Finite-Element Model for Pretensioned Prestressed Concrete Girders
Publication: Journal of Structural Engineering
Volume 136, Issue 4
Abstract
This paper presents a nonlinear model for pretensioned prestressed concrete girders. The model consists of three main components: a beam-column element that describes the behavior of concrete, a truss element that describes the behavior of prestressing tendons, and a bond element that describes the transfer of stresses between the prestressing tendons and the concrete. The model is based on a two-field mixed formulation, where forces and deformations are both approximated within the element. The nonlinear response of the concrete and tendon components is based on the section discretization into fibers with uniaxial hysteretic material models. The stress transfer mechanism is modeled with a distributed interface element with special bond stress-slip relation. A method for accurately simulating the prestressing operation is presented. Accordingly, a complete nonlinear analysis is performed at the different stages of prestressing. Correlation studies of the proposed model with experimental results of pretensioned specimens are conducted. These studies confirmed the accuracy and efficiency of the model.
Get full access to this article
View all available purchase options and get full access to this article.
References
Aalami, B. O. (1990). “Load balancing—A comprehensive solution to post-tensioning.” ACI Struct. J., 87(6), 662–670.
Aalami, B. O. (2000). “Structural modeling of posttensioned members.” J. Struct. Eng., 126(2), 157–162.
ADAPT-ABI user’s manual. (1999). ADAPT Corp., Redwood City, Calif.
Ayoub, A. S. (2006). “Nonlinear analysis of reinforced concrete beam-columns with bond-slip.” J. Eng. Mech., 132(11), 1177–1186.
Ayoub, A. S., and Filippou, F. C. (1999). “Mixed formulation of bond slip problems under cyclic loads.” J. Struct. Eng., 125(6), 661–671.
Ayoub, A. S., and Filippou, F. C. (2000). “Mixed formulation of nonlinear steel-concrete composite beam element.” J. Struct. Eng., 126(3), 371–381.
Cruz, P. J. S., Mari, A., and Roca, P. (1998). “Nonlinear time-dependent analysis of segmentally constructed structures.” J. Struct. Eng., 124(3), 278–287.
Eligehausen, R., Popov, E. P., and Bertero, V. V. (1983). “Local bond stress-slip relationships of deformed bars under generalized excitations.” Rep. No. UCB/EERC 83-23, Earthquake Engineering Research Center, Univ. of California, Berkeley, Calif.
Filippou, F. C., Popov, E. P., and Bertero, V. V. (1983). “Effects of bond deterioration on hysteretic behavior of reinforced concrete joints.” Rep. No. UCB/EERC-83/19, Earthquake Engineering Research Center, Univ. of California, Berkeley, Calif.
Kang, Y. K. (1977). “Nonlinear geometric, material and time dependent analysis of reinforced and prestressed concrete frames.” Rep. No. 77-1, SESM, Univ. of California, Berkeley, Calif.
Kent, D. C., and Park, R. (1971). “Flexural members with confined concrete.” J. Struct. Eng., 97(ST7), 1969–1990.
Kodur, V. K. R., and Campbell, T. I. (1990). “Deformation controlled nonlinear analysis of prestressed concrete continuous beams.” PCI J., 35(5), 42–55.
Mari, A. R. (1984). “Nonlinear geometric, material and time dependent analysis of three-dimensional reinforced and prestressed concrete frames.” Rep. No. 84-12, SESM, Univ. of California, Berkeley, Calif.
Menegotto, M., and Pinto, P. E. (1973). “Method of analysis for cyclically loaded reinforced concrete plane frames including changes in geometry and nonelastic behavior of elements under combined normal force and bending.” Proc., IABSE Symposium on Resistance and Ultimate Deformability of Structures Acted on by Well-Defined Repeated Loads, Lisbon, Portugal, 15–22.
Mitchell, D., Cook, W. D., Khan, A. A., and Tham, T. (1993). “Influence of high strength concrete on transfer and development length of pretensioning strand.” PCI J., 14(4), 62–74.
Picard, A., Massicotte, B., and Bastien, J. (1995). “Relative efficiency of external prestressing.” J. Struct. Eng., 121(12), 1832–1841.
Roca, P., and Mari, A. R. (1993). “Nonlinear geometric, material analysis of prestressed concrete general shell structures.” Comput. Struct., 46(5), 917–929.
Spacone, E., Filippou, F. C., and Taucer, F. F. (1996). “Fiber beam-column model for nonlinear analysis of RC frames. I: Formulation.” Earthquake Eng. Struct. Dyn., 25(7), 711–725.
Tabatabai, H., and Dickson, T. J. (1993). “The history of the prestressing strand development length equation.” PCI J., 38(6), 64–75.
Yassin, M. H. M. (1994). “Nonlinear analysis of prestressed concrete structures under monotonic and cyclic loads.” Ph.D. dissertation, Dept. of Civil and Environmental Engineering, Univ. of California, Berkeley, Calif.
Zienkiewicz, O. C., and Taylor, R. L. (1989). The finite element method: Volume 1. Basic formulation and linear problems, 4th Ed., McGraw-Hill, New York.
Information & Authors
Information
Published In
Copyright
© 2010 ASCE.
History
Received: Mar 2, 2009
Accepted: Oct 6, 2009
Published online: Oct 8, 2009
Published in print: Apr 2010
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.