Long-Term Behavior of Posttensioned Timber Connections
Publication: Journal of Structural Engineering
Volume 141, Issue 6
Abstract
Tests regarding the long-term behavior of posttensioned timber connections have been performed at the ETH in Zurich. The aim of these tests is to estimate the loss in tendon force that can be expected during the lifetime of a structure. Several posttensioned beam and beam-column timber specimens exposed to controlled and uncontrolled environmental conditions and loaded only with the axial prestressing force have been monitored for more than one year. The force in the tendon was measured together with the strains in the specimens and temperature and relative humidity in the testing environment. Creep tests performed on small glulam timber blocks loaded in compression have been started as well. The estimated creep coefficients parallel and perpendicular to the grain are used to calculate the losses with an analytical model for the larger posttensioned specimens. A prestressing loss in the range of 5–10%, depending on the geometrical properties and environmental conditions, has been found at the end of the one-year testing. Such a percentage is likely to increase up to 30% at the end of a 50-year service. Careful consideration has been given to identify the different variables affecting the losses of prestressing force in the long-term, including the environmental conditions. The tendon force losses were compared to the results obtained by a simple analytical model. A parametric study based on the model was performed in order to check whether the suggested ash reinforcement in the column is beneficial regarding tendon force losses in the long-term.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors gratefully acknowledge the financial support by the Swiss Commission for Technology and Innovation and the industrial support of Häring & Co. AG.
References
Bond, D., and Sidwell, E. (1965). “Prestressed timber beams.” Civ. Eng. (London), 60(705), 547–550.
Brady, J. F., Harte, A. M., and Arima, T. (2008). “Prestressed FRP flexural strengthening of softwood gluelaminated timber beams.” Proc., 10th World Conf. on Timber Engineering WCTE 2008, Curran Associates, Red Hook, NY.
Buchanan, A., Deam, B., Fragiacomo, M., Pampanin, S., and Palermo, A. (2008). “Multi-storey prestressed timber buildings in New Zealand.” Struct. Eng. Int., 18(2), 166–173.
Davies, M., and Fragiacomo, M. (2011). “Long-term behavior of prestressed LVL members. I: Experimental tests.” J. Struct. Eng., 1553–1561.
Deam, B. L., Fragiacomo, M., and Gross, L. S. (2008). “Experimental behavior of prestressed LVL-concrete composite beams.” J. Struct. Eng., 801–809.
European Committee for Standardization (CEN). (2004). “Design of timber structures. Part 1-1: General—Common rules and rules for buildings.” Eurocode 5, Brussels, Belgium.
European Committee for Standardization (CEN). (2009). “Structural timber—Strength classes.” DIN EN 338, German version, Brussels, Belgium.
Fragiacomo, M., and Batchelar, M. (2012). “Timber frame moment joints with glued-in steel rods. II: Experimental investigation of long-term performance.” J. Struct. Eng., 802–811.
Fragiacomo, M., and Davies, M. (2011). “Long-term behavior of prestressed LVL members. II: Analytical approach.” J. Struct. Eng., 1562–1572.
Frangi, A., Boccadoro, L., and Leyder, C. (2013). “Stark und zuverlässig wie Stahl.” Wir Holzbauer, 1(1), 12–15 (in German).
Hanhijärvi, A. (1995). Modelling of creep deformation mechanisms in wood, VTT Publications, VTT Building Technology, Helsinki, Finland.
Joint Committee on Structural Safety (JCSS). (2001). “Probabilistic model code. Part 3: Resistance models.” 〈http://www.jcss.byg.dtu.dk/Publications/Probabilistic_Model_Code〉.
Lantos, G. (1964). “Reinforced and post-tensioned glue laminated beams under development at Trada laboratories.” Civ. Eng. (London), 59(690), 86–87.
Mårtensson, A. (1994). “Mechano-sorptive effects in wooden material.” Wood Sci. Technol., 28(6), 437–449.
Muszyński, L., Rastislav, L., Shaler, S. M., and William, D. (2005). “Comments on the experimental methodology for determination of the hygro-mechanical properties of wood.” Holzforschung, 59(2), 232–239.
Oliva, M., and Dimakis, A. (1988). “Behavior of stress-laminated timber highway bridge.” J. Struct. Eng., 1850–1869.
Oliva, M. C., et al. (1987). “Development and use of stress laminated timber deck bridges.” Proc., Sessions at Structures Congress 1987 Related to Bridges and Transmission Line Structures, Structural Engineering Institute (SEI), Reston, VA.
Peterson, J. (1965). “Wood beams prestressed with bonded tension elements.” J. Struct. Div., 91(ST1), 103–119.
Quenneville, P., and Van Dalen, K. (1996). “Parameters affecting stress losses in stress-laminated timber bridge decks.” Proc., Int. Wood Eng. Conf., Vol. 2, Omnipress, Madison, WI, 376–381.
Sarisley, E. F., Jr., and Accorsi, M. L. (1990). “Prestress level in stress-laminated timber bridges.” J. Struct. Eng., 3003–3019.
Stahlton, A. G. (2012). Vorspanntechnik, 〈http://www.stahlton.ch〉 (Mar. 25, 2012).
Svensson, S., and Toratti, T. (2002). “Mechanical response of wood perpendicular to grain when subjected to changes of humidity.” Wood Sci. Technol., 36(2), 145–156.
Swiss Society of Engineers and Architects (SIA). (2003a). “Concrete structures.” SIA 262, Zurich, Switzerland.
Swiss Society of Engineers and Architects (SIA). (2003b). “Timber structures.” SIA 265, Zurich, Switzerland.
Toratti, T. (1992). “Creep of timber beams in a variable environment.”, Helsinki Univ. of Technology, Helsinki, Finland.
Toratti, T., and Svensson, S. (2000). “Mechano-sorptive experiments perpendicular to grain under tensile and compressive loads.” Wood Sci. Technol., 34(4), 317–326.
Triantafillou, T. C., Deskovic, N., and Deuring, M. (1992). “Strengthening of concrete structures with prestressed fiber reinforced plastic sheets.” ACI Struct. J., 89(3), 235–244.
Wanninger, F., and Frangi, A. (2014a). “Experimental analysis of a post-tensioned timber connection.” Materials and joints in timber structures, Springer, Heidelberg.
Wanninger, F., and Frangi, A. (2014b). “Experimental and analytical analysis of a post-tensioned timber connection under gravity loads.” Engineering structures, Elsevier, Amsterdam, Netherlands.
Wanninger, F., and Frangi, A. (2014c). “Investigation of a post-tensioned timber connection.” Institute of Structural Engineering, ETH Zurich, Zurich, Switzerland.
Information & Authors
Information
Published In
Journal of Structural Engineering
Volume 141 • Issue 6 • June 2015
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Dec 27, 2013
Accepted: May 29, 2014
Published online: Jul 28, 2014
Discussion open until: Dec 28, 2014
Published in print: Jun 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.