Model Test Studies on Soil Restraint to Pipeline Buried in Bohai Soft Clay
Publication: Journal of Pipeline Systems Engineering and Practice
Volume 4, Issue 1
Abstract
Under high thermal stress, buckling of submarine pipelines may occur to release the stresses accumulated in the walls of the pipelines. The likelihood that buckling occurs is largely determined by the capability of the soil to resist pipeline movements. Therefore, it is very important to determine the soil resistance in upheaval buckling when designing submarine pipelines. A series of large-scale model tests were carried out with soft clay chosen as the supporting medium in view of Bohai Sea geotechnical conditions. Pipe segments with diameters of 30, 50, and 80 mm were used. The pipes were buried in different depth-to-diameter ratios between 1 and 9. The uplift, lateral, and axial resistances were recorded during the tests. The test results have shown that the soil resistance depends on the pipe’s diameter and cover depth. According to the uplift test results, the load-displacement relationships with smaller depth of cover differ greatly from those with larger depth of cover. The results of the lateral sliding and axial pull-out tests have shown that the soil resistance initially increases before a peak value is reached. However, once the peak value is reached, the soil resistance will remain at approximately the same level. For the same cover depth, the lateral soil resistance is more than twice as much as that of the uplift. The observed data were compared with existing formulae, among which the best fit is selected. Meanwhile, the coefficients for the chosen formula were determined. These formulae and coefficients can be used in calculating the soil resistance in the Bohai Gulf.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The work described in this paper was funded by Innovative Research Groups of the National Natural Science Foundation of China (51021004), the China National Natural Science Foundation (40776055), Program for New Century Excellent Talents in University (HCET-11-0370), and State Key Laboratory of Ocean Engineering Foundation (1002).
References
Anand, S., and Agarwal, S. L. (1981). “Field and laboratory studies for evaluating submarine pipeline frictional resistance.” J. Energy Res. Technol., 103(3), 250–254.
ASCE. (2001). “Guidelines for the design of buried steel pipe.” American lifelines alliance, ASCE, New York.
Boer, S., Hulsbergen, C. H., Richards, D. M., Klok, A., and Biaggi, J. P. (1986). “Buckling considerations in the design of the gravel cover for a high temperature oil line.” Proc., 18th OTC, Offshore Technology Conference, Richardson, Texas, 5294, 1–8.
Bransby, M. F., Newson, T. A., and Brunning, P. (2002). “The upheaval capacity of pipelines in jetted clay backfill.” Int. J. Offshore Polar Eng., 12(4), 280–287.
Cheuk, C. Y., Take, W. A., Bolton, M. D., and Oliveira, J. R. M. S. (2007). “Soil restraint on buckling oil and gas pipelines buried in lumpy clay fill.” Eng. Struct., 29(6), 973–982.
Davie, J. R., and Sutherland, H. B. (1977). “Uplift resistance of cohesive soils.” J. Geotech. Eng. Div., 103(9), 935–952.
Dickin, E. A. (1994). “Uplift resistance of buried pipelines in sand.” Soils Found., 34(2), 41–48.
Friedmann, Y. (1986). “Some aspects of the design of hot buried pipelines.” Offshore Oil and Gas Line Technology Conference, Paris, France, 1–34.
Guijt, J. (1990). “Upheaval buckling of offshore pipeline: Overview and introduction.” Proc., 22nd Annual OTC, Vol. 4, Offshore Technology Conference, Richardson, Texas, 573–578.
Liu, R., Yan, S. W., and Sun, G. M. (2005). “Improvement of the method for marine pipeline upheaval analysis under thermal stress.” J. Tianjin Univ., 38(2), 124–128 (in Chinese).
Moradi, M., and Craig, W. H. (1998). “Observation of upheaval buckling of buried pipelines.” Centrifuge 98, T., Kimura, O., Kusakabe, and J., Takemura, eds., 693–698.
Nielsen, N. J. R., Lyngberg, B., and Pedersen, P. T. (1990). “Upheaval buckling failures of insulated burial pipelines—A case story.” Proc., 22nd Annual OTC, Vol. 4, Offshore Technology Conference, Richardson, Texas, 581–592.
Palmer, A. C., et al. (2003). “Uplift resistance of buried submarine pipelines: Comparison between centrifuge modeling and full-scale tests.” Geotechnique, 53(10), 877–883.
Palmer, A. C., Ellinas, C. P., Richards, D. M., and Guijt, J. (1990). “Design of submarine pipelines against upheaval buckling.” Proc., 22nd OTC, Vol. 4, Offshore Technology Conference, Richardson, Texas, 540–550.
Peng, L. C. (1978). “Stress analysis methods for underground pipe lines.” Part 2, Pipeline industry, 65–75.
Phillips, R., Nobahar, A., and Zhou, J. (2004). “Trench effects on pipe-soil interaction.” Proc., Int. Pipeline Conf. (IPC), ASME, Calgary, Alberta, Canada, 1–7.
Rowe, R. K., and Davis, E. H. (1982). “The behaviour of anchor plates in clay.” Geotechnique, 32(1), 9–23.
Schaminee, P. E. L., Zorn, N. F., and Schotman, G. J. M. (1990). “Soil response for pipeline upheaval buckling analyses: Full-scale laboratory tests and modeling.” OTC 6486, 22nd Annual OTC, Offshore Technology Conference, Richardson, Texas, 563–572.
Taylor, N., Richardson, D., and Gan, A. B. (1985). “On submarine pipeline frictional characteristics in the presence of buckling.” Proc., 4th Int. Symp. on Offshore Mechanics and Arctic Engineering, ASME, Dallas, 508–515.
Taylor, N., Tran, V. C., and Richardson, D. (1989). “Interface modelling for upheaval subsea pipeline buckling.” Proc., 4th Int. Conf. on Computational Methods and Experimental Measurements, WIT Press, Southampton, UK, 269–282.
Tran, V. (1994). “Imperfect upheaval buckling of subsea pipelines.” Ph.D. thesis, Sheffield Hallam Univ., England.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Aug 30, 2011
Accepted: Jul 13, 2012
Published online: Jul 16, 2012
Published in print: Feb 1, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.