Abstract
The strength reduction associated with the replacement of the virgin coarse aggregate in concrete with recycled asphalt pavement (RAP) limits the use of the RAP concrete to nonstructural applications. Recent research has suggested that RAP concrete might retain sufficient strength for structural applications if high-strength concrete mixture designs were used. Before these high-strength RAP concrete mixtures can be used in transportation infrastructure applications, their durability must be proven. This study evaluated the chloride permeability, the freeze-thaw durability, and the coefficient of thermal expansion of high-strength RAP concrete mixtures. The results indicated that the chloride permeability of the high-strength concrete, as measured by the surface resistivity, was unaffected by the replacement of up to 50% of virgin coarse aggregate with RAP. Furthermore, the freeze-thaw durability of high-strength RAP concrete was improved over high-strength concrete with 100% virgin coarse aggregate. The optimal RAP fraction in terms of the freeze/thaw durability was 35% by mass. Finally, the coefficient of thermal expansion was minimally affected by the replacement of up to 50% of virgin coarse aggregate with RAP. On the basis of these results, the durability of high-strength concrete with RAP coarse aggregate was deemed sufficient for transportation infrastructure applications.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors would like to acknowledge the Idaho Transportation Department for providing the research funding to support this study.
References
AASHTO. (2014). “Standard test method for surface resistivity indication of concrete’s ability to resist chloride ion penetration.” AASHTO TP95-14, Washington, DC.
AASHTO. (2015). “Coefficient of thermal expansion of hydraulic cement concrete.” AASHTO T336-15, Washington, DC.
Ahlborn, T. M., Peuse, E. J., and Misson, D. L. (2008). “Ultra-high-performance-concrete for Michigan bridges material performance–Phase I.”, Michigan Dept. of Transportation, Lansing, MI.
ASTM. (2014). “Standard test method for fundamental transverse, longitudinal, and torsional resonant frequencies of concrete specimens.” ASTM C215-14, West Conshohocken, PA.
ASTM. (2015). “Standard test method for resistance of concrete to rapid freezing and thawing.” ASTM C666-15, West Conshohocken, PA.
ASTM. (2016). “Standard practice for making and curing concrete test specimens in the laboratory.” ASTM C192-16a, West Conshohocken, PA.
ASTM. (2017). “Standard test method for compressive strength of cylindrical concrete specimens.” ASTM C39-17, West Conshohocken, PA.
Attia, M., and Abdelrahman, M. (2010). “Sensitivity of untreated reclaimed asphalt pavement to moisture, density, and freeze thaw.” J. Mater. Civ. Eng., 1260–1269.
Berry, M., Stephens, J., Bermel, B., Hagel, A., and Schroeder, D. (2013). “Feasibility of reclaimed asphalt pavement as aggregate in portland cement concrete.”, FHWA, McLean, VA.
Brans, A. S., Roseler, J. R., Al-Qadi, I. L., and Shagguan, P. (2012). “Fractionated reclaimed asphalt pavement (FRAP) as a coarse aggregate replacement in a ternary blended concrete pavement.”, Illinois Center for Transportation, Urbana, IL.
Capson, T., and Sorensen, A. D. (2013). “Recycled asphalt pavement as a coarse aggregate replacement in high strength concrete mixes.” Proc. Architectural Engineering Institute 2013, ASCE, Reston, VA, 652–661.
Copeland, A. (2011). “Reclaimed asphalt pavement in asphalt mixtures: State of the practice.”, FHWA, McLean, VA.
Delwar, M., Fahmy, M., and Taha, R. (1997). “Use of reclaimed asphalt pavement as an aggregate in portland cement concrete.” ACI Mater. J., 94(3), 251–256.
Fellows, A. J. (2014). “Mechanical properties of high strength portland cement concrete with recycled asphalt pavement as a percent replacement of coarse aggregate.” M.S. thesis, Idaho State Univ., Pocatello, ID.
Hansen, K. R., and Copeland, A. (2013). “Annual asphalt pavement industry survey on recycled materials and warm-mix asphalt usage: 2009–2012.” FHWA, McLean, VA.
Hossiney, N., Tia, M., and Bergin, M. J. (2010). “Concrete containing RAP for use in concrete pavement.” Int. J. Pavement Res. Technol., 3(5), 251–258.
Huang, B., Shi, X., and Burdette, E. G. (2006). “Mechanical properties of concrete containing recycled asphalt pavements.” Mag. Concr. Res., 58(5), 313–320.
Huang, B., Shi, X., and Li, G. (2005). “Laboratory investigation of portland cement concrete containing recycled asphalt pavements.” Cem. Concr. Res., 35(10), 2008–2013.
Johnson, W. H., and Parsons, W. H. (1944). Thermal expansion of concrete aggregate materials, National Bureau of Standards, Washington, DC.
Kada, H., Lachemi, M., Petrov, N., Bonneau, O., and Aïtcin, P. C. (2002). “Determination of the coefficient of thermal expansion of high performance concrete from initial setting.” Mater. Struct., 35(1), 35–41.
Koch, G. H., Bronger, M. P., Thompson, N. H., Birmani, Y. P., and Payer, J. H. (2002). “Corrosion cost and preventive strategies in the United States.”, FHWA, McLean, VA.
Legret, M., Odie, L., Demare, D., and Jullien, A. (2005). “Leaching of heavy metals and polycyclic aromatic hydrocarbons from reclaimed asphalt pavement.” Water Res., 39(15), 3675–3685.
Mathias, V., Sedran, T., and De Larrard, F. (2009). “Modeling of mechanical properties of cement concrete incorporating reclaimed asphalt pavement.” Road Mater. Pavement Des., 10(1), 63–82.
Mellela, J., Abbas, A., Harman, T., Rao, C., Liu, R., and Darter, M. (2005). “Measurement and significance of the coefficient of thermal expansion of concrete in rigid pavement design.” Trans. Res. Rec., 1919, 38–46.
Pigeon, M., and Lachance, M. (1981). “Critical air void spacing factors for concretes submitted to slow freeze-thaw cycles.” ACI J. Proc., 78(4), 282–291.
Powers, T. C. (1954). “Void space as a basis for producing air-entrained concrete.” ACI J. Proc., 50(5), 741–760.
Robinson, G. R., Jr., Menzie, W. D., and Hyun, H. (2004). “Recycling of construction debris as aggregate in the mid-Atlantic region, USA.” Resour. Conserv. Recycl., 42(3), 275–294.
Sellevold, E. J., and Bjøntegaard, Ø. (2006). “Coefficient of thermal expansion of cement paste and concrete: Mechanisms of moisture interaction.” Mater. Struct., 39(9), 809–815.
Vardanega, P. J. (2014). “State of the art: Permeability of asphalt concrete.” J. Mater. Civ. Eng., 54–64.
Zeng, M., and Shields, D. H. (1999). “Nonlinear thermal expansion and contraction of asphalt concrete.” Can. J. Civ. Eng., 26(1), 26–34.
Information & Authors
Information
Published In
Copyright
©2018 American Society of Civil Engineers.
History
Received: Apr 28, 2017
Accepted: Oct 31, 2017
Published online: Feb 16, 2018
Published in print: May 1, 2018
Discussion open until: Jul 16, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.