Repair of Fire-Exposed Preloaded Rectangular Concrete Columns by Postcompressed Steel Plates
Publication: Journal of Structural Engineering
Volume 140, Issue 3
Abstract
This paper describes an experimental study of axially loaded, fire-exposed, rectangular RC columns repaired with postcompressed steel plates. Seven RC columns with identical section dimensions and reinforcement details were fabricated and tested. Six of these were exposed to a 4-h fire load according to the ISO 834 standard. After 1 month of cooling, five of the fire-exposed columns were installed with precambered steel plates, which were then postcompressed by a method newly developed by the authors. All columns were tested under axial compression to determine their ultimate load capacity, deformation, and ductility. The effects of steel-plate thickness, initial precamber displacements, and preloading level on the ultimate load capacity of repaired RC columns were investigated. The test results show that up to 72% of the original capacity of the axial load-carrying capacity of fire-exposed columns repaired with postcompressed steel plates can be restored. Furthermore, the repaired specimens show better ductility and postpeak deformability. An analytical model was adopted to predict the ultimate axial load capacity of fire-exposed columns repaired with postcompressed steel plates. The comparison of the theoretical and experimental results reveals that the analytical model can accurately predict the ultimate axial load capacity of the repaired columns.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The research described in this paper was supported by the Research Grants Council of the Hong Kong SAR (Project No. HKU7166/08E) and The University of Hong Kong through Small Project Funding 2010–2011.
References
Bisby, L. A., Kodur, V. K. R., and Green, M. F. (2004). “Numerical parametric studies on the fire endurance of fibre-reinforced-polymer-confined concrete columns.” Can. J. Civ. Eng., 31(6), 1090–1100.
British Standards Institution (BSI). (2002). “Test methods for determining the contribution to the fire resistance of structural members—Part 4: Applied protection to steel members.”, London.
Chen, Y. H., Chang, Y. F., Yao, G. C., and Sheu, M. S. (2009). “Experimental research on post-fire behaviour of reinforced concrete columns.” Fire Saf. J., 44(5), 741–748.
Chowdhury, E. U., Bisby, L. A., Green, M. F., and Kodur, V. K. R. (2007). “Investigation of insulated FRP-wrapped reinforced concrete columns in fire.” Fire Saf. J., 42(6), 452–460.
De Luca, A., Nardone, F., Matta, F., Nanni, A., Liqnola, G., and Prota, A. (2011). “Structural evaluation of full-scale FRP-confined reinforced concrete columns.” J. Compos. Constr., 112–123.
Dotreppe, J. C., et al. (1997). “Experimental research on the determination of the main parameters affecting the behavior of reinforced concrete columns under fire conditions.” Mag. Concr. Res., 49(179), 117–127.
Ersoy, U., Suleiman, R., and Tankut, T. (1993). “Behavior of jacketed columns.” ACI Struct. J., 90(3), 288–293.
European Committee for Standardization. (2004). “Design of concrete structure. Part 1.2: General rules—structural fire design.”, U.K.
Giménez, E., Adam, J. M., Ivorra, S., Moragues, J. J., and Calderón, P. A. (2009). “Full-scale testing of axially loaded RC columns strengthened by steel angles and strips.” Adv. Struct. Eng., 12(2), 169–181.
Han, C. G., Han, M. C., and Heo, Y. S. (2009). “Improvement of residual compressive strength and spalling resistance of high-strength RC columns subjected to fire.” Constr. Build. Mater., 23(1), 107–116.
Han, L. H. (2001). “Fire performance of concrete filled steel tubular beam-columns.” J. Constr. Steel Res., 57(6), 697–711.
Han, L. H., and Huo, J. S. (2003). “Concrete-filled hollow structural steel columns after exposure to ISO-834 fire standard.” J. Struct. Eng., 68–78.
Han, L. H., and Lin, X. K. (2004). “Tests on cyclic behavior of concrete-filled hollow structural steel columns after exposure to the ISO-834 standard fire.” J. Struct. Eng., 1807–1809.
Han, L. H., Yang, Y. F., and Xu, L. (2003a). “An experimental study and calculation on the fire resistance of concrete-filled SHS and RHS columns.” J. Constr. Steel Res., 59(4), 427–452.
Han, L. H., Yang, Y. F., Yang, H., and Huo, J. S. (2002). “Residual strength of concrete-filled RHS columns after exposure to the ISO-834 standard fire.” Thin-Walled Struct., 40(12), 991–1012.
Han, L. H., Zhao, X. Y., Yang, Y. F., and Feng, J. B. (2003b). “Experimental study and calculation of fire resistance of concrete-filled hollow steel columns.” J. Struct. Eng., 346–356.
Han, L. H., Zheng, Y. Q., and Teng, J. G. (2006). “Fire resistance of RC and FRP-confined RC columns.” Mag. Concr. Res., 58(8), 533–546.
ISO. (1975). “Fire resistance test—Elements of building construction.”, Geneva.
Jau, W. C., and Huang, K. L. (2008). “A study of reinforced concrete corner columns after fire.” Cem. Concr. Compos., 30(7), 622–638.
Karter, M. J. (2012). “Fire loss in the United States during 2011.”, National Fire Protection Association, Quincy, MA.
Kodur, V. K. R. (1998). “Performance of high strength concrete-filled steel columns exposed to fire.” Can. J. Civ. Eng., 25(6), 975–981.
Kodur, V. K. R. (1999). “Performance-based fire resistance design of concrete-filled steel columns.” J. Constr. Steel Res., 51(1), 21–26.
Kodur, V. K. R., Bisby, L. A., and Green, M. F. (2006). “Experimental evaluation of the fire behaviour of insulated fibre-reinforced-polymer-strengthened reinforced concrete columns.” Fire Saf. J., 41(7), 547–557.
Kodur, V. K. R., Cheng, F. P., Wang, T. C., and Sultan, M. A. (2003). “Effect of strength and fiber reinforcement on fire resistance of high-strength concrete columns.” J. Struct. Eng., 253–259.
Kodur, V. K. R., and Raut, N. K. (2009). “Design equation for predicting fire resistance of reinforced concrete columns.” Struct. Concr., 10(2), 73–86.
Kodur, V. K. R., Wang, T. C., and Cheng, F. P. (2004). “Predicting the fire resistance behaviour of high strength concrete columns.” Cem. Concr. Compos., 26(2), 141–153.
Li, G. Q., Lou, G. B., Zhang, C., Wang, L. L., and Wang, Y. C. (2012). “Assess the fire resistance of intumescent coatings by equivalent constant thermal resistance.” Fire Technol., 48(2), 529–546.
Lie, T. T. (1992). “Structural fire protection.”, ASCE, New York.
Lie, T. T., and Kodur, V. K. R. (1996). “Fire resistance of steel columns filled with bar-reinforced concrete.” J. Struct. Eng., 30–36.
Lin, C. H., Chen, S. T., and Yang, C. A. (1995). “Repair of fire-damaged reinforced concrete columns.” ACI Mater. J., 92(4), 406–411.
Raut, N. K., and Kodur, V. K. R. (2011). “Response of high-strength concrete columns under design fire exposure.” J. Struct. Eng, 69–79.
Su, R. K. L., Cheng, B., Wang, L., Siu, W. H., and Zhu, Y. (2011). “Use of bolted steel plates for strengthening of reinforced concrete beams and columns.” IES J. Part A: Civ. Struct. Eng., 4(2), 55–68.
Su, R. K. L., Siu, W. H., and Smith, S. T. (2010). “Effects of bolt-plate arrangements on steel plate strengthened reinforced concrete beams.” Eng. Struct., 32(6), 1769–1778.
Su, R. K. L., and Wang, L. (2012). “Axial strengthening of preloaded rectangular concrete columns by precambered steel plates.” Eng. Struct., 38(5), 42–52.
Takeuti, R. A., de Hanai, J. B., and Mirmiran, A. (2008). “Preloaded RC columns strengthened with high-strength concrete jackets under uniaxial compression.” Mater. Struct., 41(7), 1251–1262.
Tan, K. H., and Yao, Y. (2003). “Fire resistance of four-face heated reinforced concrete columns.” J. Struct. Eng., 1220–1229.
Tao, Z., and Han, L. H. (2007). “Behaviour of fire-exposed concrete-filled steel tubular beam columns repaired with CFRP wraps.” Thin-Walled Struct., 45(1), 63–76.
Tao, Z., Han, L. H., and Wang, L. L. (2007). “Compressive and flexural behaviour of CFRP-repaired concrete-filled steel tubes after exposure to fire.” J. Constr. Steel Res., 63(8), 1116–1126.
Tao, Z., Wang, Z. B., Han, L. H., and Brian, B. (2011). “Fire performance of concrete-filled steel tubular columns strengthened by CFRP.” Steel Compos. Struct., 11(4), 307–324.
Wang, L., and Su, R. K. L. (2012). “Experimental investigation of preloaded RC columns strengthened with precambered steel plates under eccentric compression loading.” Adv. in Struct. Eng., 15(8), 1253–1264.
Wang, L., and Su, R. K. L. (2013). “Theoretical and experimental study of plate-strengthened concrete columns under eccentric compression loading.” J. Struct. Eng., 350–359.
Wu, B., Hong, Z., Tang, G. H., and Wang, C. (2007). “Fire resistance of reinforced concrete columns with square cross section.” Adv. Struct. Eng., 10(4), 353–369.
Wu, B., and Xu, Y. Y. (2009). “Behavior of axially-and-rotationally restrained concrete columns with ‘+’-shaped cross section and subjected to fire.” Fire Saf. J., 44(2), 212–218.
Xu, Y. Y., and Wu, B. (2009). “Fire resistance of reinforced concrete columns with L-, T-, and +-shaped cross-sections.” Fire Saf. J., 44(6), 869–880.
Yaqub, M., and Bailey, C. G. (2011). “Fire resistance of steel columns filled with bar-reinforced concrete.” Constr. Build. Mater., 25(1), 359–370.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: May 29, 2012
Accepted: May 29, 2013
Published online: Nov 25, 2013
Published in print: Mar 1, 2014
Discussion open until: Apr 25, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.