Improved Composite Effect of Square Concrete-Filled Steel Tubes with Diagonal Binding Ribs
Publication: Journal of Structural Engineering
Volume 145, Issue 10
Abstract
This paper proposes a scheme to improve the structural behavior of square concrete-filled steel tubular (CFST) columns, in which diagonal binding ribs are welded at all the four pairs of adjacent sides of the square tube. Thus, both the confinement from the stiffened square steel tube to the infilled concrete and local buckling behavior of the tube can be enhanced. The diagonal binding ribs made of perforated thin-walled steel plates can facilitate concreting and enhance the integrity of the columns. This kind of composite columns is called diagonal rib–stiffened square CFST columns in this paper. Nineteen specimens with the tube width:thickness ratios between 50 and 150 were tested under axial compression to investigate the effect of thicknesses, opening dimensions and opening shapes of the stiffeners. In addition, square CFST specimens without stiffeners and octagonal CFST specimens and square CFST specimens with longitudinal stiffeners on each tube face were also tested for comparison. Test results showed that the diagonal binding ribs can improve the composite effect effectively by cocarrying the axial compression force and confining both the steel tube and concrete. The diagonal binding ribs can increase load-carrying capacity by 10%–20% and ductility by 30% or more compared with the CFST specimens without stiffeners. The diagonal rib–stiffened square CFST columns also behaved better than the octagonal CFST specimens and square CFST specimens with longitudinal stiffeners. Finally, two calculating methods which well predict the axial load-carrying capacities of diagonal ribs stiffened square CFST columns are recommended.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors greatly appreciate the financial support provided by the National Natural Science Foundation of China (Nos. 51878097 and 51890902), and the Fundamental Research Funds for the Central Universities (No. 2018CDQYTM0043). However, the opinions expressed in this paper are solely the authors’ own.
References
AIJ (Architectural Institute of Japan). 1997. Recommendations for design and construction of concrete filled steel tubular structures. Tokyo: AIJ.
AISC (American Institute of Steel Construction). 2016. Specification for structural steel buildings. ANSI/AISC 360. Chicago: AISC.
CEN (European Committee for Standardization). 2004. Eurocode 4: Design of composite steel and concrete structures. Part 1.1: General rules and rules for building. BS EN 1994-1-1. London: CEN.
Denavit, M. T., J. F. Hajjar, T. Perea, and R. T. Leon. 2016. “Stability analysis and design of composite structures.” J. Struct. Eng. 142 (3): 04015157. https://doi.org/10.1061/(ASCE)ST.1943-541X.0001434.
DHURD (Department of Housing and Urban-Rural Development). 2010. Technical specification for concrete-filled steel tubular structures. [In Chinese.] DBJ/T 13-51-2010. Fuzhou, China: DHURD.
Gan, D., Z. Zhou, X. H. Zhou, and J. Li. 2017. “Finite element analysis on axial loading behavior of stub columns of square concrete-filled steel tube with diagonal ribs.” [In Chinese.] Supplement, J. Build. Struct. 38 (S1): 210–217.
Ge, H., and T. Usami. 1992. “Strength of concrete-filled thin-walled steel box columns: Experiment.” J. Struct. Eng. 118 (11): 3036–3054. https://doi.org/10.1061/(ASCE)0733-9445(1992)118:11(3036).
Han, L. H., W. Li, and R. Bjorhovde. 2014. “Developments and advanced applications of concrete-filled steel tubular (CFST) structures: Members.” J. Constr. Steel Res. 100 (Sep): 211–228. https://doi.org/10.1016/j.jcsr.2014.04.016.
Huang, C. S., Y. K. Yeh, G. Y. Liu, H. T. Hu, K. C. Tsai, Y. T. Weng, S. H. Wang, and M. H. Wu. 2002. “Axial load behavior of stiffened concrete-filled steel columns.” J. Struct. Eng. 128 (9): 1222–1230. https://doi.org/10.1061/(ASCE)0733-9445(2002)128:9(1222).
Kitada, T. 1998. “Ultimate strength and ductility of state-of-the-art concrete-filled steel bridge piers in Japan.” Eng. Struct. 20 (4): 347–354. https://doi.org/10.1016/S0141-0296(97)00026-6.
Lai, Z., and A. H. Varma. 2018. “High-strength rectangular CFT members database, modeling, and design of short columns.” J. Struct. Eng. 144 (5): 04018036. https://doi.org/10.1061/(ASCE)ST.1943-541X.0002026.
Lie, T. T., and V. K. R. Kodur. 1996. “Fire resistance of circular steel columns filled with bar-reinforced concrete.” J. Struct. Eng. 122 (1): 30–36. https://doi.org/10.1061/(ASCE)0733-9445(1996)122:1(30).
Liew, J. Y. R., and D. X. Xiong. 2012. “Ultra-high strength concrete filled composite columns for multi-storey building construction.” Adv. Struct. Eng. 15 (9): 1487–1503. https://doi.org/10.1260/1369-4332.15.9.1487.
Lume, G., K. J. R. Rasmussen, Z. Tao, and L. H. Han. 2017. “Experimental behaviour of high-strength thin-walled concrete filled steel tubular stub columns.” In Proc., EUROSTEEL, 1976–1985. Hoboken, NJ: Wiley.
Mander, J. B., M. J. N. Priestley, and R. Park. 1988. “Theoretical stress-strain model for confined concrete.” J. Struct. Eng. 114 (8): 1804–1826. https://doi.org/10.1061/(ASCE)0733-9445(1988)114:8(1804).
MOHURD (Ministry of Housing and Urban-Rural Development of the People’s Republic of China). 2010. Code for seismic design of buildings. [In Chinese.] GB50011. Beijing: MOHURD.
MOHURD (Ministry of Housing and Urban-Rural Development of the People’s Republic of China). 2014. Technical code for concrete filled steel tubular structures. [In Chinese.] GB50936. Beijing: MOHURD.
Park, R. 1988. “State of the art report ductility evaluation from laboratory and analytical testing.” In Vol. 8 of Proc., 9th World Conf. on Earthquake Engineering, 713–718. Tokyo: Japan Association for Earthquake Disaster Prevention.
Sakino, K., H. Nakahara, S. Morino, and I. Nishiyama. 2004. “Behavior of centrally loaded concrete-filled steel-tube short columns.” J. Struct. Eng. 130 (2): 180–188. https://doi.org/10.1061/(ASCE)0733-9445(2004)130:2(180).
Susantha, K. A. S., H. B. Ge, and T. Usami. 2001a. “A capacity prediction procedure for concrete-filled steel columns.” J. Earthquake Eng. 5 (4): 483–520. https://doi.org/10.1080/13632460109350403.
Susantha, K. A. S., H. B. Ge, and T. Usami. 2001b. “Uniaxial stress-strain relationship of concrete confined by various shaped steel tubes.” Eng. Struct. 23 (10): 1331–1347. https://doi.org/10.1016/S0141-0296(01)00020-7.
Tao, Z., L. H. Han, and D. Y. Wang. 2008. “Strength and ductility of stiffened thin-walled hollow steel structural stub columns filled with concrete.” Thin-Walled Struct. 46 (10): 1113–1128. https://doi.org/10.1016/j.tws.2008.01.007.
Tao, Z., L. H. Han, and Z. B. Wang. 2005. “Experimental behaviour of stiffened concrete-filled thin-walled hollow steel structural (HSS) stub columns.” J. Constr. Steel Res. 61 (7): 962–983. https://doi.org/10.1016/j.jcsr.2004.12.003.
Wang, Y. T., J. Cai, and Y. L. Long. 2017. “Hysteretic behavior of square CFT columns with binding bars.” J. Constr. Steel Res. 131 (Apr): 162–175. https://doi.org/10.1016/j.jcsr.2017.01.001.
Xiong, M. X., D. X. Xiong, and J. Y. R. Liew. 2017. “Axial performance of short concrete filled steel tubes with high- and ultra-high-strength materials.” Eng. Struct. 136 (Apr): 494–510. https://doi.org/10.1016/j.engstruct.2017.01.037.
Yang, Y., Y. Wang, and F. Fu. 2014. “Effect of reinforcement stiffeners on square concrete-filled steel tubular columns subjected to axial compressive load.” Thin-Walled Struct. 82 (Sep): 132–144. https://doi.org/10.1016/j.tws.2014.04.009.
Zhang, J. G., Y. J. Liu, J. Yang, and K. L. Xu. 2011. “Experimental research and finite element analysis of concrete-filled steel box columns with longitudinal stiffeners.” Adv. Mater. Res. 287–290: 1037–1042.
Zhang, S., L. Guo, Z. Ye, and Y. Wang. 2005. “Behavior of steel tube and confined high strength concrete for concrete-filled RHS tubes.” Adv. Struct. Eng. 8 (2): 101–116. https://doi.org/10.1260/1369433054037976.
Zhang, Y., C. Xu, and X. Lu. 2007. “Experimental study of hysteretic behaviour for concrete-filled square thin-walled steel tubular columns.” J. Constr. Steel Res. 63 (3): 317–325. https://doi.org/10.1016/j.jcsr.2006.04.014.
Zhou, X. H., Z. Zhou, and D. Gan. 2018. “Cyclic testing of square tubed-reinforced-concrete column to RC beam joints.” Eng. Struct. 176 (Dec): 439–454. https://doi.org/10.1016/j.engstruct.2018.09.053.
Information & Authors
Information
Published In
Copyright
©2019 American Society of Civil Engineers.
History
Received: Nov 6, 2018
Accepted: Mar 3, 2019
Published online: Aug 10, 2019
Published in print: Oct 1, 2019
Discussion open until: Jan 10, 2020
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.