Instability of Axially Loaded Compression Members under Lateral Rigid Body Excitations
Publication: Journal of Structural Engineering
Volume 137, Issue 10
Abstract
The global compressive capacity of steel members subject to lateral rigid body dynamic excitation is examined numerically with a dynamic nonlinear finite-element analytical algorithm that uses the implicit Newmark- integration procedure combined with the Newton-Raphson iterative scheme. The algorithm was validated with experimental results. Parametric studies on 180 box, tube, and shapes are presented. The members included initial geometric imperfections along their lengths. On the basis of the parametric study, a simplified formula for the buckling capacity of a steel member under lateral rigid body excitations is presented that may be considered for the use in the development of a design formula.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers are grateful to Dr. S. Kuranishi, Honorary Professor of Tohoku University who initiated this investigation. Financial aid provided by Japanese Kozai Club Research Foundation was gratefully acknowledged. The findings and conclusions of this paper; however, are those of the authors alone. The authors wish to thank Mr. R. Tanaka of the Graduate School of Engineering at the University of Ryukyu for some computer analyzes and plots. The numerical analysis was performed using the computer facilities of the Information Processing Center at the University of Ryukyu, Okinawa. The authors also appreciate the careful review and subsequent suggestions made by the reviewers of the original manuscript, which substantially improved the present paper.
References
Akamine, F. (1992). “Study on dynamic ultimate strength of beam-column members.” M.S. thesis, Graduate School of Engineering and Science, Univ. of Ryukyu, Okinawa, Japan.
AISC. (1994). Manual of steel construction, load and resistance factor design, 2nd Ed., AISC, Chicago.
Belieav, N. M. (1924). “Stability of prismatic rods subjected to variable longitudinal forces.” Engineering constructions and structural mechanics, 149–167.
Bolotin, V. V. (1964). The dynamic stability of elastic systems, Holden-Day, San Francisco.
European Committee for Standardization (CEN). (1992). “Design of steel structures.” Eurocode 3, Brussels.
Galambos, T. V., ed. (1998). “Guide to stability design criteria for metal structures.” Structural stability research council, 5th Ed., Wiley, New York.
Hutchinson, J. W. (1972). “On the post-buckling behavior of imperfection-sensitive structures in the plastic range.” J. Appl. Mech., 39(1), 155–162.
Japan Public Highway Association (JPHA). (2002). “Japan specifications for standard highway bridges. Part 2: Steel bridges.” JPHA, Tokyo (in Japanese).
Japan Society of Civil Engineers (JSCE). (1997). “Design code for steel structures-Part A; Structures in general, committee on steel structures.” F. Nishino, ed., JSCE, Tokyo.
Jones, N., and Reis, H. L. M. (1980). “On the dynamic buckling of a simple elastic-plastic model.” Int. J. Solids Struct., 16(11), 969–989.
Karagiozova, D., Alves, M., and Jones, N. (2000). “Inertia effects in axisymmetrically deformed cylindrical shells under axial impact.” Int. J. Impact Eng., 24(10), 1083–1115.
Karagiozova, D., and Jones, N. (2000). “Dynamic elastic-plastic buckling of circular cylindrical shells under axial impact.” Int. J. Solids Struct., 37(14), 2005–2034.
Kato, B., and Lu, L.-W. (1972). “Instability effects under dynamic and repeated load.” Proc., 1st Int. Conf. On Tall Buildings, Lehigh Univ., II, 59–77.
Khudada, A. E., and Geschwindner, L. F. (1997). “Nonlinear dynamic analysis of steel frames by modal superposition.” J. Struct. Eng., 123(11), 1519–1527.
Kishi, N., Ikeda, K., Koeda, H., and Komuro, M. (2002). “Effects of stress-strain relation on seismic performance of small steel-pipe pier models.” J. Struct. Mech. Earthquake Eng., 695(58), 45–60.
Kuranishi, S., and Nakajima, A. (1985). “Failure of elasto-plastic columns with initial crookedness in parametric resonance.” Proc., JSCE, Struct. Eng. Earthquake Eng., 2(1), 207–216.
Nakajima, A., Abe, H., Kuranishi, S., and Sano, T. (1992). “Evaluation of dynamic collapse of SDOF system with degrading restoring force characteristics under random excitation.” J. Struct. Eng. Earthquake Eng., JSCE, 9(1), 57s–64s.
Nakajima, A., Kuranishi, S., and Abe, H. (1987). “Dynamic failure of structures with structural instability.” J. Struct. Eng. Earthquake Eng., JSCE, 4(2), 351s–360s.
Tanaka, R. (2000). “Simplified model-evaluation on dynamic instability of steel-pipe-pier.” M.S. thesis, Graduate School of Engineering and Science, Univ. of Ryukyu, Okinawa, Japan.
Vian, D., and Bruneau, M. (2003). “Tests to structural collapse of single degree of freedom frames subjected to earthquake excitations.” J. Struct. Eng., 129(12), 1676–1685.
Yabuki, T., Akamine, F., Arizumi, Y., and Lu, L.-W. (2005). “Nonlinear effect on instability of steel columns under dynamic axial loads.” J. Struct. Eng., 131(12), 1832–1840.
Yabuki, T., Arizumi, Y., Gentile, C., and Lu, L. W. (2000). “Inelastic dynamic instabilities of steel columns.” Proc. of 7th Int. Symp. on Structural Failure and Plasticity (IMPLAST 2000), X L. Zhoa, and R. H. Grzebieta, eds., Elsevier Science, Oxford, UK, 527–532.
Information & Authors
Information
Published In
Copyright
© 2011 American Society of Civil Engineers.
History
Received: Feb 1, 2008
Accepted: Sep 12, 2010
Published online: Sep 22, 2010
Published in print: Oct 1, 2011
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.