Huihui Huang, Investigation of cyclic behavior of full-scale tree-like hollow structural section columns with infilled concrete, Journal of Constructional Steel Research, 10.1016/j.jcsr.2022.107339, 194, (107339), (2022).