Time-and-Depth-Dependent Model of Chloride Diffusion Coefficient for Concrete Members Considering the Effect of Coarse Aggregate
Publication: Journal of Materials in Civil Engineering
Volume 30, Issue 3
Abstract
Chloride-induced reinforcement corrosion is one of the major causes of durability failure of concrete structures in a salty environment. Because concrete is a kind of heterogeneous material, the effect of coarse aggregate on chloride diffusion cannot be ignored. This paper presents the results of an indoor experimental investigation on chloride diffusion in concrete specimens with continuously graded coarse aggregate. Concrete specimens with different coarse aggregate volume fraction (CAVF) and various maximum sizes of aggregate (MSA) were exposed in a self-designed tidal cycle device, where the chloride environment of a tidal zone was simulated, to determine the chloride concentration profile along depth for 30, 60, 90, 130, and 170 days. A time-and-depth-dependent chloride diffusion coefficient was determined using the Boltzmann–Matano method in terms of the chloride measurements. CAVF and MSA impact factors were obtained on the basis of statistical analysis. The results show that the chloride diffusion coefficient increases initially and becomes stable afterward along the penetrating direction, but decreases as CAVF or MSA increases. Based on the aforementioned results, the authors propose a time-and-depth-dependent model of a chloride diffusion coefficient considering the effect of coarse aggregate, which is called the T-D model.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors would like to appreciate the insightful and constructive comments of the editor and two anonymous reviewers. We are grateful for the finical support from the National Key Research and Development Program of China under Grant No. 2016YFC0802204, the National Science Foundation of China under Grant No. 51679166, and the Construction Science and Technology Project of the Ministry of Transport of the People’s Republic of China under Grant No. 2014328224040.
References
CABR (China Academy of Building Research). (2006). “Standards for sand and stone quality and test methods for normal concrete.” JGJ 52-2006, Beijing.
Collepardi, M., Marcialis, A., and Turrizzani, R. (1970). “The kinetics of penetration of chloride ions into the concrete.” Il Cemento., 4(26), 157–164.
Collepardi, M., Marcialis, A., and Turrizzani, R. (1972). “Penetration of chloride ions into cement pastes and concretes.” J. Am. Ceram. Soc., 55(10), 534–535.
Costa, A., and Appleton, J. (1999). “Chloride penetration into concrete in marine environment. II: Prediction of long term chloride penetration.” Mater. Struct., 32(5), 354–359.
Jerath, S., and Hanson, N. (2007). “Effect of fly ash content and aggregate gradation on the durability of concrete pavements.” J. Mater. Civ. Eng., 367–375.
Li, X. X., Xu, Y., and Chen, S. (2016). “Computational homogenization of effective permeability in three-phase mesoscale concrete.” Constr. Build. Mater., 121, 100–111.
Mangat, P. S., and Molloy, B. T. (1994). “Prediction of long term chloride concentration in concrete.” Mater. Struct., 27(6), 338–346.
MATLAB [Computer software]. MathWorks, Inc., Natick, MA.
Michael, D. A., Thomas, A., and Phil, B. (1999). “Modelling chloride diffusion in concrete effect of fly ash and slag.” Cem. Concr. Res., 29(4), 487–495.
Ministry of Communications of the People’s Republic of China. (1998). “Testing code of concrete for port and watering engineering.” JTJ270-98, Beijing.
Mumtaz, K. K., and Michel, G. (2002). “Chloride-induced corrosion of reinforced concrete bridge decks.” Cem. Concr. Res., 32(1), 139–143.
Razmjoo, A., and Poursaee, A. (2016). “Effects of coarse aggregates on the corrosion of steel bars in cement paste.” J. Mater. Civ. Eng., 04016061.
Shah, S. P. (2000). “High performance concrete: Past, present and future.” Proc., Int. Symp. on High Performance Concrete: Workability, Strength and Durability, C. K. Leung, Y. Z. Li, and J. T. Ding, eds., Vol. 1, Hong Kong Univ. of Science and Technology, Hong Kong, 3–29.
Song, H. W., Lee, C. H., and Ann, K. Y. (2008). “Factors inurning chloride transport in concrete structures exposed to marine environments.” Cem. Concr. Compos., 30(2), 113–121.
Stephen, L. A., Dwayne, A. J., Matthew, A. M., and Hamid, F. (1998). “Predicting the service life of concrete marine structures: An environmental methodology.” ACI Struct. J., 95(2), 205–214.
Sun, G. W., Sun, W., Zhang, Y. S., and Liu, Z. Y. (2012). “Prediction of the effective diffusion coefficient of chloride ions in cement-based composite materials.” J. Mater. Civ. Eng., 1245–1253.
Sun, G. W., Sun, W., Zhang, Y. S., Liu, Z. Y., and Wang, C. H. (2011). “Influence of aggregates on chloride ion diffusion coefficient in cement-based composite materials.” J. Chin. Ceram. Soc., 39(4), 662–669.
Sun, Y. M., Chang, T. P., and Liang, M. T. (2008). “Kirchhoff transformation analysis for determining time/depth dependent chloride diffusion coefficient in concrete.” J. Mater. Sci., 43(4), 1429.
Tang, L., and Joost, G. (2007). “On the mathematics of time-dependent apparent chloride diffusion coefficient in concrete.” Cem. Concr. Res., 37(4), 589–595.
Thomas, M. D. A., and Bamforth, P. B. (1999). “Modelling chloride diffusion in concrete: Effect of fly ash and slag.” Cem. Concr. Res., 29(4), 487–495.
Tian, X. C. (2010). “A three-dimensional numerical modeling method for predicting the chloride diffusivity of concrete.” M.S. thesis, Zhejiang Univ. of Technology, Hangzhou, China.
Tumidajski, P. J., Chan, G. W., Feldman, R. F., and Strathdee, G. (1995). “A Boltzmann-Matano analysis of chloride diffusion.” Cem. Concr. Res., 25(7), 1556–1566.
Vji, K., Matsuoka, Y., Maruya, T., and Bamforth, P. (1990). “Formulation of an equation for surface chloride content of concrete due to permeation of chloride.” Corros. Reinforcement Concr., 258–267.
Wang, Y. Z., Li, Q. M., and Lin, C. A. P. (2016). “Chloride diffusion analysis is of concrete members considering depth-dependent diffusion coefficients and effect of reinforcement presence.” J. Mater. Civ. Eng., 04015183.
Wang, Y. Z., Lin, C. A. P., and Cui, Y. Q. (2014). “Experiments of chloride ingression in loaded concrete members under the marine environment.” J. Mater. Civ. Eng., 04014012.
Yang, C. C. (2005). “Effect of the percolated interfacial transition zone on the chloride migration coefficient of cement-based materials.” Mater. Chem. Phys., 91(2), 538–544.
Yang, C. C., and Su, J. K. (2002). “Approximate migration coefficient of interfacial transition zone and the effect of aggregate content on the migration coefficient of mortar.” Cem. Concr. Res., 32(10), 1559–1565.
Yao, C. J., Jin, W. L., Wang, H. L., Jin, L. B., and Yan, Y. D. (2008). “Change of chloride diffusion coefficient in marine concrete with depth.” Hydrogen Sci. Eng., 30(4), 14–18.
Zhang, J. Z., Wang, J. Z., Kong, D. Y., Zou, C. R., and Huang, H. Z. (2010). “Time variation model of chloride ions diffusion coefficient for existing concrete.” Hydrogen Sci. Eng., 32(4), 14–20.
Zhao, Y. X., Wang, C. K., Jin, W. L., and Xu, C. (2010). “Experimental analysis on time-dependent law of surface chloride ion concentration of concrete.” J. Civil Archit. Environ. Eng., 32(3), 8–13.
Zheng, J. J., Zhang, C. Y., Wu, Y. F., and Sun, L. Z. (2016). “Random-walk algorithm for chloride diffusivity of concrete with aggregate shape effect.” J. Mater. Civ. Eng., 04016153.
Zheng, J. J., Zhou, X. Z., Huang, X. F., and Fu, C. Q. (2014). “Experiment and modeling of the effect of aggregate shape on the chloride diffusivity of concrete.” J. Mater. Civ. Eng., 04014048.
Zhou, S. J. (2016). “Analytical model for square root increase of surface chloride concentration and decrease of chloride diffusivity.” J. Mater. Civ. Eng., 04015181.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Mar 28, 2017
Accepted: Aug 15, 2017
Published online: Dec 22, 2017
Published in print: Mar 1, 2018
Discussion open until: May 22, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.