Wind Interference Effects from One High-Rise Building and Similar Low-Rise Flat-Roof Buildings
Publication: Journal of Structural Engineering
Volume 147, Issue 9
Abstract
Wind tunnel tests in an open terrain were carried out to study interference effects on peak pressure coefficients of one low-rise flat-roof building due to one high-rise building and similar low-rise buildings. The results demonstrate that amplification interference effects are significant on the minimum pressures at the edge of the low-rise building roof adjacent to the high-rise building and on the maximum pressures in the roof area away from the high-rise building, where the minimum pressure means the algebraic minimum with negative suction. Magnitudes of the envelope peak pressure coefficients on the low-rise building increase when the high-rise building height increases. The envelope minimum peak pressure coefficients in the roof middle area parallel to the high-rise building experience amplification effects at large building height and small spacing ratios, but other roof areas experience shielding effects at small spacing ratios, and interference factors of the envelope minimum peak pressure coefficients increase with the increase of the height and spacing ratios. When the spacing ratio is less than two, cases with large height ratios display amplification effects on the envelope maximum peak pressure coefficients, and amplification effects increase with the increase of the height ratio or the decrease of spacing ratio.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
All data, models, and code generated or used during the study appear in the published article.
Acknowledgments
The work in this paper was partially supported by the National Natural Science Foundation of China (Grant Nos. 52078088 and 51378059) and the 111 Project of China (Grant No. B18062). The authors are also grateful to Ms. Shuo Wang from Beijing Jiaotong University for her contribution towards the paper.
References
Alrawashdeh, H., and T. Stathopoulos. 2015. “Wind pressures on large roofs of low buildings and wind codes and standards.” J. Wind Eng. Ind. Aerodyn. 147 (Dec): 212–225. https://doi.org/10.1016/j.jweia.2015.09.014.
ASCE. 2016. Minimum design loads and associated criteria for buildings and other structures. ASCE 7-16. New York: ASCE.
Chang, C.-H., and R. N. Meroney. 2003. “The effect of surroundings with different separation distances on surface pressures on low-rise buildings.” J. Wind Eng. Ind. Aerodyn. 91 (8): 1039–1050. https://doi.org/10.1016/S0167-6105(03)00051-5.
Chen, B., H. Cheng, H. Kong, X. Chen, and Q. Yang. 2019. “Interference effects on wind loads of gable-roof buildings with different roof slopes.” J. Wind Eng. Ind. Aerodyn. 189 (Jun): 198–217. https://doi.org/10.1016/j.jweia.2019.03.033.
Chen, B., L. Shang, M. Qin, X. Chen, and Q. Yang. 2018. “Wind interference effects of high-rise building on low-rise building with flat roof.” J. Wind Eng. Ind. Aerodyn. 183 (Dec): 88–113. https://doi.org/10.1016/j.jweia.2018.10.019.
Cook, N. J. 1982. “Towards better estimation of extreme winds.” J. Wind Eng. Ind. Aerodyn. 9 (3): 295–323. https://doi.org/10.1016/0167-6105(82)90021-6.
Cook, N. J. 1985. The designer’s guide to wind loading on building structures. Part I: Background, damage survey, wind data, and structural classification. Watford, UK: Building Research Establishment.
Holmes, J. D. 1994. “Wind pressures on tropical housing.” J. Wind Eng. Ind. Aerodyn. 53 (1–2): 105–123. https://doi.org/10.1016/0167-6105(94)90021-3.
Hong, H. P., S. H. Li, and T. G. Mara. 2013. “Performance of the generalized least-squares method for the Gumbel distribution and its application to annual maximum wind speeds.” J. Wind Eng. Ind. Aerodyn. 119 (Aug): 121–132. https://doi.org/10.1016/j.jweia.2013.05.012.
Hunt, A. 1982. “Wind-tunnel measurements of surface pressures on cubic building models at several scales.” J. Wind Eng. Ind. Aerodyn. 10 (2): 137–163. https://doi.org/10.1016/0167-6105(82)90061-7.
Hussain, M., and B. E. Lee. 1980. “A wind tunnel study of the mean pressure forces acting on large groups of low-rise buildings.” J. Wind Eng. Ind. Aerodyn. 6 (3–4): 207–225. https://doi.org/10.1016/0167-6105(80)90002-1.
Khanduri, A. C., T. Stathopoulos, and C. Bédard. 1998. “Wind-induced interference effects on buildings—A review of the state-of-the-art.” Eng. Struct. 20 (7): 617–630. https://doi.org/10.1016/S0141-0296(97)00066-7.
Kim, Y. C., Y. Tamura, and S.-W. Yoon. 2015. “Proximity effect on low-rise building surrounded by similar-sized buildings.” J. Wind Eng. Ind. Aerodyn. 146 (Nov): 150–162. https://doi.org/10.1016/j.jweia.2015.08.011.
Kim, Y. C., A. Yoshida, and Y. Tamura. 2012. “Characteristics of surface wind pressures on low-rise building located among large group of surrounding buildings.” Eng. Struct. 35 (Feb): 18–28. https://doi.org/10.1016/j.engstruct.2011.10.024.
Kim, Y. C., A. Yoshida, and Y. Tamura. 2013. “Influence of surrounding buildings on wind loads acting on low-rise building.” J. Struct. Eng. 139 (2): 275–283. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000625.
Kose, D. A., and E. Dick. 2010. “Prediction of the pressure distribution on a cubical building with implicit LES.” J. Wind Eng. Ind. Aerodyn. 98 (10–11): 628–649. https://doi.org/10.1016/j.jweia.2010.06.004.
Lee, B. E., and B. F. Soliman. 1977. “An investigation of the forces on three dimensional bluff bodies in rough wall turbulent boundary layers.” J. Fluids Eng. 99 (3): 503–509. https://doi.org/10.1115/1.3448828.
Lieblein, J. 1974. Efficient methods of extreme-value methodology. New York: National Bureau of Standards.
Morris, H. M. 1955. “Flow in rough conduits.” Trans. ASME. 120 (7–8): 557–563. https://doi.org/10.1016/j.nut.2007.05.005.
Murakami, S. 1993. “Comparison of various turbulence models applied to a bluff body.” J. Wind Eng. Ind. Aerodyn. 46–47 (Aug): 21–36. https://doi.org/10.1016/0167-6105(93)90112-2.
Pindado, S., J. Meseguer, and S. Franchini. 2011. “Influence of an upstream building on the wind-induced mean suction on the flat roof of a low-rise building.” J. Wind Eng. Ind. Aerodyn. 99 (8): 889–893. https://doi.org/10.1016/j.jweia.2011.06.003.
Rostamy, N. 2012. “Fundamental studies of the wake structure for surface-mounted finite-height cylinders and prisms.” Ph.D. dissertation, Dept. of Mechanical Engineering, Univ. of Saskatchewan.
Stathopoulos, T. 1984. “Adverse wind loads on low buildings due to buffeting.” J. Struct. Eng. 110 (10): 2374–2392. https://doi.org/10.1061/(ASCE)0733-9445(1984)110:10(2374).
Sun, Y., Y. Tamura, Y. Quan, and M. Matsui. 2008. “The interference effect of surrounding roughness on wind pressures of rectangular prism.” In Proc., 6th Int. Colloq Bluff Body Aerodyn Appl (BBAA VI). Milan, Italy: International Association for Wind Engineering. http://citeseerx.ist.psu.edu/viewdoc/versions?doi=10.1.1.564.9460.
Tieleman, H. W., T. A. Reinhold, and M. R. Hajj. 1997. “Importance of turbulence for the prediction of surface pressures on low-rise structures.” J. Wind Eng. Ind. Aerodyn. 69–71 (97): 519–528. https://doi.org/10.1016/S0167-6105(97)00182-7.
Information & Authors
Information
Published In
Copyright
© 2021 American Society of Civil Engineers.
History
Received: Sep 16, 2020
Accepted: Apr 29, 2021
Published online: Jul 12, 2021
Published in print: Sep 1, 2021
Discussion open until: Dec 12, 2021
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.