Uncoupled Compression Membrane Analysis of Reinforced-Concrete Members Subject to Extreme Loads
Publication: Journal of Structural Engineering
Volume 146, Issue 9
Abstract
An analytical procedure was developed to predict the compression membrane behavior of laterally restrained reinforced concrete members subject to extreme loads, such as those generated by the loss of bearing elements or during the application of excessive lateral loadings (e.g., explosions and impact). The procedure is based on the simplifying assumption that flexure and arching calculations can be uncoupled and that beam growth due to flexure after cracking can be approximated using rigid body rotation of beam half-segments. A lumped inelasticity flexure analysis is first performed to determine the degree of contact between the beam end and lateral support. The arching contribution to load capacity is computed by considering equilibrium of the contact zone arising from the projection of the beam into a partially rigid support. The total compression membrane strength is taken as the superposition of flexure and arching strength components. The methodology can handle supports with both rigid and nonrigid lateral restraint and varying degrees of rotational fixity. The numerical procedure has been verified extensively against the results of laterally restrained beam-column assembly and slab tests reported in the literature. The methodology can be used to model arching action under quasi-static conditions, or for inelastic dynamic analysis of structures subjected to blast and impact, provided high strain rate material properties are incorporated.
Get full access to this article
View all available purchase options and get full access to this article.
References
Algola, K., L. Weekes, and L. Augusthus-Nelson. 2016. “A new mitigation scheme to resist progressive collapse of RC structures.” Constr. Build. Mater. 125 (Oct): 533–545. https://doi.org/10.1016/j.conbuildmat.2016.08.084.
Alogla, K., L. Weekes, and L. Augusthus-Nelson. 2017. “Theoretical assessment of progressive collapse capacity of reinforced concrete structures” Mag. Concr. Res. 69 (3): 145–162. https://doi.org/10.1680/jmacr.16.00319.
Bao, Y., S. K. Kunnath, S. El-Tawil, and H. S. Lew. 2008. “Macromodel-based simulation of progressive collapse: RC frame structures.” J. Struct. Eng. 134 (7): 1079–1091. https://doi.org/10.1061/(ASCE)0733-9445(2008)134:7(1079).
Biggs, J. M. 1964. Introduction to structural dynamics. New York: McGraw-Hill.
Choi, H., and J. Kim. 2011. “Progressive collapse-resisting capacity of RC beam-column sub-assemblage.” Mag. Concr. Res. 63 (4): 297–310. https://doi.org/10.1680/macr.9.00170.
Dusenberry, D. O. 2010. Handbook of blast resistant design of buildings. Hoboken, NJ: Wiley.
Eyre, J. R. 1997. “Direct assessment of safe strengths of RC slabs under membrane action.” J. Struct. Eng. 123 (10): 1331–1338. https://doi.org/10.1061/(ASCE)0733-9445(1997)123:10(1331).
Eyre, J. R., and K. O. Kemp. 1994. “In-plane stiffness of reinforced concrete slabs under compressive membrane action.” Mag. Concr. Res. 46 (166): 67–77. https://doi.org/10.1680/macr.1994.46.166.67.
FarhangVesali, N., H. Valipour, B. Samali, and S. Foster. 2013. “Development of arching action in longitudinally-restrained reinforced concrete beams.” Constr. Build. Mater. 47 (Oct): 7–19. https://doi.org/10.1016/j.conbuildmat.2013.04.050.
Harry, O. A. 2018. “Behavior of reinforced concrete frame structure against progressive collapse.” Ph.D. thesis, Institute for Infrastructure and the Environment, Univ. of Edinburgh.
Hognestad, E. 1951. Study of combined bending and axial load in reinforced concrete members. Champaign, IL: Univ. of Illinois.
Hon, A. 2004. “Compressive membrane action in reinforced concrete beam-and-slab bridge decks.” Ph.D. thesis, Dept. of Civil Engineering, Monash Univ.
Jacques, E. 2011. “Blast retrofit of reinforced concrete walls and slabs.” M.A.Sc. thesis, Dept. of Civil Engineering, Univ. of Ottawa.
Jacques, E. 2012. “RCBLAST (Version 0.5.1) [Computer program].” Accessed January 11, 2018. http://www.rcblast.ca/.
Jacques, E., A. Lloyd, P. Imbeau, D. Palermo, and J. Quek. 2015. “GFRP retrofitted reinforced concrete columns subjected to simulated blast loading.” J. Struct. Eng. 141 (11): 04015028. https://doi.org/10.1061/(ASCE)ST.1943-541X.0001251.
Jacques, E., A. Lloyd, and M. Saatcioglu. 2012. “Predicting reinforced concrete response to blast loads.” Can. J. Civ. Eng. Special Issue on Innovations and IT 39 (5): 1–18. https://doi.org/10.1139/L2012-014.
Jacques, E., and M. Saatcioglu. 2016. Blind simulation of blast loaded slabs using RCBlast software, analytical and finite element concrete material models—Comparison of blast response analysis of one-way slabs with experimental data, edited by G. Thiagarajan and E. Williamson. Farmington Hills, MI: ACI.
Jacques, E., and M. Saatcioglu. 2019. “Bond-slip modelling of reinforced concrete lap splices subjected to low and high strain rates.” Eng. Struct. 195 (Sep): 568–578. https://doi.org/10.1016/j.engstruct.2019.05.104.
Kadhom, B. 2016. “Blast performance of reinforced concrete columns protected by FRP laminates.” Ph.D. thesis, Dept. of Civil Engineering, Univ. of Ottawa.
Lahlouh, E. H., and P. Waldron. 1992. “Membrane action in one-way spanning strips.” Proc. Inst. Civ. Eng. Struct. Build. 94 (4): 419–429.
Lloyd, A. 2010. “Performance of reinforced concrete columns under shock tube induced shock wave loading.” M.A.Sc. thesis, Dept. of Civil Engineering, Univ. of Ottawa.
Muthu, K. U., K. Amarnath, A. Ibrahim, and H. Mattarneh. 2007. “Load deflection behaviour of partially restrained slab strips.” Elsevier Eng. Struct. 29 (5): 663–674. https://doi.org/10.1016/j.engstruct.2006.05.017.
Nav, F. M., N. Usefi, and R. Abbasina. 2018. “Analytical investigation of reinforced concrete frames under middle column removal scenario.” SAGE Adv. Struct. Eng. 21 (9): 1388–1401. https://doi.org/10.1177/1369433217746343.
Park, R., and W. L. Gamble. 2000. Reinforced concrete slabs. New York: Wiley.
Ranklin, G. I. B., and A. E. Long. 1997. “Arching action strength enhancement in laterally-restrained slab strips.” Proc. Inst. Civ. Eng. Struct. Build. 122 (4): 461–467. https://doi.org/10.1680/istbu.1997.29834.
Ren, P., Y. Li, X. Lu, H. Guan, and Y. Zhou. 2016. “Experimental investigation of progressive collapse resistance of one-way reinforced concrete beam-slab substructures under a middle-column-removal scenario.” Eng. Struct. 118 (Jul): 28–40. https://doi.org/10.1016/j.engstruct.2016.03.051.
Ruddle, M. E., G. I. B. Rankin, and A. E. Long. 2003. “Arching action–Flexural and shear strength enhancements in rectangular and tee beams.” Proc. Inst. Civ. Eng. Struct. Build. 156 (Feb): 63–74. https://doi.org/10.1680/stbu.2003.156.1.63.
Sasani, M., A. Kazemi, S. Sagiroglu, and S. Forest. 2011. “Progressive collapse resistance of an actual 11-story structure subjected to severe initial damage.” J. Struct. Eng. 137 (9): 893–902. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000418.
Sasani, M., and J. Kropelnicki. 2008. “Progressive collapse analysis of an RC structure.” Struct. Des. Tall Special Build. 17 (4): 757–771. https://doi.org/10.1002/tal.375.
Su, Y., Y. Tian, and X. Song. 2009. “Progressive collapse resistance of axially-restrained frame beams.” ACI Struct. J. 106 (5): 600–607.
Taylor, S. E., and B. Mullin. 2006. “Arching action in FRP reinforced concrete slabs.” Constr. Build. Mater. 20 (1–2): 71–80. https://doi.org/10.1016/j.conbuildmat.2005.06.039.
Taylor, S. E., G. I. B. Rankin, and D. J. Cleland. 2001. “Arching action in high strength concrete slabs.” Proc. Inst. Civ. Eng. Struct. Build. 146 (4): 353–362. https://doi.org/10.1680/stbu.2001.146.4.353.
Unified Facilities Code (UFC). 2002. Design and analysis of hardened structures to conventional weapons effects. Washington, DC: United States of America Dept. of Defense.
Unified Facilities Code (UFC). 2008. Structures to resist the effects of accidental explosions. Washington, DC: United States of America Dept. of Defense.
USACE. 2008a. Methodology manual for the single-degree-of-freedom blast effects design spreadsheets (SBEDS). Washington, DC: USACE.
USACE. 2008b. User’s guide for the single-degree-of-freedom blast effects design spreadsheets (SBEDS). Washington, DC: USACE.
Vecchio, F. J., and K. Tang. 1990. “Membrane action in reinforced concrete slabs.” Can. J. Civ. Eng. 17 (5): 698–704. https://doi.org/10.1139/l90-083.
Vessali, N. 2015. “Compressive membrane action in reinforced concrete beams.” Ph.D. thesis, School of Civil and Environmental Engineering, Univ. of Technology Sydney.
Wang, G., Q-X. Wang, and Z-J. Li. 2011. “Membrane action in lateral restraint reinforced concrete slabs.” J. Central South Univ. Technol. 18 (2): 550–557. https://doi.org/10.1007/s11771-011-0730-6.
Wu, S. 2013. “Rational modeling of arching action in laterally restrained beams.” M.A.Sc thesis, Graduate Dept. of Civil Engineering, Univ. of Toronto.
Xiao, H., and B. Hedegaard. 2018. “Flexural compressive arch, and catenary mechanisms in pseudostatic progressive collapse analysis.” J. Perform. Constr. Facil. 32 (1): 04017115. https://doi.org/10.1061/(ASCE)CF.1943-5509.0001110.
Yu, J., and K.-H. Tan. 2013. “Structural behavior of reinforced concrete beam-column sub-assemblages under a middle column removal scenario.” J. Struct. Eng. 139 (2): 233–250. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000658.
Yu, J., and K.-H. Tan. 2014. “Special detailing techniques to improve structural resistance against progressive collapse.” J. Struct. Eng. 140 (3): 04013077. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000886.
Zheng, Y., D. Robinson, S. Taylor, D. Cleland, and A. Shaat. 2008. “Analysis of compressive membrane action in concrete slabs.” Proc. Inst. Civ. Eng. Bridge Eng. 161 (1): 21–31. https://doi.org/10.1680/bren.2008.161.1.21.
Information & Authors
Information
Published In
Copyright
©2020 American Society of Civil Engineers.
History
Received: Aug 30, 2018
Accepted: Mar 4, 2020
Published online: Jun 30, 2020
Published in print: Sep 1, 2020
Discussion open until: Nov 30, 2020
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.