Fragility Analysis of Base-Isolated Liquid Storage Tanks under Random Sinusoidal Base Excitation Using Generalized Polynomial Chaos Expansion–Based Simulation
Publication: Journal of Structural Engineering
Volume 142, Issue 10
Abstract
Generalized polynomial chaos (gPC) expansion–based simulation technique is used to investigate the influence of input parameter uncertainty, on peak response quantities and fragility curves of base-isolated liquid storage tanks. Unidirectional horizontal sinusoidal base excitation is considered to develop the fragility curves for the base-isolated liquid storage tanks. Extensively used laminated rubber bearing (LRB), with linear force-deformation behavior, is considered as the isolation system. The liquid storage tank is modeled using a widely accepted lumped mass model. The failure of the liquid storage tank is defined corresponding to the elastic buckling of the tank wall. The uncertainties are considered in the isolator parameters and in the base excitation. Considerable difference in the peak response estimation is observed when the input parameters are represented using different probability distributions, especially when the uncertainties are higher. It is also observed that when the uncertainties in the input parameters increase, probability of failure at given amplitude of the excitation increases. It is demonstrated that the probability of failure estimated using gPC expansion–based simulations closely matches the same obtained through the direct Monte Carlo (MC) simulations. Significant influence of the time period of the isolation system is observed on the fragility curves of the base-isolated liquid storage tanks. However, isolation damping has a marginal effect on the fragility curves of the base-isolated liquid storage tanks.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors thank the anonymous reviewers for their valuable comments and suggestions to improve the quality of the presented work.
References
Buckle, I. G., and Mayes, R. L. (1990). “Seismic isolation: History, application, and performance—A world view.” Earthquake Spectra, 6(2), 161–201.
Choi, E., DesRoches, R., and Nielson, B. (2004). “Seismic fragility of typical bridges in moderate seismic zones.” Eng. Struct., 26(2), 187–199.
Deb, S. K. (2004). “Seismic base isolation—An overview.” Curr. Sci., 87(10), 1426–1430.
Ghanem, R., and Spanos, P. D. (1990). “Polynomial chaos in stochastic finite elements.” J. Appl. Mech., 57(1), 197–202.
Gupta, S., and Manohar, C. S. (2006). “Reliability analysis of randomly vibrating structures with parameter uncertainties.” J. Sound Vib., 297(3–5), 1000–1024.
Haroun, M. A., and Housner, G. W. (1981). “Earthquake response of deformable liquid storage tanks.” J. Appl. Mech., 48(2), 411–418.
HAZUS. (1999). “Earthquake loss estimation methodology.” Federal Emergency Management Agency (FEMA), Technical Rep., National Institute of Building Science, Risk Management Solution, Menlo Park, CA.
Huh, J., and Haldar, A. (2002). “Seismic reliability of non-linear frames with PR connections using systematic RSM.” Probab. Eng. Mech., 17(2), 177–190.
Ibrahim, R. A. (2008). “Recent advances in nonlinear passive vibration isolators.” J. Sound Vib., 314(3–5), 371–452.
Iervolino, I., Fabbrocino, G., and Manfredi, G. (2004). “Fragility of standard industrial structures by a response surface based method.” J. Earthquake Eng., 8(6), 927–945.
Jacob, C. M., Sepahvand, K., Matsagar, V. A., and Marburg, S. (2013). “Stochastic seismic response of an isolated building.” 〈http://web.iitd.ac.in/∼matsagar/EqDataBase.htm〉 (Jul. 9, 2014).
Jangid, R. S., and Datta, T. K. (1995). “Seismic behavior of base-isolated buildings: A state-of-the-art-review.” Struct. Build., 110(2), 186–203.
Kelly, J. M. (1986). “Aseismic base isolation: Review and bibliography.” Soil Dyn. Earthquake Eng., 5(4), 202–216.
Kim, M. K., Lim, Y. M., Cho, S. Y., Cho, K. H., and Lee, K. W. (2002). “Seismic analysis of base-isolated liquid storage tanks using the BE-FE-BE coupling technique.” Soil Dyn. Earthquake Eng., 22(9), 1151–1158.
Malhotra, P. K. (1997). “Method for seismic base isolation of liquid-storage tanks.” J. Struct. Eng., 113–116.
Matsagar, V. A., and Jangid, R. S. (2004). “Influence of isolator characteristics on the response of base-isolated structures.” Eng. Struct., 26(12), 1735–1749.
Mavronicola, E., and Komodromos, P. (2011). “Assessing the suitability of equivalent linear elastic analysis of seismically isolated multi-storey buildings.” Comput. Struct., 89(21–22), 1920–1931.
Mishra, S. K., and Chakraborty, S. (2013). “Performance of a base-isolated building with system parameter uncertainty subjected to a stochastic earthquake.” Int. J. Acoust. Vib., 18(1), 7–19.
Mishra, S. K., Roy, B. K., and Chakraborty, S. (2013). “Reliability-based-design-optimization of base isolated buildings considering stochastic system parameters subjected to random earthquakes.” Int. J. Mech. Sci., 75, 123–133.
Okada, J., Iwata, K., Tsukimori, K., and Nagata, T. (1995). “An evaluation method for elastic-plastic buckling of cylindrical shells under shear forces.” Nucl. Eng. Des., 157(1–2), 65–79.
O’Rourke, M. J., and So, P. (2000). “Seismic fragility curves for on-grade steel tanks.” Earthquake Spectra, 16(4), 801–815.
Padgett, J. E., Nielson, B. G., and DesRoches, R. (2008). “Selection of optimal intensity measures in probabilistic seismic demand models of highway bridge portfolios.” Earthquake Eng. Struct. Dyn., 37(5), 711–725.
Ranganathan, R. (2000). Structural reliability analysis and design, Jaico Publishing House, New Delhi, India.
Razzaghi, M. S., and Eshgi, S. (2008). “Development of analytical fragility curves for cylindrical steel oil tanks.” 14th World Conf. on Earthquake Engineering, Beijing.
Saha, S. K., and Matsagar, V. A. (2015). “Reliability of base-isolated liquid storage tanks under horizontal base excitation.” Numerical methods for reliability and safety assessment: Multiscale and multiphysics systems, S. Kadry and A. El Hami, Springer, Switzerland, 305–328.
Saha, S. K., Matsagar, V. A., and Jain, A. K. (2013a). “Seismic fragility of base-isolated industrial tanks.” Reliability, Risk and Life-Cycle Performance of Structures and Infrastructures—Proc., 11th Int. Conf. on Structural Safety and Reliability, Taylor & Francis Group, London, 4289–4296.
Saha, S. K., Matsagar, V. A., and Jain, A. K. (2014). “Earthquake response of base-isolated liquid storage tanks for different isolator models.” J. Earthquake Tsunami, 8(5), 22.
Saha, S. K., Sepahvand, K., Matsagar, V. A., Jain, A. K., and Marburg, S. (2013b). “Stochastic analysis of base-isolated liquid storage tanks with uncertain isolator parameters under random excitation.” Eng. Struct., 57, 465–474.
Salzano, E., Iervolino, I., and Fabbrocino, G. (2003). “Seismic risk of atmospheric storage tanks in the framework of quantitative risk analysis.” J. Loss Prev. Process Ind., 16(5), 403–409.
Schuëller, G. I. (1997). “A state-of-the-art report on computational stochastic mechanics.” Probab. Eng. Mech., 12(4), 197–321.
Sepahvand, K. (2009). “Uncertainty quantification in stochastic forward and inverse vibration problems using generalized polynomial chaos expansion.” Ph.D. thesis, Technische Universität Dresden, Dresden, Germany.
Sepahvand, K., Marburg, S., and Hardtke, H.-J. (2010). “Uncertainty quantification in stochastic systems using polynomial chaos expansion.” Int. J. Appl. Mech., 2(2), 305–353.
Shrimali, M. K., and Jangid, R. S. (2002). “Seismic response of liquid storage tanks isolated by sliding bearings.” Eng. Struct., 24(7), 909–921.
Sudret, B. (2008). “Global sensitivity analysis using polynomial chaos expansions.” Reliab. Eng. Syst. Saf., 93(7), 964–979.
Sudret, B., and Mai, V.-C. (2013). “Computing seismic fragility curves using polynomial chaos expansions.” Reliability, Risk and Life-Cycle Performance of Structures and Infrastructures—Proc., 11th Int. Conf. on Structural Safety and Reliability, Taylor & Francis Group, London, 3337–3344.
Unnikrishnan, V. U., Prasad, A. M., and Rao, B. N. (2013). “Development of fragility curves using high-dimensional model representation.” Earthquake Eng. Struct. Dyn., 42(3), 419–430.
Xiu, D., and Karniadakis, G. (2002). “The Wiener-Askey polynomial chaos for stochastic differential equations.” SIAM J. Sci. Comput., 24(2), 619–644.
Information & Authors
Information
Published In
Copyright
© 2016 American Society of Civil Engineers.
History
Received: Sep 19, 2014
Accepted: Jan 19, 2016
Published online: Apr 13, 2016
Discussion open until: Sep 13, 2016
Published in print: Oct 1, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.