Effects of Strain Rate on the Hysteretic Behavior of Buckling-Restrained Braces
Publication: Journal of Structural Engineering
Volume 146, Issue 1
Abstract
Two groups of geometrically identical buckling-restrained braces (BRBs) were subjected to either dynamic or quasi-static uniaxial loading until the cores fractured to investigate the effect of the strain rate on the hysteretic behavior of BRBs. The test results show that the compression overstrength of the BRBs is significantly greater in dynamic loading than in quasi-static loading. This finding indicates that neglecting the strain-rate effect on BRBs is nonconservative. No obvious effect of the strain rate on the cumulative deformation capacity of BRBs was observed during testing. The results thus support a previously proposed empirical model for estimating the cumulative deformation capacity of BRBs.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
We are grateful to Professor Yu Jiao at Tokyo City University and Professor Xiaodong Ji at Tsinghua University for their helpful discussions in analyzing the test data. We are also grateful to the anonymous reviewers for their insightful and detailed comments that helped improve the paper. This work was jointly supported by the Scientific Research Fund of the Institute of Engineering Mechanics, China Earthquake Administration (Grant No. 2016A05), and the National Natural Science Foundation of China (Grant No. 51878629). Their financial support is greatly appreciated.
References
AISC. 2010. Seismic provisions for structural steel buildings. AISC 341. Chicago: AISC.
Carden L., A. Itani, I. Buckle, and I. Aiken. 2004. “Buckling restrained braces for ductile end cross frames in steel plate girder bridges.” In Vol. 503 of Proc. 13th World Conf. on Earthquake Engineering. Tokyo: International Association for Earthquake Engineering.
Chen, W., Y. Gao, X. Y. Gao, and X. Y. Zhou. 2009. “Experiments on concrete-tube buckling restrained brace.” [In Chinese.] Constr. Des. Project 9: 30–34.
Gao, X. Y., H. Y. Du, H. Zhang, and F. Liang. 2008. “Experimental study on seismic performance of buckling restrained braces made of Q235 hot-rolled steel in China.” [in Chinese.] Build. Struct. 38 (3): 91–95.
Gao, X. Y., Y. G. Wang, D. H. Liu, and J. W. Xu. 2010. “Static tests on buckling restrained brace made of hot-rolled steel angle with strengthened ends. Experiments on concrete-tube buckling restrained brace.” J. Build. Struct. 31 (3): 77–82.
Hasegawa, H., T. Takeuchi, M. Iwata, S. Yamada, and H. Akiyama. 1999. “Experimental study on dynamic behaviour of unbonded-braces.” [In Japanese.] AIJ J. Technol. Des. 9: 103–106. https://doi.org/10.3130/aijt.5.103.
Huang, H. T., X. J. Yin, X. Y. Gao, M. Tu, X. L. Gao, N. Wu, and J. Ren. 2010. “Static test studies on full-scale buckling-restrained brace specimens with quasi-cross section of steel angles.” [In Chinese.] Supplement, China Civ. Eng. J. 43 (S2): 164–169.
Jiao, Y., S. Yamada, S. Kishiki, and Y. Shimada. 2011. “Evaluation of plastic energy dissipation capacity of steel beams suffering ductile fracture under various loading histories.” Earthquake Eng. Struct. Dyn. 40 (14): 1553–1570. https://doi.org/10.1002/eqe.1103.
Lanning, J., G. Benzoni, and C. M. Uang. 2016. “Using buckling-restrained braces on long-span bridges. I: Full-scale testing and design implications.” J. Bridge Eng. 21 (5): 04016001. https://doi.org/10.1061/(ASCE)BE.1943-5592.0000781.
Manjoine, M. J. 1944. “Influence of rate of strain and temperature on yield stress of mild steel.” Transaction Am. Soc. Mech. Eng. 66 (4): A211–A218.
Qu, Z., J. J. Xie, T. Wang, and S. Kishiki. 2017. “Cyclic loading test of double K-braced reinforced concrete frame subassemblies with buckling restrained braces.” Eng. Struct. 139 (May): 1–14. https://doi.org/10.1016/j.engstruct.2017.02.040.
Shing, P. S. B., and S. Mahin. 1988. “Rate-of-loading effects of pseudodynamic tests.” J. Struct. Eng. 114 (11): 2403–2420. https://doi.org/10.1061/(ASCE)0733-9445(1988)114:11(2403).
Takeuchi, T., M. Ida, S. Yamada, and K. Suzuki. 2008. “Estimation of cumulative deformation capacity of buckling restrained braces.” J. Struct. Eng. 134 (5): 822–831. https://doi.org/10.1061/(ASCE)0733-9445(2008)134:5(822).
Tremblay, R., P. Bolduc, R. Neville, and R. DeVall. 2006. “Seismic testing and performance of buckling-restrained bracing systems.” Can. J. Civ. Eng. 33 (2): 183–198. https://doi.org/10.1139/l05-103.
Wang, Y. G., and E. X. Gao. 2012. “Experimental study on end enhanced double-steel tube buckling-restrained brace.” [In Chinese.] World Earthquake Eng. 28 (4): 122–130.
Wu, A. C., P. C. Lin, and K. C. Tsai. 2014. “High-mode buckling responses of buckling-restrained brace core plates.” Earthquake Eng. Struct. Dyn. 43 (3): 375–393. https://doi.org/10.1002/eqe.2349.
Yamaguchi, M., S. Yamada, Y. Matsumoto, K. Tanigawa, M. Ono, T. Takeuchi, N. Ogawa, and H. Akiyama. 2002. “Full-scale shaking table test of damage tolerant structure with a buckling resistant brace.” [In Japanese.] J. Struct. Constr. Eng. 558: 189–196. https://doi.org/10.3130/aijs.67.189_2.
Information & Authors
Information
Published In
Copyright
©2019 American Society of Civil Engineers.
History
Received: Aug 27, 2018
Accepted: Jun 4, 2019
Published online: Oct 31, 2019
Published in print: Jan 1, 2020
Discussion open until: Mar 31, 2020
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.