Structural Performance and Compression Resistances of Thin-Walled Square CFST Columns with Steel Lining Tubes
Publication: Journal of Structural Engineering
Volume 147, Issue 7
Abstract
This paper proposes an innovative thin-walled square concrete-filled steel tubular (CFST) column with a circular/octagonal steel lining tube, in which the outer steel tube and the lining tube are fabricated independently of each other and then connected by slot welds. The advantages of a simplified manufacturing process, an insensitivity to local buckling, and good confinement could be expected in this composite column. Twelve short columns were tested to failure under compression, and various key parameters including nominal width-to-thickness ratios of steel tubes, stiffener types, yield strengths of steel tubes, and lining tubes were considered. The test results indicated that the proposed steel lining tubes were able to improve the axial behavior of these thin-walled square CFST short columns in various ways, including a more uniformly spaced buckling pattern with smaller intervals, larger axial stiffness, higher section resistances, and enhanced confinement and ductility. The octagonal lining tubes were more effective than the circular ones in terms of buckling constraints while the circular lining tubes were superior in terms of confining enhancement. A finite-element parametric analysis was also carried out to assess the axial resistances of these thin-walled square CFST columns with lining tubes. A simplified model was developed incorporating both the postlocal buckling of the square steel tubes and the confinement of the lining tubes.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
Some or all data, models, or code that support the findings of this study are available from the corresponding author upon reasonable request.
Acknowledgments
The authors are grateful to the supports provided by the National Natural Science Foundation of China (Grant Nos. 51890902 and 51908086), the China Postdoctoral Science Foundation (Project No. 2020T130758), and the Natural Science Foundation of Chongqing, China (Project No. cstc2019jcyj-bshX0091).
References
AIJ (Architectural Institute of Japan). 1997. Recommendations for design and construction of concrete filled steel tubular structures. Tokyo: AIJ.
AISC (American Institute of Steel Construction). 2016. Specification for structural steel buildings. ANSI/AISC 360. Chicago: AISC.
CEB-FIP (Comité Euro-International du Béton/Federation Internationale de la Precontrainte). 1993. CEB-FIP model code 1990 CEB bulletin d’Information. London: Thomas Telford.
CEN (European Committee for Standardization). 2004. Design of composite steel and concrete structures. Part 1.1: General rules and rules for building. Eurocode 4. BS EN 1994-1-1. London: CEN.
Ding, F. X., Z. Li, S. Cheng, and Z. W. Yu. 2016. “Composite action of octagonal concrete-filled steel tubular stub columns under axial loading.” Thin Wall Struct. 107 (Oct): 453–461. https://doi.org/10.1016/j.tws.2016.07.012.
Dong, H., Y. Li, W. Cao, Q. Qiao, and R. Li. 2018. “Uniaxial compression performance of rectangular CFST columns with different internal construction characteristics.” Eng. Struct. 176 (Dec): 763–775. https://doi.org/10.1016/j.engstruct.2018.09.051.
Ge, H., and T. Usami. 1992. “Strength of concrete-filled thin-walled steel box columns: Experiment.” J. Struct. Eng. 118 (11): 3036–3054. https://doi.org/10.1061/(ASCE)0733-9445(1992)118:11(3036).
Han, L. H., W. Li, and R. Bjorhovde. 2014. “Developments and advanced applications of concrete-filled steel tubular (CFST) structures: Members.” J. Constr. Steel Res. 100 (Sep): 211–228. https://doi.org/10.1016/j.jcsr.2014.04.016.
Han, L. H., G. H. Yao, and Z. Tao. 2007. “Performance of concrete-filled thin-walled steel tubes under pure torsion.” Thin Wall Struct. 45 (1): 24–36. https://doi.org/10.1016/j.tws.2007.01.008.
Han, L. H., G. H. Yao, and X. L. Zhao. 2005. “Tests and calculations for hollow structural steel (HSS) stub columns filled with self-consolidating concrete (SCC).” J. Constr. Steel Res. 61 (9): 1241–1269. https://doi.org/10.1016/j.jcsr.2005.01.004.
Huang, C. S., Y. K. Yeh, G. Y. Liu, H. T. Hu, K. C. Tsai, Y. T. Weng, S. H. Wang, and M. H. Wu. 2002. “Axial load behavior of stiffened concrete-filled steel columns.” J. Struct. Eng. 128 (9): 1222–1230. https://doi.org/10.1061/(ASCE)0733-9445(2002)128:9(1222).
Huang, H., A. Zhang, Y. Li, and M. Chen. 2011. “Experimental research and finite element analysis on mechanical performance of concrete-filled stiffened square steel tubular stub columns subjected to axial compression.” [In Chinese.] J. Build. Eng. 32 (2): 75–82.
Lee, H. J., I. R. Choi, and H. G. Park. 2016. “Eccentric compression strength of rectangular concrete-filled tubular columns using high-strength steel thin plates.” J. Struct. Eng. 143 (5): 04016228. https://doi.org/10.1061/(ASCE)ST.1943-541X.0001724.
Lee, H. J., H. G. Park, and I. R. Choi. 2019. “Compression loading test for concrete-filled tubular columns with high-strength steel slender section.” J. Constr. Steel Res. 159 (Aug): 507–520. https://doi.org/10.1016/j.jcsr.2019.04.040.
Liang, Q. Q., and B. Uy. 2000. “Theoretical study on the post-local buckling of steel plates in concrete-filled box columns.” Comput. Struct. 75 (5): 479–490. https://doi.org/10.1016/S0045-7949(99)00104-2.
Liu, J., Y. Teng, Y. Zhang, X. Wang, and Y. F. Chen. 2018. “Axial stress-strain behavior of high-strength concrete confined by circular thin-walled steel tubes.” Constr. Build. Mater. 177 (Aug): 366–377. https://doi.org/10.1016/j.conbuildmat.2018.05.021.
Mander, J. B., M. J. Priestley, and R. Park. 1988. “Theoretical stress-strain model for confined concrete.” J. Struct. Eng. 114 (8): 1804–1826. https://doi.org/10.1061/(ASCE)0733-9445(1988)114:8(1804).
MOHURD (Ministry of Housing and Urban-Rural Development of the People’s Republic of China). 2014. Technical code for concrete filled steel tubular structures. [In Chinese.] GB50936. Beijing: MOHURD.
O’Shea, M. D., and R. Q. Bridge. 2000. “Design of circular thin-walled concrete filled steel tubes.” J. Struct. Eng. 126 (11): 1295–1303. https://doi.org/10.1061/(ASCE)0733-9445(2000)126:11(1295).
Park, R. 1988. “Ductility evaluation from laboratory and analytical testing.” In Vol. 8 of Proc., 9th World Conference on Earthquake Engineering, 605–616. Tokyo: International Association for Earthquake Engineering.
Petrus, C., H. A. Hamid, A. Ibrahim, and G. Parke. 2010. “Experimental behaviour of concrete filled thin walled steel tubes with tab stiffeners.” J. Constr. Steel Res. 66 (7): 915–922. https://doi.org/10.1016/j.jcsr.2010.02.006.
Richart, F. E., A. Brandtzaeg, and R. L. Brown. 1928. A study of the failure of concrete under combined compressive stresses. Urbana, IL: Univ. of Illinois at Urbana Champaign.
Tao, Z., L. H. Han, and D. Y. Wang. 2008. “Strength and ductility of stiffened thin-walled hollow steel structural stub columns filled with concrete.” Thin Wall Struct. 46 (10): 1113–1128. https://doi.org/10.1016/j.tws.2008.01.007.
Tao, Z., L. H. Han, and Z. B. Wang. 2005. “Experimental behaviour of stiffened concrete-filled thin-walled hollow steel structural (HSS) stub columns.” J. Constr. Steel Res. 61 (7): 962–983. https://doi.org/10.1016/j.jcsr.2004.12.003.
Uy, B. 2000. “Strength of concrete filled steel box columns incorporating local buckling.” J. Struct. Eng. 126 (3): 341–352. https://doi.org/10.1061/(ASCE)0733-9445(2000)126:3(341).
Wang, X., J. Liu, and S. Zhang. 2015. “Behavior of short circular tubed-reinforced-concrete columns subjected to eccentric compression.” Eng. Struct. 105 (Dec): 77–86. https://doi.org/10.1016/j.engstruct.2015.10.001.
Wang, Y. T., J. Cai, and Y. L. Long. 2017. “Hysteretic behavior of square CFT columns with binding bars.” J. Constr. Steel Res. 131 (Apr): 162–175. https://doi.org/10.1016/j.jcsr.2017.01.001.
Wei, J., X. Luo, Z. Lai, and A. H. Varma. 2020. “Experimental behavior and design of high-strength circular concrete-filled steel tube short columns.” J. Struct. Eng. 146 (1): 04019184. https://doi.org/10.1061/(ASCE)ST.1943-541X.0002474.
Wu, B., X. Y. Zhao, and J. S. Zhang. 2012. “Cyclic behavior of thin-walled square steel tubular columns filled with demolished concrete lumps and fresh concrete.” J. Constr. Steel Res. 77 (Oct): 69–81. https://doi.org/10.1016/j.jcsr.2012.05.003.
Xiong, M., D. Xiong, and J. Liew. 2017. “Behaviour of steel tubular members infilled with ultra high strength concrete.” J. Constr. Steel Res. 138 (Nov): 168–183. https://doi.org/10.1016/j.jcsr.2017.07.001.
Yang, Y., Y. Wang, and F. Fu. 2014. “Effect of reinforcement stiffeners on square concrete-filled steel tubular columns subjected to axial compressive load.” Thin Wall Struct. 82 (Sep): 132–144. https://doi.org/10.1016/j.tws.2014.04.009.
Zhou, Z., D. Gan, and X. Zhou. 2019. “Improved composite effect of square concrete-filled steel tubes with diagonal binding ribs.” J. Struct. Eng. 145 (10): 04019112. https://doi.org/10.1061/(ASCE)ST.1943-541X.0002400.
Zhu, J. Y., and T. M. Chan. 2018. “Experimental investigation on octagonal concrete filled steel stub columns under uniaxial compression.” J. Constr. Steel Res. 147 (Aug): 457–467. https://doi.org/10.1016/j.jcsr.2018.04.030.
Information & Authors
Information
Published In
Copyright
© 2021 American Society of Civil Engineers.
History
Received: Jul 10, 2020
Accepted: Mar 9, 2021
Published online: May 11, 2021
Published in print: Jul 1, 2021
Discussion open until: Oct 11, 2021
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.