Development of Pressure-Impulse Diagrams for Framed PVB-Laminated Glass Windows
Publication: Journal of Structural Engineering
Volume 145, Issue 3
Abstract
This paper investigates isodamage criteria for framed PVB (polyvinyl butyral) laminated glass panels subjected to blast load. Isodamage criteria are presented in the form of pressure-impulse (P-I) diagrams, and a methodology for the generation of the P-I diagrams for laminated glass was developed based on numerical simulation studies and the energy method. Three damage levels were classified in accordance with the conditions identified in standards, namely (1) the glass crack limit, (2) the PVB rupture limit, and (3) overall detachment with a specific velocity after the PVB ruptures. Based on nonlinear finite-element analysis, the governing failure modes of the glass panel in both impulsive and quasi-static regions for each damage level were identified and the corresponding deflection functions were determined. A simplified PVB tensile bar model is proposed to describe the local tensile failure of PVB laminated glass corresponding to Damage Level III under impulsive loading. The pressure and impulse asymptotes of framed PVB-laminated glass for different damage levels were derived using the energy balance principle. The proposed method was validated through comparison with published experimental data and further numerical results. This method can provide a reference for engineering design and hazard estimation of framed PVB-laminated glass against blast loading and can be extended to laminated glazing with other interlayers.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors gratefully acknowledge the financial support by the National Natural Science Foundation of China under Grant No. 51678448 and the State Key Laboratory of Disaster Reduction in Civil Engineering, Tongji University under Grant No. SLDRCE 14-B-13.
References
ASTM. 2012a. Standard practice for determining load resistance of glass in buildings. ASTM-E1300. West Conshohocken, PA: ASTM.
ASTM. 2012b. Standard practice for specifying an equivalent 3-second duration design loading for blast resistant glazing fabricated with laminated glass. ASTM-F2248. West Conshohocken, PA: ASTM.
Baker, W. E. 1983. Explosion hazards and evaluation. Amsterdam, Netherlands: Elsevier.
Bennison, S. J., J. G. Sloan, D. F. Kristunas, P. J. Buehler, T. Amos, and C. A. Smith. 2005. “Laminated glass for blast mitigation: Role of interlayer properties.” In Proc., Glass Performance Days. Tampere, Finland.
Biggs, J. M. 1964. Introduction to structural dynamics. New York: McGraw-Hill.
BSI (British Standards Institution). 2012. Glass in building—Security glazing—Testing and classification of resistance against explosion pressure. BS EN 13541. London: BSI.
Chen, S., X. Chen, and X. Wu. 2018. “The mechanical behaviour of polyvinyl butyral at intermediate strain rates and different temperatures.” Constr. Build. Mater. 182: 66–79. https://doi: 10.1016/j.conbuildmat.2018.06.080.
Chen, S., C. G. Zhu, G. Q. Li, and Y. Lu. 2016. “Blast test and numerical simulation of point-supported glazing.” Adv. Struct. Eng. 19 (12): 1841–1854. https://doi.org/10.1177/1369433216649387.
Cormie, D., G. C. Mays, and P. D. Smith. 2009. Blast effects on buildings. 2nd ed. London: Thomas Telford.
Ge, J., G. Q. Li, and S. W. Chen. 2012. “Theoretical and experimental investigation on fragment behavior of architectural glass panel under blast loading.” Eng. Failure Anal. 26 (12): 293–303. https://doi.org/10.1016/j.engfailanal.2012.07.022.
GSA (General Services Administration). 2003. Standard test method for glazing and window systems subject to dynamic overpressure loadings. GSA-TS01. Washington, DC: GSA.
Hetherington, J., and P. Smith. 1994. Blast and ballistic loading of structures. Boca Raton, FL: CRC Press.
Hidallana-Gamage, H. D., D. P. Thambiratnam, and N. J. Perera. 2014. “Numerical modelling and analysis of the blast performance of laminated glass panels and the influence of material parameters.” Eng. Failure Anal. 45 (8): 65–84. https://doi.org/10.1016/j.engfailanal.2014.06.013.
Hidallana-Gamage, H. D., D. P. Thambiratnam, and N. J. Perera. 2017. “Influence of the negative phase and support flexibility on the blast response of laminated glass panels.” Constr. Build. Mater. 154 (11): 462–481. https://doi.org/10.1016/j.conbuildmat.2017.07.231.
Hooper, P. A., R. A. M. Sukhram, B. R. K. Blackman, and J. P. Dear. 2012. “On the blast resistance of laminated glass.” Int. J. Solids Struct. 49 (6): 899–918. https://doi.org/10.1016/j.ijsolstr.2011.12.008.
ISO. 2007a. Glass in building—Explosion-resistant security glazing—Test and classification by shock-tube loading. ISO 16934. Geneva: ISO.
ISO. 2007b. Glass in building—Explosion-resistant security glazing—Test and classification for arena air-blast loading. ISO 16933. Geneva: ISO.
Iwasaki, R., C. Sato, J. L. Latailladeand, and P. Viot. 2007. “Experimental study on the interface fracture toughness of PVB (polyvinyl butyral)/glass at high strain rates.” Int. J. Crashworthiness 12 (3): 293–298. https://doi.org/10.1080/13588260701442249.
Jarrett, D. E. 1968. “Derivation of the British explosives safety distances.” Ann. N.Y. Acad. Sci. 152 (1): 18–35. https://doi.org/10.1111/j.1749-6632.1968.tb11963.x.
Krauthammer, T., and A. Altenberg. 2000. “Negative phase blast effects on glass panels.” Int. J. Impact Eng. 24 (1): 1–17. https://doi.org/10.1016/S0734-743X(99)00043-3.
Larcher, M., M. Arrigoni, C. Bedon, A. V. Doormaal, C. Haberacker, G. Hüsken, O. Millon, A. Saarenheimo, G. Solomos, and L. Thamie. 2016. “Design of blast-loaded glazing windows and façades: A review of essential requirements towards standardization.” Adv. Civ. Eng. 2016: 14. https://doi.org/10.1155/2016/2604232.
Larcher, M., G. Solomos, F. Casadei, and N. Gebbeken. 2012. “Experimental and numerical investigations of laminated glass subjected to blast loading.” Int. J. Impact Eng. 39 (1): 42–50. https://doi.org/10.1016/j.ijimpeng.2011.09.006.
Laura, P. A. A., and C. A. Rossit. 2001. “The behavior of sandwich structures of isotropic and composite materials: by Jack R. Vinson; 1999, TECHNOMIC Publishing Company, Inc., Lancaster, PA, USA, 378 pp.” Ocean Eng. 28 (10): 1437–1438. https://doi.org/10.1016/S0029-8018(01)00013-0.
Li, Q. M., and H. Meng. 2002. “Pressure-impulse diagram for blast loads based on dimensional analysis and single-degree-of-freedom model.” J. Eng. Mech. 128 (1): 87–92. https://doi.org/10.1061/(ASCE)0733-9399(2002)128:1(87).
Livermore Software Technology. 2007. LS-DYNA keyword user’s manual. Livermore, CA: Livermore Software Technology.
Merrifield, R. 1993. Simplified calculations of blast induced injuries and damage. Bootle, UK: Health and Safety Executive, Technology and Health Sciences Division.
Nawar, M., H. Salim, B. Lusk, and S. Kiger. 2015. “Modeling and shock tube testing of architectural glazing systems for blast resistance.” J. Struct. Eng. 141 (7): 04014174. https://doi.org/10.1061/(ASCE)ST.1943-541X.0001130.
Norville, H. S., N. C. Harvill, J. Edward, S. Shariat, and S. Mallonee. 1999. “Glass-related injuries in Oklahoma City Bombing.” J. Perform. Constr. Facil. 13 (2): 50–56. https://doi.org/10.1061/(ASCE)0887-3828(1999)13:2(50).
Pelfrene, J., J. Kuntsche, S. V. Dam, W. V. Paepegem, and J. Schneider. 2016. “Critical assessment of the post-breakage performance of blast loaded laminated glazing: Experiments and simulations.” Int. J. Impact Eng. 88 (2): 61–71.
Shi, Y., H. Hao, and Z. X. Li. 2008. “Numerical derivation of pressure–impulse diagrams for prediction of RC column damage to blast loads.” Int. J. Impact Eng. 35 (11): 1213–1227. https://doi.org/10.1016/j.ijimpeng.2007.09.001.
Spiller, K., J. A. Packer, M. V. Seica, and D. Z. Yankelevsky. 2016. “Prediction of annealed glass window response to blast loading.” Int. J. Impact Eng. 88 (2): 189–200. https://doi.org/10.1016/j.ijimpeng.2015.10.010.
Teich, M., and N. Gebbeken. 2010. “The influence of the underpressure phase on the dynamic response of structures subjected to blast loads.” Int. J. Protective Struct. 1 (2): 219–233. https://doi.org/10.1260/2041-4196.1.2.219.
Timmel, M., S. Kolling, P. Osterrieder, and P. A. D. Bois. 2007. “A finite element model for impact simulation with laminated glass.” Int. J. Impact Eng. 34 (8): 1465–1478. https://doi.org/10.1016/j.ijimpeng.2006.07.008.
Timoshenko, S. P. 1940. Vol. 6 of Theory of plates and shells: Studies in mathematics & its applications, 606. Amsterdam, Netherlands: Elsevier.
UFC (Unified Facilities Criteria). 2013. DoD minimum antiterrorism standards for buildings. UFC 4-010-01. Washington, DC: USACE.
Weggel, D. C., and B. J. Zapata. 2008. “Laminated glass curtain walls and laminated glass lites subjected to low-level blast loading.” J. Struct. Eng. 134 (3): 466–477. https://doi.org/10.1061/(ASCE)0733-9445(2008)134:3(466).
Weggel, D. C., B. J. Zapata, and M. J. Kiefer. 2013. “Properties and dynamic behavior of glass curtain walls with split screw spline mullions.” J. Struct. Eng. 133 (10): 1415–1425. https://doi.org/10.1061/(ASCE)0733-9445(2007)133:10(1415).
Wei, J., and L. R. Dharani. 2005. “Fracture mechanics of laminated glass subjected to blast loading.” Theor. Appl. Fract. Mech. 44 (2): 157–167. https://doi.org/10.1016/j.tafmec.2005.06.004.
Wei, J., and L. R. Dharani. 2006. “Response of laminated architectural glazing subjected to blast loading.” Int. J. Impact Eng. 32 (12): 2032–2047. https://doi.org/10.1016/j.ijimpeng.2005.05.012.
Zhang, X., H. Hao, and G. Ma. 2013. “Parametric study of laminated glass window response to blast loads.” Eng. Struct. 56 (6): 1707–1717. https://doi.org/10.1016/j.engstruct.2013.08.007.
Zhang, X., H. Hao, Y. Shi, and J. Cui. 2015a. “The mechanical properties of polyvinyl butyral (PVB) at high strain rates.” Constr. Build. Mater. 93 (9): 404–415. https://doi.org/10.1016/j.conbuildmat.2015.04.057.
Zhang, X., Y. Zou, H. Hao, X. Li, G. Ma, and K. Liu. 2012. “Laboratory test on dynamic material properties of annealed float glass.” Int. J. Protective Struct. 3 (4): 407–430. https://doi.org/10.1260/2041-4196.3.4.407.
Zhang, X. H., H. Hao, and Z. Q. Wang. 2015b. “Experimental study of laminated glass window responses under impulsive and blast loading.” Int. J. Impact Eng. 78 (4): 1–19. https://doi.org/10.1016/j.ijimpeng.2014.11.020.
Information & Authors
Information
Published In
Copyright
©2018 American Society of Civil Engineers.
History
Received: Aug 12, 2017
Accepted: Aug 10, 2018
Published online: Dec 24, 2018
Published in print: Mar 1, 2019
Discussion open until: May 24, 2019
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.