Mechanistic Analysis and Economic Benefits of Fiber-Reinforced Asphalt Mixtures
Publication: Journal of Materials in Civil Engineering
Volume 31, Issue 8
Abstract
Fatigue cracking and permanent deformation (rutting) are major distresses that occur in flexible pavements. One of the most significant solutions to prolong the fatigue life as well as rutting resistance for an asphaltic mixture is to utilize flexible materials such as fibers. The impact of fiber addition to hot-mixed asphalt (HMA) was investigated utilizing a developed testing program in which the mechanistic and mechanical performance of fiber-reinforced mixtures as well as the economic attributes were evaluated. All beam fatigue tests were strain-controlled tests performed according to current guideline procedures. The testing results indicated that the fiber-reinforced mixtures had a better performance compared with conventional mixtures in terms of rutting and fatigue resistance. Additionally, a mechanistic analysis coupled with a cost-effectiveness analysis study based on the fatigue and rutting resistance performance on the two mixtures was performed. Overall, analysis showed that fiber-reinforced asphalt mixtures exhibited significantly lower cost of pavement per 1,000 cycles of fatigue and rutting life 1.6 km (1 mi) compared with conventional HMA mixture.
Get full access to this article
View all available purchase options and get full access to this article.
References
AASHTO. 2003. Determining the fatigue life of compacted hot-mix asphalt (HMA) subjected to repeated flexural bending. AASHTO T321. Washington, DC: AASHTO.
Bdour, A. N., Y. Khalayleh, and A. A. Al-Omari. 2015. “Assessing mechanical properties of hot mix asphalt with wire wool fibers.” Adv. Civ. Eng. 2015: 6. https://doi.org/10.1155/2015/795903.
Kaloush, K. E., and K. P. Biligiri. 2008. Evaluation of FORTA fiber-reinforced asphalt mixtures using advanced material characterization tests: Evergreen Drive. Tempe, AZ: Ira A. Fulton Schools of Engineering, Dept. of Civil and Environmental Engineering.
Kaloush, K. E., K. P. Biligiri, W. A. Zeiada, M. C. Rodezno, and J. X. Reed. 2010. “Evaluation of fiber-reinforced asphalt mixtures using advanced material characterization tests.” J. Test. Eval. 38 (4): 400–411. https://doi.org/10.1520/JTE102442.
Lamptey, G., S. Labi, M. Ahmad, and K. Sinha. 2005. Life cycle cost analysis for INDOT pavement design procedures. West Lafayette, IN: Joint Transportation Research Program, Indiana Dept. of Transportation and Purdue Univ.
Mahrez, A., and M. R. Karim. 2010. “Fatigue characteristics of stone mastic asphalt mix reinforced with fiber glass.” Int. J. Phys. Sci. 5 (12): 1840–1847.
Panda, M., A. Suchismita, and J. Giri. 2013. “Utilization of ripe coconut fiber in stone matrix asphalt mixes.” Int. J. Transp. Sci. Technol. 2 (4): 289–302. https://doi.org/10.1260/2046-0430.2.4.289.
Pavement Interactive. 2017. “A site by Pavia system.” Accessed July 5, 2017. http://www.pavementinteractive.org.
Peshkin, D., K. Smith, A. Wolters, J. Krstulovich, J. Moulthrop, and C. Alvarado. 2011. Preservation approaches for high-traffic-volume roadways SHRP 2 renewal research. Washington, DC: Transportation Research Board.
Putman, B. J. 2011. “Effects of fiber finish on the performance of asphalt binders and mastics.” Adv. Civ. Eng. 2011: 11. https://doi.org/10.1155/2011/172634.
Qadir, A., and S. M. Quraishi. 2012. Use of polypropylene fibres for control of asphalt pavement’s rutting in Pakistan. Karachi, Pakistan: Dept. of Urban and Infrastructure Engineering, NED Univ. of Engineering and Technology.
Siddharthan, R. V., J. Yao, and P. E. Sebaaly. 1998. “Pavement strain from moving dynamic 3-D load distribution.” J. Transp. Eng. 124 (6): 557–566. https://doi.org/10.1061/(ASCE)0733-947X(1998)124:6(557).
Souliman, M. I., M. Mamlouk, and A. Eifert. 2016. “Cost-effectiveness of rubber and polymer modified asphalt mixtures as related to sustainable fatigue performance.” Procedia Eng. 145: 404–411.
Tapkin, S. 2008. “The effect of polypropylene fibers on asphalt performance.” Build. Environ. 43 (6): 1065–1071.
Information & Authors
Information
Published In
Copyright
©2019 American Society of Civil Engineers.
History
Received: Jun 14, 2018
Accepted: Jan 14, 2019
Published online: May 22, 2019
Published in print: Aug 1, 2019
Discussion open until: Oct 22, 2019
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.