Global Seismic Damage Model of RC Structures Based on Structural Modal Properties
Publication: Journal of Structural Engineering
Volume 144, Issue 10
Abstract
A macroscopic global seismic damage model is proposed for reinforced concrete structures by considering the dynamic modal contributions. Modal damage is defined using the concepts of dynamic modal stiffness and modal mass. Based on the kinetic energy inequality for damaged systems, a normalization method is chosen for the proposed modal mass contribution factor, which reflects the fluctuation of modal damage caused by a change in modal shape. Assuming an in-series independence between the modal damages, a customized combination rule is suggested. Global damage curves generated from the proposed model (PM) tend to have a segmented evolution, composed of a zero-damage segment, an acceleration segment, a constant velocity segment, a deceleration segment, and a converged segment, following the general damage evolution rule. The results from a case study indicate that the PM can explain the dynamic transition in the modal damage and exhibits a distinct convergence with the increasing peak ground acceleration level and number of modes included. The proposed damage model is proven to have a good correlation with the results from the incremental dynamic analysis at the collapse-critical point, indicating a potential application as a promising collapse criterion. The results have also confirmed the effectiveness of the five-segment damage evolution curve proposed previously.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research was financially supported by the National Natural Science Foundation of China (Grant Nos. 91315301 and 51261120376).
References
Baker, J. W. 2011. “Conditional mean spectrum: Tool for ground-motion selection.” J. Struct. Eng. 137 (3): 322–331. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000215.
Boore, D. M., and G. M. Atkinson. 2008. “Ground-motion prediction equations for the average horizontal component of PGA, PGV, and 5%-damped PSA at spectral periods between 0.01s and 10.0s.” Earthquake Spectra 24 (1): 99–138. https://doi.org/10.1193/1.2830434.
Cao, V. V., H. R. Ronagh, M. Ashraf, and H. Baji. 2014. “A new damage index for reinforced concrete structures.” Earthquake Struct. 6 (6): 581–609. https://doi.org/10.12989/eas.2014.6.6.581.
Carrillo, J. 2015. “Damage index based on stiffness degradation of low-rise RC walls.” Earthquake Eng. Struct. Dyn. 44 (6): 831–848. https://doi.org/10.1002/eqe.2488.
Chen, B., and Y. L. Xu. 2007. “A new damage index for detecting sudden change of structural stiffness.” Struct. Eng. Mech. 26 (3): 315–341. https://doi.org/10.12989/sem.2007.26.3.315.
China Architecture and Building Press. 2010. Code for seismic design of buildings. [In Chinese.] GB50011-2010. Beijing: China Architecture and Building Press.
Chopra, A. K., and R. K. A. Goel. 2002. “Modal pushover analysis procedure for estimating seismic demands for buildings.” Earthquake Eng. Struct. Dyn. 31 (3): 561–582. https://doi.org/10.1002/eqe.144.
Das, S., P. Saha, and S. K. Patro. 2016. “Vibration-based damage detection techniques used for health monitoring of structures: A review.” J. Civ. Struct. Health Monit. 6 (3): 477–507. https://doi.org/10.1007/s13349-016-0168-5.
DiPasquale, E., and A. S. Cakmak. 1989. On the relation between local and global damage indices. Buffalo, NY: National Center for Earthquake Engineering Research.
Doebling, S. W., C. R. Farrar, M. B. Prime, and D. W. Shevitz. 1996. Damage identification and health monitoring of structural and mechanical systems from changes in their vibration characteristics: A literature review. Los Alamos, NM: Los Alamos National Laboratory.
Fan, W., and P. Qiao. 2010. “Vibration-based damage identification methods: A review and comparative study.” Struct. Health Monit. 9 (3): 83–111.
FEMA (Federal Emergency Management Agency). 1997. NEHRP commentary on the guidelines for the rehabilitation of buildings. Washington, DC: FEMA.
FEMA (Federal Emergency Management Agency). 2012. Seismic performance assessment of buildings. Washington, DC: FEMA.
Ghobarah, A., H. Abou-Elfath, and A. Biddah. 1999. “Response-based damage assessment of structure.” Earthquake Eng. Struct. Dyn. 28 (1): 79–104. https://doi.org/10.1002/(SICI)1096-9845(199901)28:1%3C79::AID-EQE805%3E3.0.CO;2-J.
Guo, X., and Z. He. 2016. “Correlation between local stiffness degradation, modal damage and global damage of the shear-type RC frames.” In Proc., 7th Int. Forum on Advances in Structural Engineering. Beijing: China Architecture & Building Press.
He, Z., X. Y. Ou, and J. P. Ou. 2014. “A macro-level global seismic damage model with consideration of higher modes.” Earthquake Eng. Eng. Vib. 13 (3): 425–436. https://doi.org/10.1007/s11803-014-0253-x.
He, Z., Z. Y. Zhu, X. Guo, T. T. Liu, and Y. T. Hu. 2017. “Development of a macroscopic global seismic damage model for lattice shell structures.” J. Struct. Eng. 143 (2): 04016174. https://doi.org/10.1061/(ASCE)ST.1943-541X.0001668.
Ji, X., G. L. Fenves, K. Kajiwara, and M. Nakashima. 2011. “Seismic damage detection of a full-scale shaking table test Structure.” J. Struct. Eng. 137 (1): 14–21. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000278.
Krawinkler, H. 2002. Seismic demand analysis. Berkeley, CA: Pacific Earthquake Engineering Research Center.
Maity, D., and R. R. Tripathy. 2005. “Damage assessment of structures from changes in natural frequencies using genetic algorithm.” Struct. Eng. Mech. 19 (1): 21–42. https://doi.org/10.12989/sem.2005.19.1.021.
Massumi, A., and E. Moshtagh. 2013. “A new damage index for RC buildings based on variations of nonlinear fundamental period.” Struct. Des. Tall Spec. Build. 22 (1): 50–61. https://doi.org/10.1002/tal.656.
Mergos, P. E., and A. J. Kappos. 2013. “A combined local damage index for seismic assessment of existing RC structures.” Earthquake Eng. Struct. Dyn. 42 (6): 833–852. https://doi.org/10.1002/eqe.2247.
Messina, A., E. J. Williams, and T. Contursi. 1998. “Structural damage detection by a sensitivity and statistical-based method.” J. Sound Vibr. 216 (5): 791–808. https://doi.org/10.1006/jsvi.1998.1728.
Moehle, J., and G. G. Deierlein. 2004. “A framework methodology for performance-based earthquake engineering.” In Proc., 13th World Conf. on Earthquake Engineering (13WCEE). Vancouver, BC, Canada: Canadian Association for Earthquake Engineering.
Nair, K. K., and A. S. Kiremidjian. 2007. Damage diagnosis algorithm for wireless structural health monitoring. Stanford, CA: Stanford Univ.
Noh, H., and A. S. Kiremidjian. 2010. “On the use of wavelet coefficient energy for structural damage diagnosis.” In Proc., 10th Int. Conf. on Structural Safety and Reliability, edited by H. Furuta, D. Frangopol, and M. Shinozuka. London: Taylor & Francis. CD-ROM.
Noh, H., D. G. Lignos, K. K. Nair, and A. S. Kiremidjian. 2012. “Development of fragility functions as a damage classification/prediction method for steel moment-resisting frames using a wavelet-based damage sensitive feature.” Earthquake Eng. Struct. Dyn. 41 (4): 681–696. https://doi.org/10.1002/eqe.1151.
Noh, H. Y., K. K. Nair, D. G. Lignos, and A. S. Kiremidjian. 2011. “Use of wavelet-based damage-sensitive features for structural damage diagnosis using strong motion data.” J. Struct. Eng. 137 (10): 1215–1228. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000385.
Park, Y. J., A. H. S. Ang, and Y. K. Wen. 1985. “Seismic damage analysis of reinforced concrete buildings.” J. Struct. Eng. 111 (4): 740–757. https://doi.org/10.1061/(ASCE)0733-9445(1985)111:4(740).
PEER (Pacific Earthquake Engineering Research Center). 2017. PEER strong motion database. Berkeley, CA: Pacific Earthquake Engineering Research Center.
Scotta, R., L. Tesser, R. Vitaliani, and A. Saetta. 2009. “Global damage indexes for the seismic performance assessment of RC structures.” Earthquake Eng. Struct. Dyn. 38 (8): 1027–1049. https://doi.org/10.1002/eqe.882.
SEAOC (Structural Engineering Association of California). 1995. Vision 2000: Performance-based seismic engineering of buildings. Sacramento, CA: SEAOC.
Shi, W. X., Y. Wang, and C. Q. Liu. 2007. “Damage analysis of high-rise building under seismic load based on frequency measurement.” [In Chinese.] J. Southwest Jiaotong Univ. 42 (4): 389–394.
Sohn, H., C. R. Farrar, F. M. Hemez, D. D. Shunk, D. W. Stinemates, B. R. Nadler, and J. J. Czarnecki. 2004. A review of structural health monitoring literature: 1996–2001. Los Alamos, NM: Los Alamos National Laboratory.
Sohn, H., and K. H. Law. 2001. “Damage diagnosis using experimental Ritz vectors.” J. Eng. Mech. 127 (11): 1184–1193. https://doi.org/10.1061/(ASCE)0733-9399(2001)127:11(1184).
Tjhin, T., M. Aschheim, and E. Hernández-Montes. 2005. “Estimates of peak roof displacement using ‘equivalent’ single degree of freedom systems.” J. Struct. Eng. 131 (3): 517–522. https://doi.org/10.1061/(ASCE)0733-9445(2005)131:3(517).
Vafaei, M., S. C. Alih, A. B. A. Rahman, and A. B. Adnan. 2015. “A wavelet-based technique for damage quantification via mode shape decomposition.” Struct. Infrastruct. Eng. 11 (7): 869–883. https://doi.org/10.1080/15732479.2014.917114.
Vamvatsikos, D., and C. A. Cornell. 2002. “Incremental dynamic analysis.” Earthquake Eng. Struct. Dyn. 31 (3): 491–514. https://doi.org/10.1002/eqe.141.
Whalen, T. M. 2008. “The behavior of higher order mode shape derivatives in damaged, beam-like structures.” J. Sound Vibr. 309 (3): 426–464. https://doi.org/10.1016/j.jsv.2007.07.054.
Zhu, H. W., K. P. Wang, and S. G. Tang. 2004. “Modal damage index and its application in structure damage assessment.” [In Chinese.] J. Tongji Univ. (Nat. Sci.) 32 (12): 1589–1592.
Information & Authors
Information
Published In
Copyright
©2018 American Society of Civil Engineers.
History
Received: Apr 22, 2017
Accepted: Apr 4, 2018
Published online: Jul 11, 2018
Published in print: Oct 1, 2018
Discussion open until: Dec 11, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.