Analytical Element for Simulating Lateral-Strength Degradation in Reinforced Concrete Columns and Other Frame Members
Publication: Journal of Structural Engineering
Volume 140, Issue 7
Abstract
An analytical element is proposed that is capable of simulating the lateral-strength degradation behavior of frame members subjected to seismic loading up to severe loss in lateral strength. Although element capabilities allow simulating the behavior of a wide range of frame members exhibiting loss of lateral strength, they were developed with the behavior of shear-critical reinforced concrete columns in mind. The element consists of a zero-length shear spring that connects in series with a beam-column flexural element. The proposed element can dynamically monitor beam-column elements for user-defined limiting forces and flexural deformations, and initiate degradation when either is reached. Upon initiation of degradation, the material model governing the behavior of the zero-length shear spring changes its constitutive properties to include pinching, strength degradation, and stiffness degradation. Cycle-, energy-, and displacement-based damage accumulation methods were implemented to provide users with the necessary tools to model a variety of frame members. A novel flexural-deformation compensation algorithm was implemented in the element that automatically adjusts the shear-spring stiffness and backbone curve such that a symmetric member response is achieved. The versatile element is shown to possess the necessary capabilities to simulate the nonlinear shear behavior and strength degradation of select reinforced concrete columns with only a limited number of parameters calibrated.
Get full access to this article
View all available purchase options and get full access to this article.
References
ASCE/SEI. (2007). “Seismic rehabilitation of existing structures.”, Reston, VA.
Comerio, M. C., and Anagnos, T. (2012). “Los Angeles inventory: Implications for retrofit policies for nonductile concrete buildings.” Proc., 15th World Conf. on Earthquake Engineering, International Association for Earthquake Engineering, Tokyo, Japan.
Elwood, K. J. (2004). “Modeling failures in existing reinforced concrete columns.” Can. J. Civ. Eng., 31, 846–859.
Elwood, K. J., and Moehle, J. P. (2005). “Drift capacity of reinforced concrete columns with light transverse reinforcement.” Earthquake Spectra, 21(1), 71–89.
Esaki, F. (1996). “Reinforcing effect of steel plate hoops on ductility of r/c square columns.” Proc., 11th World Conf. on Earthquake Engineering, Paper No. 199, Elsevier Science, Amsterdam.
Ghannoum, W. M., and Moehle, J. P. (2012a). “Dynamic collapse analysis of a concrete frame sustaining column axial failures.” ACI Struct. J., 109(3), 403–412.
Ghannoum, W. M., and Moehle, J. P. (2012b). “Rotation-based shear failure model for lightly confined reinforced concrete columns.” J. Struct. Eng., 1267–1278.
Ghannoum, W. M., and Moehle, J. P. (2012c). “Shake-table tests of a concrete frame sustaining column axial failures.” ACI Struct. J., 109(3), 393–402.
Ghannoum, W. M., and Sivaramakrishnan, B. (2012a). “ACI 369 circular column database.” Data set, 〈http://www.nees.org/resour/3658〉 (2013).
Ghannoum, W. M., and Sivaramakrishnan, B. (2012b). “ACI 369 rectangular column database.” Data set.〈http://www.nees.org/resources/3659〉 (2013).
Haselton, C., Liel, A., Taylor Lange, S., and Deierlein, G. G. (2008). “Beam-column element model calibrated for predicting flexural response leading to global collapse of RC frame buildings.” Pacific Earthquake Engineering Research Center, Univ. of California, Berkeley, CA, 152.
Kam, W. Y., Pampanin, S., and Elwood, K. (2011). “Seismic performance of reinforced concrete buildings in the 22 February Christchurch (Lyttelton) earthquake.” Bull. New Zeal. Natl. Soc. Earthquake Eng., 44(4), 239–278.
Kaneko, Y., Mihashi, H., and Ishihara, S. (2001). “Entire load-displacement characteristics for direct shear failure of concrete.” Modeling of inelastic behavior of RC structures under seismic loads, ASCE, Reston, VA, 175–192.
Kato, D., and Ohnishi, K. (2002). “Axial load carrying capacity of R/C columns under lateral load reversals.” Proc., 3rd U.S.-Japan Workshop on Performance-Based Earthquake Engineering Methodology for Reinforced Concrete Building Structures, Pacific Earthquake Engineering Research Center, Berkeley, CA, 247–255.
LeBorgne, M. R. (2012). “Modeling the post shear failure behavior of reinforced concrete columns.” Ph.D. thesis, Univ. of Texas, Austin, TX.
Lynn, A. C. (2001). “Seismic evaluation of existing reinforced concrete building columns.” Ph.D. dissertation, Univ. of California, Berkeley, CA.
Massone, L. M., Orakcal, K., and Wallace, J. W. (2006). “Shear-flexure interaction for structural walls.”, American Concrete Institute, Farmington Hills, MI, 127–150.
Matchulat, L. (2009). “Mitigation of collapse risk in vulnerable concrete buildings.”, Univ. of Kansas, Lawrence, KS.
McKenna, F., Fenves, G. L., Scott, M. H., and Jeremie, B. (2000). “Open system for earthquake engineering simulation, OpenSEES.” 〈http://opensees.berkeley.edu/〉 (11, 2013).
Mitra, N., and Lowes, L. N. (2007). “Evaluation, calibration, and verification of a reinforced concrete beam—column joint model.” J. Struct. Eng., 105–120.
Mostafaei, H., and Kabeyasawa, T. (2007). “Axial-shear-flexure interaction approach for reinforced concrete columns.” ACI Struct. J., 104(2), 218–226.
Nagasaka, T. (1982). “Effectiveness of steel fiber as web reinforcement in reinforced concrete columns.” Japan Concrete Institute, Tokyo, 493–500.
Niwa, J., Ito, A., and Tanabe, T. (2001). “Lattice model prediction for ultimate deformation of RC columns subjected to cyclic loading.” Modeling of inelastic behavior of RC structures under seismic loads, ASCE, Reston, VA, 384–402.
Ohue, M., Morimoto, H., Fujii, S., and Morita, S. (1985). “Behavior of R.C. short columns failing in splitting bond-shear under dynamic lateral loading.” Trans. Japan Concr. Inst., 7, 293–300.
Otani, S. (1999). “RC building damage statistics and SDF response with design seismic forces.” Earthquake Spectra, 15(3), 485–501.
Otani, S., and Sozen, M. A. (1972). “Behavior of multistory reinforced concrete frames during earthquakes.” Univ. of Illinois, Urbana-Champaign, xxii, 551.
Ozbolt, J., Mayer, U., and Vocke, H. (2001). “Smeared fracture FE-analysis of reinforced concrete structures—theory and examples.” Modeling of inelastic behavior of RC structures under seismic loads, ASCE, Reston, VA, 234–256.
Panagiotakos, T. B., and Fardis, M. N. (2001). “Deformations of reinforced concrete members at yielding and ultimate.” ACI Struct. J., 98(2), 135–148.
Park, Y.-J., and Ang, A. H. S. (1985). “Mechanistic seismic damage model for reinforced concrete.” J. Struct. Eng., 722–739.
Pincheira, J. A., Dotiwala, F. S., and D’Souza, J. T. (1999). “Seismic analysis of older reinforced concrete columns.” Earthquake Spectra, 15(2), 245–272.
Pujol, S., Ramirez, J. A., and Sozen, M. A. (1999). “Drift capacity of reinforced concrete columns subjected to cyclic shear reversal.” Seismic Response of Concrete Bridges, Farmington Hills, MI, 255–274.
Pujol, S., Sozen, M. A., and Ramirez, J. A. (2006). “Displacement history effects on drift capacity of reinforced concrete columns.” ACI Struct. J., 103(2), 253–262.
Sasani, M. (2007). “Life-safety and near-collapse capacity models for seismic shear behavior of reinforced concrete columns.” ACI Struct. J., 104(1), 30–38.
Sezen, H. (2000). “Structural engineering reconnaissance of the August 17, 1999 earthquake: Kocaeli (Izmit), Turkey.” UCB/PEER, Univ. of California, Berkeley, xv, 157.
Sezen, H., and Moehle, J. P. (2006). “Seismic tests of concrete columns with light transverse reinforcement.” ACI Struct. J., 103(6), 842–849.
Sezen, H., and Moehle, J. P. (2004). “Shear strength model for lightly reinforced concrete columns.” J. Struct. Eng., 1692–1703.
Shing, P.-S. B., and Spencer, B. (2001). “Modeling of shear behavior of reinforced concrete bridge structures.” Modeling of inelastic behavior of RC structures under seismic loads, ASCE, Reston, VA, 315–333.
Spacone, E., Filippou, F. C., and Taucer, F. F. (1996). “Fibre beam-column model for non-linear analysis of R/C frames: Part I. Formulation.” Earthquake Eng. Struct. Dyn., 25(7), 711–725.
Takeda, T., Sozen, M. A., and Nielsen, N. N. (1970). “Reinforced concrete response to simulated earthquakes.” J. Struct. Div., 96(12), 2557–2573.
Watanabe, F., and Ichinose, T. (1992). “Strength and ductility of RC members subjected to combined bending and shear.” Concrete shear in earthquake, Elsevier Applied Science, New York, 429–438.
Yavari, S., Elwood, K. J., Lin, S., Wu, C.-L., Hwang, S., and Moehle, J. P. (2009a). “Experimental study on dynamic behavior of multi-story reinforced concrete frames with non-seismic detailing.” Proc., 2009 ATC and SEI Conf. on Improving the Seismic Performance of Existing Buildings and Other Structures, American Society of Civil Engineers, Reston, VA, 489–499.
Yavari, S., Elwood, K. J., and Wu, C.-L. (2009b). “Collapse of a nonductile concrete frame: Evaluation of analytical models.” Earthquake Eng. Struct. Dyn., 38(2), 225–241.
Zeris, C., and Mahin, S. (1991). “Behavior of reinforced concrete structures subjected to biaxial excitation.” J. Struct. Eng., 2657–2673.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Jul 12, 2012
Accepted: Aug 9, 2013
Published online: Aug 12, 2013
Published in print: Jul 1, 2014
Discussion open until: Aug 26, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.