Effect of Mixing Time and Temperature on Cracking Resistance of Bituminous Mixtures Containing Reclaimed Asphalt Pavement Material
Publication: Journal of Materials in Civil Engineering
Volume 29, Issue 8
Abstract
The use of reclaimed asphalt pavement (RAP) in bituminous mixtures is considerably increasing due to the environmental and economic benefits of recycled materials. However, stiffer mixes, usually resulting from RAP addition, have raised concern about long-term properties of the pavement; a mechanical characterization of these mixes is thus needed. In this study, the effect of mixing condition on bituminous mixtures containing RAP was evaluated. Volumetric and mechanical properties were analyzed. An experimental program, with the aim of measuring stiffness modulus, water sensitivity, and cracking resistance, was conducted. Cracking resistance was evaluated according to the Fénix test because it has proved to be a convenient and effective method for characterizing cracking behavior of bituminous mixtures at different temperatures. Mixtures containing 20 or 40% of RAP material were tested; virgin aggregates and RAP mixing temperatures as well as mixing time were varied and comparisons with a reference mix were conducted to characterize fracture energy and mechanical performance.
Get full access to this article
View all available purchase options and get full access to this article.
References
Al-Qadi, I., Carpenter, S., Roberts, G., Ozer, H., and Aurangzeb, Q. (2009). “Investigation of working binder in hot-mix asphalt containing recycled asphalt pavement.” 88th Annual Meeting of the Transportation Research Board, Transportation Research Board, Washington, DC.
Al-Qadi, I., Elseifi, M. Y., and Carpenter, S. (2007). “Reclaimed asphalt pavement: A literature review.”, Illinois Center for Transportation, Chicago.
ASTM. (2013). “Standard test method for determining fracture energy of asphalt-aggregate mixtures using the disk-shaped compact tension geometry.” ASTM D7313–13, West Conshohocken, PA.
Bowers, B., Huang, B., Shu, X., and Miller, B. (2014). “Investigation of reclaimed asphalt pavement blending efficiency through GPC and FTIR.” Constr. Build. Mater., 50, 517–523.
Bressi, S., Dumont, A. G., and Partl, M. N. (2016). “A new laboratory methodology for optimization of mixture design of asphalt concrete containing reclaimed asphalt pavement material.” Mater. Struct., 49(12). 4975–4990.
CEN (European Committee for Standardization). (2004). “Bituminous mixtures—Test methods for hot mix asphalt—Determination of the indirect tensile strength of bituminous specimens.” EN 12697-23, Brussels, Belgium.
CEN (European Committee for Standardization). (2009). “Bituminous mixtures—Test methods for hot mix asphalt—Determination of the water sensitivity of bituminous specimens.” EN 12697-12, Brussels, Belgium.
CEN (European Committee for Standardization). (2011). “Bituminous mixtures—Test methods for hot mix asphalt—Crack propagation by semi-circular bending test.” EN 12697-44, Brussels, Belgium.
CEN (European Committee for Standardization). (2012a). “Bituminous mixtures—Test methods for hot mix asphalt—Determination of bulk density of bituminous specimens.” EN 12697-6, Brussels, Belgium.
CEN (European Committee for Standardization). (2012b). “Bituminous mixtures—Test methods for hot mix asphalt—Stiffness.” EN 12697-26, Brussels, Belgium.
CEN (European Committee for Standardization). (2013). “Bituminous mixtures—Test methods for hot mix asphalt—Specimen preparation by impact compactor.” EN 12697-30, Brussels, Belgium.
CEN (European Committee for Standardization). (2015). “Bitumen and bituminous binders—Determination of needle penetration.” EN 1426, Brussels, Belgium.
CEN (European Committee for Standardization). (2015). “Bitumen and bituminous binders—Determination of the softening point—Ring and Ball method.” EN 1427, Brussels, Belgium.
Howard, I. L., Cooley, A. L., Jr., and Doyle, J. D. (2009). “Laboratory testing and economic analysis of high RAP warm mixed asphalt.”, Mississippi Dept. of Transportation, Jackson, MS.
Huang, B., Li, G., Vukosavlievic, D., and Shu, X. (2005). “Laboratory investigation of mixing HMA with RAP.” Transp. Res. Rec., 1929, 37–45.
Iwanski, M., and Chomicz-Kowalska, A. (2012). “Experimental study of water and frost resistance of foamed bitumen mixes in the cold recycling technology.” Eurasphalt and Eurobitume Congress, European Asphalt Pavement Association and Eurobitume, Brussels, Belgium.
Marsac, P., et al. (2014). “Potential and limits of FTIR methods for reclaimed asphalt characterization.” Mater. Struct., 47(8), 1273–1286.
McDaniel, R., Soleymani, H., Anderson, M., Turner, P., and Peterson, R. (2000). “Recommended use of reclaimed asphalt pavement in the superpave mix design method.” National Cooperative Highway Research Program, Washington, DC.
Nguyen, V. H. (2009). “Effects of laboratory mixing methods and RAP materials on performance of hot recycled asphalt mixtures.” Ph.D. dissertation, Univ. of Nottingham, Nottingham, U.K.
Ozer, H., Al-Qadi, I., Carpenter, S. H., Aurangzeb1, Q., Roberts, G. L., and Trepanier, J. (2009). “Evaluation of rap impact on hot-mix asphalt design and performance.” J. Assoc. Asphalt Paving Technol., 78, 317–348.
Pérez-Jiménez, F., Botella, R., Moon, K., and Marasteanu, M. (2013). “Effect of load application rate and temperature on the fracture energy of asphalt mixtures; Fénix and semi-circular bending tests.” Constr. Build. Mater., 26(1), 1067–1071.
Pérez-Jiménez, F., Valdés, G., Botella, R., Miró, R., and Martínez, A. (2011). “Approach to fatigue performance using Fénix test for asphalt mixtures.” Constr. Build. Mater., 26(1), 372–380.
Pérez-Jiménez, F., Valdés, G., Miró, R., Martínez, A., and Botella, R. (2010). “Fénix test: Development of a new test procedure for evaluating cracking resistance in bituminous mixtures.” Transp. Res. Rec., 2181, 36–43.
TXDOT (Texas Department of Transportation). (2015). “Test procedure for overlay test.”, Austin, TX.
Wagoner, M., Buttlar, W., and Paulino, G. (2005). “Disk-shaped compact tension test for asphalt concrete fracture.” Exp. Mech., 45(3), 270–277.
Walubita, L. F., Faruk, A. N., Das, G., Tanvir, H. A., Zhang, J., and Scullion, T. (2012). “The overlay tester: A sensitivity study to improve repeatability and minimize variability in the test results.”, Federal Highway Administration, Washington, DC.
Walubita, L. F., Faruk, A. N., Koohi, Y., Luo, R., Scullion, T., and Lytton, R. L. (2013). “The overlay tester (OT): Comparison with other crack test methods and recommendation for surrogate crack tests.”, Federal Highway Administration, Washington, DC.
Yang, S., Braham, A., Wang, L., and Wang, Q. (2016). “Influence of aging and moisture on laboratory performance of asphalt concrete.” Constr. Build. Mater., 115, 527–535.
Yu, B., Gu, X., Wu, M., and Ni, F. (2016). “Application of a high percentage of reclaimed asphalt pavement in an asphalt mixture: Blending process and performance investigation.” Road Mater. Pavement Des., 1–13.
Zaumanis, M., and Mallick, R. B. (2015). “Review of very high-content reclaimed asphalt use in plant produced pavements: State of the art.” Int. J. Pavement Eng., 16(1), 39–55.
Zhang, K., Wen, H., and Hobbs, A. (2015). “Laboratory tests and numerical simulations of mixing superheated virgin aggregate with reclaimed asphalt pavement materials.” Transp. Res. Rec., 2506, 62–71.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Jun 16, 2016
Accepted: Sep 26, 2016
Published ahead of print: Mar 30, 2017
Published online: Mar 31, 2017
Published in print: Aug 1, 2017
Discussion open until: Aug 31, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.