Synergy Effect of Attapulgite, Rubber, and Diatomite on Organic Montmorillonite-Modified Asphalt
Publication: Journal of Materials in Civil Engineering
Volume 31, Issue 2
Abstract
Organic montmorillonite (OMMT) was obtained by reacting montmorillonite (MMT) with the surfactant cetyltrimethyl ammonium bromide (CTAB). The crystalline phases of MMT and OMMT were characterized by microscopic performance analysis using an X-ray diffractometer (XRD) and scanning electron microscope (SEM). The effects of rubber, attapulgite, columnar diatomite, and disk diatomite on the technological and rheological properties of OMMT-modified asphalt were studied using a dynamic shear rheometer, and the low-temperature properties were determined from their creep characteristics by a bending beam rheometer. The short-term, long-term, and ultraviolet (UV) aging of modified asphalt were tested, respectively. After adding five types of modifiers to the asphalt, the high-temperature rheological and aging resistance of matrix asphalt and modified asphalt can be improved. In particular, it is shown that modification with OMMT with attapulgite as comodifier had a positive influence on asphalt thermo-oxidative aging and UV aging.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was supported by the National Natural Science Foundation of China (51704040), the Scientific Research Project of Hunan Provincial Department of Education (16B007), and Open Fund of Key Laboratory of Special Environment Road Engineering of Hunan Province (Changsha University of Science and Technology, KFJ160501, 170502).
References
AASHTO. 1999. Standard specification for determining the flexural creep stiffness of asphalt binder using the bending beam rheometer (BBR). AASHTO TP1. Washington, DC: AASHTO.
AASHTO. 2009. Standard practice for accelerated aging of asphalt binder using a pressurized aging vessel (PAV). AASHTO PP1. Washington, DC: AASHTO.
AASHTO. 2012. Standard method of test for determining the rheological properties of asphalt binder using a dynamic shear rheometer (DSR). AASHTO TP5. Washington, DC: AASHTO.
Abdullah, M. E., K. A. Zamhari, R. Buhari, M. N. Nayan, and M. R. Hainin. 2013. “Short term and long term aging effects of asphalt binder modified with montmorillonite.” Key Eng. Mater. 594–595: 996–1002. https://doi.org/10.4028/www.scientific.net/KEM.594-595.996.
ASTM. 2009. Standard test method for effects of heat and air on asphaltic materials (thin-film oven test). ASTM D1754. West Conshohocken, PA: ASTM.
Borghi, A., A. Jiménez del Barco Carrión, D. Lo Presti, and F. Giustozzi. 2017. “Effects of laboratory aging on properties of biorejuvenated asphalt binders.” J. Mater. Civ. Eng. 29 (10): 04017149. https://doi.org/10.1061/(ASCE)MT.1943-5533.0001995.
Ding, Y., B. Huang, S. Xiang, Y. Zhang, and M. E. Woods. 2016. “Use of molecular dynamics to investigate diffusion between virgin and aged asphalt binders.” Fuel 174: 267–273. https://doi.org/10.1016/j.fuel.2016.02.022.
Falchetto, A. C., and K. H. Moon. 2017. “Simple approach to the investigation of asphalt mixture strength on small beam specimens at low temperature.” J. Mater. Civ. Eng. 29 (3): 04016238. https://doi.org/10.1061/(ASCE)MT.1943-5533.0001770.
Fang, C., X. Liu, R. Yu, P. Liu, and W. Lei. 2014a. “Preparation and properties of asphalt modified with a composite composed of waste package poly(vinyl chloride) and organic montmorillonite.” J. Mater. Sci. Technol. 30 (12): 1304–1310. https://doi.org/10.1016/j.jmst.2014.11.001.
Fang, C., C. Wu, J. Hu, R. Yu, Z. Zhang, L. Nie, S. Zhou, and X. Mi. 2014b. “Pavement properties of asphalt modified with packaging-waste polyethylene.” J. Vinyl Add. Tech. 20 (1): 31–35. https://doi.org/10.1002/vnl.21328.
Fang, C., R. Yu, Y. Li, M. Zhang, J. Hu, and M. Zhang. 2013. “Preparation and characterization of an asphalt-modifying agent with waste packaging polyethylene and organic montmorillonite.” Polym. Test. 32 (5): 953–960. https://doi.org/10.1016/j.polymertesting.2013.04.006.
Fang, C., Y. Zhang, and R. Yu. 2015. “Effect of organic montmorillonite on the hot storage stability of asphalt modified by waste packaging polyethylene.” J. Vinyl Add. Tech. 21 (2): 89–93. https://doi.org/10.1002/vnl.21376.
Goli, A., H. Ziari, and A. Amini. 2017. “Influence of carbon nanotubes on performance properties and storage stability of SBS modified asphalt binders.” J. Mater. Civ. Eng. 29 (8): 04017070. https://doi.org/10.1061/(ASCE)MT.1943-5533.0001910.
Jasso, M., R. Hampl, O. Vacin, D. Bakos, J. Stastna, and L. Zanzotto. 2015. “Rheology of conventional asphalt modified with SBS, Elvaloy and polyphosphoric acid.” Fuel Process. Technol. 140: 172–179. https://doi.org/10.1016/j.fuproc.2015.09.002.
Jin, J., F. Lin, R. Liu, T. Xiao, J. Zheng, G. Qian, H. Liu, and P. Wen. 2017. “Preparation and thermal properties of mineral-supported polyethylene glycol as form-stable composite phase change materials (CPCMs) used in asphalt pavements.” Sci. Rep. 7 (1): 16998. https://doi.org/10.1038/s41598-017-17224-1.
Jin, J., Y. Tan, R. Liu, F. Lin, Y. Wu, G. Qian, H. Wei, and J. Zheng. 2018. “Structure characteristics of organic bentonite and the effects on rheological and aging properties of asphalt.” Powder Technol. 329: 107–114. https://doi.org/10.1016/j.powtec.2018.01.047.
Liao, L., G. Lv, D. Cai, and L. Wu. 2016. “The sequential intercalation of three types of surfactants into sodium montmorillonite.” Appl. Clay Sci. 119: 82–86. https://doi.org/10.1016/j.clay.2015.08.003.
Liu, G., S. Wu, M. van de Ven, J. Yu, and A. Molenaar. 2013. “Structure and artificial ageing behavior of organo montmorillonite bitumen nanocomposites.” Appl. Clay Sci. 72: 49–54. https://doi.org/10.1016/j.clay.2013.01.013.
Lv, S., C. Liu, J. Zheng, Z. You, and L. You. 2018. “Viscoelastic fatigue damage properties of asphalt mixture with different aging degrees.” KSCE J. Civ. Eng. 22 (6): 2073–2081. https://doi.org/10.1007/s12205-018-1688-9.
Maryan, A. S., M. Montazer, and R. Damerchely. 2015. “Discoloration of denim garment with color free effluent using montmorillonite based nano clay and enzymes: Nano bio-treatment on denim garment.” J. Clean Prod. 91: 208–215. https://doi.org/10.1016/j.jclepro.2014.12.014.
Menapace, I., M. Nogueira d’Eurydice, P. Galvosas, M. W. Hunter, O. Sirin, and E. Masad. 2017. “Aging evaluation of asphalt samples with low field nuclear magnetic resonance.” Mater. Charact. 128: 165–175. https://doi.org/10.1016/j.matchar.2017.01.029.
Meng, X., J. Yi, D. Feng, Y. Huang, and D. Wang. 2016. “Analysis of adhesive characteristics of asphalt based on atomic force microscopy and molecular dynamics simulation.” ACS Appl. Mater. Interfaces 8 (19): 12393–12403. https://doi.org/10.1021/acsami.6b01598.
Roshani, H., S. Dessouky, A. Montoya, and A. T. Papagiannakis. 2016. “Energy harvesting from asphalt pavement roadways vehicle-induced stresses: A feasibility study.” Appl. Energy 182: 210–218. https://doi.org/10.1016/j.apenergy.2016.08.116.
Xu, G., and H. Wang. 2017. “Molecular dynamics study of oxidative aging effect on asphalt binder properties.” Fuel 188: 1–10. https://doi.org/10.1016/j.fuel.2016.10.021.
Yao, H., Q. Dai, and Z. You. 2016. “Molecular dynamics simulation of physicochemical properties of the asphalt model.” Fuel 164: 83–93. https://doi.org/10.1016/j.fuel.2015.09.045.
Yu, X., N. A. Burnham, and M. Tao. 2015. “Surface microstructure of bitumen characterized by atomic force microscopy.” Adv. Colloid Interface Sci. 218: 17–33. https://doi.org/10.1016/j.cis.2015.01.003.
Zhang, H., J. Yu, H. Wang, and L. Xue. 2011. “Investigation of microstructures and ultraviolet aging properties of organo-montmorillonite/SBS modified bitumen.” Mater. Chem. Phys. 129 (3): 769–776. https://doi.org/10.1016/j.matchemphys.2011.04.078.
Zhang, H., J. Yu, and S. Wu. 2012. “Effect of montmorillonite organic modification on ultraviolet aging properties of SBS modified bitumen.” Constr. Build. Mater. 27 (1): 553–559. https://doi.org/10.1016/j.conbuildmat.2011.07.008.
Information & Authors
Information
Published In
Copyright
©2018 American Society of Civil Engineers.
History
Received: Oct 16, 2017
Accepted: Aug 9, 2018
Published online: Nov 30, 2018
Published in print: Feb 1, 2019
Discussion open until: Apr 30, 2019
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.